enic: add V2 VF probe with admin channel and PF registration

When a V2 SR-IOV VF probes, initialize the MBOX protocol, open the
admin channel, perform the capability check with the PF, and register
with the PF. This establishes the PF-VF communication path that the PF
uses to send link state notifications.

The admin channel and MBOX registration happen after enic_dev_init()
(which discovers admin channel resources) and before register_netdev()
so the VF is fully initialized before the interface is visible to
userspace.

A V2 VF whose firmware did not provision admin WQ/RQ/CQ resources
fails probe with -ENODEV from enic_admin_channel_open(); the admin
channel is a hard requirement for V2 VFs.

enic_mbox_init() installs the receive handler and resets the message
sequence number before enic_admin_channel_open() unmasks the admin
interrupt, so a completion can never arrive before the handler is in
place.

On remove, the VF unregisters from the PF and closes its admin channel
before tearing down data path resources.

V2 VFs are not provisioned with an RES_TYPE_SRIOV_INTR resource by
firmware, so bypass that check in the admin channel capability
detection for V2 VFs. The PF still requires this resource.

The admin MSI-X vector reserved by enic_set_intr_mode()
is used for the admin channel interrupt.
enic_adjust_resources() ensures the reserved slot is within
intr_avail bounds even at maximum queue configurations.  The
admin INTR uses a RES_TYPE_INTR_CTRL slot shared with the
data path.

Signed-off-by: Satish Kharat <satishkh@cisco.com>
Link: https://patch.msgid.link/20260812-enic-sriov-v2-admin-channel-v2-v13-10-b3809e448aba@cisco.com
Signed-off-by: Jakub Kicinski <kuba@kernel.org>

0 files changed, 0 insertions, 0 deletions