wifi: mt76: mt7996: do not leave state behind after a failed WED attach

mt7996_mmio_wed_init() set dev->mt76.hwrro_mode and rx_token_size while
building the WED configuration, before knowing whether the WED attach
can succeed. A failed attach left the enlarged rx_token_size behind and
reset hwrro_mode to MT76_HWRRO_OFF, clobbering the values that another
RX datapath owner may have configured earlier in probe: on Airoha
platforms with the wed_enable module parameter set, this broke the NPU
offload configuration set up by mt76_npu_init() (NPU offload requires
HW-RRO and a larger rx token space, and the attach always fails there
since no SoC has both an Airoha NPU and MTK WED).

Move both assignments after a successful attach, next to the existing
success-only dma_dev/irq assignments. This is safe for the regular WED
attach case: the first consumer of either field runs after probe
continues (mtk_wed_device_attach() only invokes the init_buf callback;
rx buffers are allocated via init_rx_buf from mtk_wed_start(), long
after mt7996_mmio_wed_init() has returned).

Within the WED configuration the HW-RRO checks were constant: the mode
was assigned unconditionally right before them, and the hif2 path is
only reachable after a successful main attach has set it. Resolve them
to their constant values and drop the dead branches.

Fixes: 377aa17d2aed ("wifi: mt76: mt7996: Add NPU offload support to MT7996 driver")
Link: https://patch.msgid.link/20260727150434.1778520-7-nbd@nbd.name
Signed-off-by: Felix Fietkau <nbd@nbd.name>

0 files changed, 0 insertions, 0 deletions