wifi: ath11k: fix resource leak on error in ext IRQ setup

In ath11k_ahb_config_irq(), when a CE request_irq() fails, the function
returns the error immediately without freeing the CE IRQs that were
successfully registered in previous loop iterations. The probe error
path does not call ath11k_ahb_free_irq() either, so the previously
registered CE IRQ handlers remain attached to the interrupt lines and
are never released.

In ath11k_ahb_config_ext_irq(), when an external request_irq() fails,
the error is only logged and the loop continues. The function then
returns 0 indicating success, leaving the device in a partially
configured state where some external IRQs are not registered. This
causes enable_irq()/disable_irq()/free_irq() to be called on
unregistered IRQs during runtime and remove/shutdown, triggering
WARN_ON(!desc->action), and missing interrupt handlers lead to data
loss.

Additionally, if alloc_netdev_dummy() fails for a later IRQ group, the
function returns -ENOMEM without freeing the ext IRQs and napi_ndev
that were successfully set up for earlier groups.

Fix all three issues: propagate the error up to the caller and unwind
all successfully registered IRQs and allocated resources on failure.
Also move ab->irq_num[irq_idx] assignment after request_irq() succeeds
in the ext IRQ path to match the CE IRQ path and avoid storing a stale
IRQ number on failure.

Signed-off-by: ZhaoJinming <zhaojinming@uniontech.com>
Reviewed-by: Rameshkumar Sundaram <rameshkumar.sundaram@oss.qualcomm.com>
Reviewed-by: Baochen Qiang <baochen.qiang@oss.qualcomm.com>
Link: https://patch.msgid.link/20260729020005.219253-1-zhaojinming@uniontech.com
Signed-off-by: Jeff Johnson <jeff.johnson@oss.qualcomm.com>

0 files changed, 0 insertions, 0 deletions