mmc: core: Validate UHS/DDR/HS200 timing selection for 1-bit bus width

UHS/DDR/HS200 modes require at least 4-bit bus support. Host controllers
that lack relevant capability registers rely on paring properties provided
by firmware, which may incorrectly set these modes. Now that mmc_validate_host_caps()
has been introduced to validate such configuration violations, let's also
add checks for UHS/DDR/HS200 modes.

This fixes an issue where, if the HS200/HS400 property is set while only
a 1-bit bus width is used, mmc_select_hs200() returns 0 without actually
performing the mode switch. Consequently, mmc_select_timing() proceeds
without falling back to mmc_select_hs(), leaving the eMMC device operating
in legacy mode (26 MHz) instead of switching to High Speed mode (52 MHz).

Signed-off-by: Luke Wang <ziniu.wang_1@nxp.com>
[Shawn: reword the commit msg and rework the code]
Signed-off-by: Shawn Lin <shawn.lin@linux.dev>
Signed-off-by: Ulf Hansson <ulf.hansson@linaro.org>

0 files changed, 0 insertions, 0 deletions