serial: 8250: Add support for console flow control

The kernel documentation specifies that the console option 'r' can
be used to enable hardware flow control for console writes. The 8250
driver does include code for hardware flow control on the console if
cons_flow is set, but there is no code path that actually sets this.
However, that is not the only issue. The problems are:

1. Specifying the console option 'r' does not lead to cons_flow being
   set.

2. Even if cons_flow would be set, serial8250_register_8250_port()
   clears it.

3. When the console option 'r' is specified, uart_set_options()
   attempts to initialize the port for CRTSCTS. However, afterwards
   it does not set the UPSTAT_CTS_ENABLE status bit and therefore on
   boot, uart_cts_enabled() is always false. This policy bit is
   important for console drivers as a criteria if they may poll CTS.

4. Even though uart_set_options() attempts to initialize the port
   for CRTSCTS, the 8250 set_termios() callback does not enable the
   RTS signal (TIOCM_RTS) and thus the hardware is not properly
   initialized for CTS polling.

5. Even if modem control was properly setup for CTS polling
   (TIOCM_RTS), uart_configure_port() clears TIOCM_RTS, thus
   breaking CTS polling.

6. wait_for_xmitr() and serial8250_console_write() use cons_flow
   to decide if CTS polling should occur. However, the condition
   should also include a check that it is not in RS485 mode and
   CRTSCTS is actually enabled in the hardware.

Address all these issues as conservatively as possible by gating them
behind checks focussed on the user specifying console hardware flow
control support and the hardware being configured for CTS polling
at the time of the write to the UART.

Since checking the UPSTAT_CTS_ENABLE status bit is a part of the new
condition gate, these changes also support runtime termios updates to
disable/enable CRTSCTS.

Signed-off-by: John Ogness <john.ogness@linutronix.de>
Link: https://patch.msgid.link/20260511152706.151498-4-john.ogness@linutronix.de
Signed-off-by: Greg Kroah-Hartman <gregkh@linuxfoundation.org>

0 files changed, 0 insertions, 0 deletions