hwmon: add driver for ARCTIC Fan Controller

Add hwmon driver for the ARCTIC Fan Controller, a USB HID device
(VID 0x3904, PID 0xF001) with 10 fan channels. Exposes fan speed in
RPM (read-only) and PWM duty cycle (0-255, read/write) via sysfs.

The device pushes IN reports at ~1 Hz containing RPM readings. PWM is
set via OUT reports; the device applies the new duty cycle and sends
back a 2-byte ACK (Report ID 0x02). The driver waits up to 1 s for
the ACK using a completion. Measured device latency: max ~563 ms over
500 iterations. PWM control is manual-only: the device never changes
duty cycle autonomously.

raw_event() may run in hardirq context, so fan_rpm[] is protected by
a spinlock with irq-save. pwm_duty[] is also protected by this spinlock
because reset_resume() clears it outside the hwmon core lock. The OUT
report buffer is built and write_pending is armed under the same lock so
that no reset_resume() can race with the pwm_duty[] snapshot. priv->buf
is exclusively accessed by write(), which the hwmon core serializes.

Signed-off-by: Aureo Serrano de Souza <aureo.serrano@arctic.de>
Link: https://lore.kernel.org/r/20260508064405.38676-1-aureo.serrano@arctic.de
Signed-off-by: Guenter Roeck <linux@roeck-us.net>

0 files changed, 0 insertions, 0 deletions