Merge branch 'r8152-add-support-for-the-rtl8159-10gbit-usb-ethernet-chip'

Birger Koblitz says:

====================
r8152: Add support for the RTL8159 10Gbit USB Ethernet chip

Add support for the RTL8159, which is a 10GBit USB-Ethernet adapter
chip in the RTL815x family of chips.

The RTL8159 re-uses the frame descriptor format and SRAM2 access introduced
with the RTL8157 as well as most of the setup and PM logic of the RTL8157.

The module was tested with a Lekuo DR59R11 USB-C 10GbE Ethernet Adapter:
[ 2502.906947] usb 2-1: new SuperSpeed USB device number 3 using xhci_hcd
[ 2502.927859] usb 2-1: New USB device found, idVendor=0bda, idProduct=815a, bcdDevice=30.00
[ 2502.927867] usb 2-1: New USB device strings: Mfr=1, Product=2, SerialNumber=7
[ 2502.927871] usb 2-1: Product: USB 10/100/1G/2.5G/5G/10G LAN
[ 2502.927873] usb 2-1: Manufacturer: Realtek
[ 2502.927875] usb 2-1: SerialNumber: 000388C9B3B5XXXX
[ 2503.063745] r8152-cfgselector 2-1: reset SuperSpeed USB device number 3 using xhci_hcd
[ 2503.123876] r8152 2-1:1.0: Requesting firmware: rtl_nic/rtl8159-1.fw
[ 2503.126267] r8152 2-1:1.0: PHY firmware installed 0 to be loaded: 20
[ 2503.156265] r8152 2-1:1.0: load rtl8159-1 v1 2026/01/01 successfully
[ 2503.270729] r8152 2-1:1.0 eth0: v1.12.13
[ 2503.289349] r8152 2-1:1.0 enx88c9b3b5xxxx: renamed from eth0
[ 2507.777055] r8152 2-1:1.0 enx88c9b3b5xxxx: carrier on

The RTL8159 adapter was tested against an AQC107 PCIe-card supporting
10GBit/s and an RTL8157 5Gbit USB-Ethernet adapter supporting 5GBit/s for
performance, link speed and EEE negotiation. Using USB3.2 Gen 2 (20GBit) with
the RTL8159 USB adapter and running iperf3 against the AQC107 PCIe
card resulted in 8.96 Gbits/sec transfer speed.

The code is based on the out-of-tree r8152 driver published by Realtek under
the GPL.

The RTL8159 requires firmware for the PHY in order to achieve a 10GBit link
speed. Without firmware, only 5GBit were achieved. The firmware can be
extracted from the out-of-tree r8152 driver-code where it is stored in the
ram17 u8-array. Code is added to use the existing firmware upload mechanism
of the driver for the RTL8157/9 PHY firmware code. The firmware will be
submitted separately to linux-firmware.
====================

Link: https://patch.msgid.link/20260505-rtl8159_net_next-v4-0-1a648a9c4d8d@birger-koblitz.de
Signed-off-by: Jakub Kicinski <kuba@kernel.org>

0 files changed, 0 insertions, 0 deletions