net: sfp: extend SMBus support

Commit 7662abf4db94 ("net: phy: sfp: Add support for SMBus module access")
added SMBus access for SFP modules, but limited it to single-byte
transfers. As a side effect, hwmon is disabled (16-bit reads cannot be
guaranteed atomic) and a warning is printed.

Many SMBus-only I2C controllers in the wild support more than just
byte access, and SFP cages are often wired to such controllers
rather than to a full-featured I2C controller -- e.g. the SMBus
controllers in the Realtek longan and mango SoCs, which advertise
word access and I2C block reads. Today, they cannot drive an SFP at
all without falling back to the byte-only path.

Extend sfp_smbus_read()/sfp_smbus_write() so that, in addition to
the existing byte access, they also use SMBus word access and SMBus
I2C block access whenever the adapter advertises them. Both
directions are handled in a single read and a single write helper
that pick the largest supported transfer per chunk and fall back as
needed.

I2C-block is preferred unconditionally when available: the protocol
carries any length 1..32, so it can serve every chunk -- including
the 1- and 2-byte tails -- without help from word or byte access.
Note that this requires I2C_FUNC_SMBUS_I2C_BLOCK, which reads a
caller-specified number of bytes. This deviates from the official
SMBus Block Read (length is supplied by the slave) but is widely
supported by Linux I2C controllers/drivers.

Capability matrix this implementation supports:

  - BYTE only:                  works (unchanged behaviour); 1-byte
                                xfers, hwmon disabled.
  - BYTE + WORD:                word for >=2-byte chunks, byte for
                                trailing odd byte.
  - I2C_BLOCK present (with or
    without BYTE/WORD):         block as the universal transport for
                                every chunk.
  - WORD only (no BYTE/BLOCK):  accepted with WARN_ONCE. Even-length
                                transfers work; odd-length transfers
                                (e.g. the 3-byte cotsworks fixup
                                write) hit the BYTE branch which the
                                adapter does not implement, so the
                                xfer returns an error and the
                                operation is aborted. No mainline
                                I2C driver was found to advertise
                                WORD without BYTE; the warning lets
                                us learn about it if it ever shows
                                up.

Adapters with asymmetric R/W capabilities (e.g. only READ_I2C_BLOCK
but not WRITE_I2C_BLOCK) remain functionally correct -- the
per-iteration fallback uses the direction-specific bits -- but the
shared i2c_max_block_size is sized by the all-bits-set check, so a
transfer in the better-supported direction is not upgraded. None of
the mainline I2C bus drivers surveyed during review advertise such
asymmetry; promoting i2c_max_block_size to per-direction sizes can
be revisited if needed.

Signed-off-by: Jonas Jelonek <jelonek.jonas@gmail.com>
Reviewed-by: Maxime Chevallier <maxime.chevallier@bootlin.com>
Link: https://patch.msgid.link/20260614133418.2068201-3-jelonek.jonas@gmail.com
Signed-off-by: Jakub Kicinski <kuba@kernel.org>

0 files changed, 0 insertions, 0 deletions