summaryrefslogtreecommitdiff
path: root/drivers/mmc/core
AgeCommit message (Expand)Author
2022-11-25mmc: core: properly select voltage range without power cycleYann Gautier
2022-11-03mmc: core: Fix kernel panic when remove non-standard SDIO cardMatthew Ma
2022-05-25mmc: core: Default to generic_cmd6_time as timeout in __mmc_switch()Ulf Hansson
2022-05-25mmc: core: Specify timeouts for BKOPS and CACHE_FLUSH for eMMCUlf Hansson
2022-04-20mmc: host: Return an error when ->enable_sdio_irq() ops is missingUlf Hansson
2021-07-20mmc: core: clear flags before allowing to retuneWolfram Sang
2021-05-22mmc: core: Set read only for SD cards with permanent write protect bitSeunghui Lee
2021-05-22mmc: core: Do a power cycle when the CMD11 failsDooHyun Hwang
2021-03-17mmc: core: Fix partition switch time for eMMCAdrian Hunter
2021-02-10mmc: core: Limit retries when analyse of SDIO tuples failsFengnan Chang
2020-10-29mmc: sdio: Check for CISTPL_VERS_1 buffer sizePali Rohár
2019-09-06mmc: core: Fix init of SD cards reporting an invalid VDD rangeUlf Hansson
2019-05-31mmc: core: make pwrseq_emmc (partially) support sleepy GPIO controllersAndrea Merello
2019-05-31mmc: core: Verify SD bus widthRaul E Rangel
2018-12-29mmc: core: Use a minimum 1600ms timeout when enabling CACHE ctrlUlf Hansson
2018-12-29mmc: core: Allow BKOPS and CACHE ctrl even if no HPI supportUlf Hansson
2018-12-29mmc: core: Reset HPI enabled state during re-init and in case of errorsUlf Hansson
2018-08-03mmc: pwrseq: Use kmalloc_array instead of stack VLATobin C. Harding
2018-03-24mmc: avoid removing non-removable hosts during suspendDaniel Drake
2017-12-05mmc: core: prepend 0x to OCR entry in sysfsBastian Stender
2017-12-05mmc: core: Do not leave the block driver in a suspended stateAdrian Hunter
2017-10-12mmc: core: add driver strength selection when selecting hs400esChanho Min
2017-10-08mmc: sdio: fix alignment issue in struct sdio_funcHeiner Kallweit
2017-08-16mmc: mmc: correct the logic for setting HS400ES signal voltageHaibo Chen
2017-08-11mmc: core: Use device_property_read instead of of_property_readDavid Woods
2017-08-11mmc: core: Fix access to HS400-ES devicesGuenter Roeck
2017-02-23mmc: core: fix multi-bit bus width without high-speed modeAnssi Hannula
2017-01-09mmc: sd: Meet alignment requirements for raw_ssr DMAPaul Burton
2016-11-07mmc: mmc: Use 500ms as the default generic CMD6 timeoutUlf Hansson
2016-10-10mmc: core: changes frequency to hs_max_dtr when selecting hs400esShawn Lin
2016-10-10mmc: core: switch to 1V8 or 1V2 for hs400es modeShawn Lin
2016-09-26mmc: core: don't try to switch block size for dual rate modeZiyuan Xu
2016-09-26mmc: core: Add support for sending commands during data transferAdrian Hunter
2016-09-26mmc: core: Optimize the mmc erase size alignmentBaolin Wang
2016-09-26mmc: core: Factor out the alignment of erase sizeBaolin Wang
2016-09-26mmc: core: Use a default maximum erase timeoutUlf Hansson
2016-09-26mmc: sdio: deploy error handling instead of triggering BUG_ONShawn Lin
2016-09-26mmc: core: Add error message when switching fails in mmc_select_hs()Jungseung Lee
2016-09-26mmc: sd: Export SD Status via “ssr” device attributeUri Yanai
2016-09-26mmc: pwrseq-simple: Add an optional post-power-on-delayHans de Goede
2016-07-25mmc: Change the max discard sectors and erase response when HW busy detectBaolin Wang
2016-07-25mmc: core: Extend sysfs with DSR registerBojan Prtvar
2016-07-25mmc: core: expose MMC_CAP2_NO_* to dtShawn Lin
2016-07-25mmc: core: Extend sysfs with OCR registerBojan Prtvar
2016-07-25mmc: core: Allow hosts to specify non-support for MMC commandsShawn Lin
2016-07-25mmc: core: Allow hosts to specify non-support for SD commandsUlf Hansson
2016-07-25mmc: core: Disable HPI for certain Hynix eMMC cardsPratibhasagar V
2016-07-25mmc: core: Only change mode if mmc_select_bus_width() is successfulPeter Griffin
2016-07-25mmc: Set pref erase size based on sizeGwendal Grignou
2016-07-25mmc: mmc: Fix HS switch failure in mmc_select_hs400()Ziyuan Xu