KVM: arm64: gic-v5: Implement direct injection of PPIs

GICv5 is able to directly inject PPI pending state into a guest using
a mechanism called DVI whereby the pending bit for a paticular PPI is
driven directly by the physically-connected hardware. This mechanism
itself doesn't allow for any ID translation, so the host interrupt is
directly mapped into a guest with the same interrupt ID.

When mapping a virtual interrupt to a physical interrupt via
kvm_vgic_map_irq for a GICv5 guest, check if the interrupt itself is a
PPI or not. If it is, and the host's interrupt ID matches that used
for the guest DVI is enabled, and the interrupt itself is marked as
directly_injected.

When the interrupt is unmapped again, this process is reversed, and
DVI is disabled for the interrupt again.

Note: the expectation is that a directly injected PPI is disabled on
the host while the guest state is loaded. The reason is that although
DVI is enabled to drive the guest's pending state directly, the host
pending state also remains driven. In order to avoid the same PPI
firing on both the host and the guest, the host's interrupt must be
disabled (masked). This is left up to the code that owns the device
generating the PPI as this needs to be handled on a per-VM basis. One
VM might use DVI, while another might not, in which case the physical
PPI should be enabled for the latter.

Co-authored-by: Timothy Hayes <timothy.hayes@arm.com>
Signed-off-by: Timothy Hayes <timothy.hayes@arm.com>
Signed-off-by: Sascha Bischoff <sascha.bischoff@arm.com>
Reviewed-by: Jonathan Cameron <jonathan.cameron@huawei.com>
Link: https://patch.msgid.link/20260319154937.3619520-27-sascha.bischoff@arm.com
Signed-off-by: Marc Zyngier <maz@kernel.org>

0 files changed, 0 insertions, 0 deletions