From 6000eab4515a2a381557a48c35e248a3418f2bc6 Mon Sep 17 00:00:00 2001 From: Miquel Raynal Date: Tue, 26 May 2026 16:56:44 +0200 Subject: mtd: spi-nor: Add steps for testing locking support As recently raised on the mailing list, it may be useful to propose a list of steps to go through in order to prove the devices have been described correctly, especially since all the block protection information is not stored in any kind of table and is instead filled manually by developers. Use the debugfs output to ease the comparison between expectations and reality. [rdunlap@infradead.org: fix build warning] Link: https://lore.kernel.org/linux-mtd/20260526172341.773398-1-rdunlap@infradead.org/ Signed-off-by: Miquel Raynal Signed-off-by: Randy Dunlap Signed-off-by: Pratyush Yadav --- Documentation/driver-api/mtd/spi-nor.rst | 133 +++++++++++++++++++++++++++++++ 1 file changed, 133 insertions(+) (limited to 'Documentation') diff --git a/Documentation/driver-api/mtd/spi-nor.rst b/Documentation/driver-api/mtd/spi-nor.rst index 148fa4288760..f817a9193731 100644 --- a/Documentation/driver-api/mtd/spi-nor.rst +++ b/Documentation/driver-api/mtd/spi-nor.rst @@ -203,3 +203,136 @@ section, after the ``---`` marker. mtd.writesize = 1 mtd.oobsize = 0 regions = 0 + +5) If your flash supports locking, please go through the following test + procedure to make sure it correctly behaves. The below example + expects the typical situation where eraseblocks and lock sectors have + the same size. In case you enabled MTD_SPI_NOR_USE_4K_SECTORS, you + must adapt `bs` accordingly. + + Warning: These tests may hard lock your device! Make sure: + + - The device is not hard locked already (#WP strapped to low and + SR_SRWD bit set) + - If you have a WPn pin, you may want to set `no-wp` in your DT for + the time of the test, to only make use of software protection. + Otherwise, clearing the locking state depends on the WPn + signal and if it is tied to low, the flash will be permanently + locked. + + Test full chip locking and make sure expectations, the MEMISLOCKED + ioctl output, the debugfs output and experimental results are all + aligned:: + + root@1:~# alias show_sectors='grep -A4 "locked sectors" /sys/kernel/debug/spi-nor/spi0.0/params' + root@1:~# flash_lock -u /dev/mtd0 + root@1:~# flash_lock -i /dev/mtd0 + Device: /dev/mtd0 + Start: 0 + Len: 0x4000000 + Lock status: unlocked + Return code: 0 + root@1:~# mtd_debug erase /dev/mtd0 0 2097152 + Erased 2097152 bytes from address 0x00000000 in flash + root@1:~# mtd_debug write /dev/mtd0 0 2097152 spi_test + Copied 2097152 bytes from spi_test to address 0x00000000 in flash + root@1:~# mtd_debug read /dev/mtd0 0 2097152 spi_read + Copied 2097152 bytes from address 0x00000000 in flash to spi_read + root@1:~# sha256sum spi* + c444216a6ba2a4a66cccd60a0dd062bce4b865dd52b200ef5e21838c4b899ac8 spi_read + c444216a6ba2a4a66cccd60a0dd062bce4b865dd52b200ef5e21838c4b899ac8 spi_test + root@1:~# show_sectors + software locked sectors + region (in hex) | status | #sectors + ------------------+----------+--------- + 00000000-03ffffff | unlocked | 1024 + + root@1:~# flash_lock -l /dev/mtd0 + root@1:~# flash_lock -i /dev/mtd0 + Device: /dev/mtd0 + Start: 0 + Len: 0x4000000 + Lock status: locked + Return code: 1 + root@1:~# mtd_debug erase /dev/mtd0 0 2097152 + Erased 2097152 bytes from address 0x00000000 in flash + root@1:~# mtd_debug read /dev/mtd0 0 2097152 spi_read + Copied 2097152 bytes from address 0x00000000 in flash to spi_read + root@1:~# sha256sum spi* + c444216a6ba2a4a66cccd60a0dd062bce4b865dd52b200ef5e21838c4b899ac8 spi_read + c444216a6ba2a4a66cccd60a0dd062bce4b865dd52b200ef5e21838c4b899ac8 spi_test + root@1:~# dd if=/dev/urandom of=./spi_test2 bs=1M count=2 + 2+0 records in + 2+0 records out + root@1:~# mtd_debug write /dev/mtd0 0 2097152 spi_test2 + Copied 2097152 bytes from spi_test2 to address 0x00000000 in flash + root@1:~# mtd_debug read /dev/mtd0 0 2097152 spi_read2 + Copied 2097152 bytes from address 0x00000000 in flash to spi_read2 + root@1:~# sha256sum spi* + c444216a6ba2a4a66cccd60a0dd062bce4b865dd52b200ef5e21838c4b899ac8 spi_read + c444216a6ba2a4a66cccd60a0dd062bce4b865dd52b200ef5e21838c4b899ac8 spi_read2 + c444216a6ba2a4a66cccd60a0dd062bce4b865dd52b200ef5e21838c4b899ac8 spi_test + bea9334df51c620440f86751cba0799214a016329f1736f9456d40cf40efdc88 spi_test2 + root@1:~# show_sectors + software locked sectors + region (in hex) | status | #sectors + ------------------+----------+--------- + 00000000-03ffffff | locked | 1024 + root@1:~# flash_lock -u /dev/mtd0 + + Once we trust the debugfs output we can use it to test various + situations. Check top locking/unlocking (end of the device):: + + root@1:~# size=$(cat /sys/class/mtd/mtd0/size) + root@1:~# bs=$(cat /sys/class/mtd/mtd0/erasesize) + root@1:~# nsectors=$(grep unlocked /sys/kernel/debug/spi-nor/spi0.0/params | sed -e 's/.*unlocked | //') + root@1:~# ss=$(($size / $nsectors)) + root@1:~# bps=$(($ss / $bs)) + + root@1:~# flash_lock -u /dev/mtd0 + root@1:~# flash_lock -l /dev/mtd0 $(($size - (2 * $ss))) $((2 * $bps)) # last two + root@1:~# show_sectors + software locked sectors + region (in hex) | status | #sectors + ------------------+----------+--------- + 00000000-03fdffff | unlocked | 1022 + 03fe0000-03ffffff | locked | 2 + root@1:~# flash_lock -u /dev/mtd0 $(($size - (2 * $ss))) $((1 * $bps)) # last one + root@1:~# show_sectors + software locked sectors + region (in hex) | status | #sectors + ------------------+----------+--------- + 00000000-03feffff | unlocked | 1023 + 03ff0000-03ffffff | locked | 1 + + If the flash features 4 block protection bits (BP), we can protect + more than 4MB (typically 128 64kiB-blocks or more), with a finer + grain than locking the entire device:: + + root@1:~# flash_lock -u /dev/mtd0 + root@1:~# flash_lock -l /dev/mtd0 $(($size - (2**7 * $ss))) $((2**7 * $bps)) + root@1:~# show_sectors + software locked sectors + region (in hex) | status | #sectors + ------------------+----------+--------- + 00000000-037fffff | unlocked | 896 + 03800000-03ffffff | locked | 128 + + If the flash features a Top/Bottom (TB) bit, we can protect the + beginning of the flash:: + + root@1:~# flash_lock -u /dev/mtd0 + root@1:~# flash_lock -l /dev/mtd0 0 $((2 * $bps)) # first two + root@1:~# show_sectors + software locked sectors + region (in hex) | status | #sectors + ------------------+----------+--------- + 00000000-0001ffff | locked | 2 + 00020000-03ffffff | unlocked | 1022 + root@1:~# flash_lock -u /dev/mtd0 $ss $((1 * $bps)) # first one + root@1:~# show_sectors + software locked sectors + region (in hex) | status | #sectors + ------------------+----------+--------- + 00000000-0000ffff | locked | 1 + 00010000-03ffffff | unlocked | 1023 -- cgit v1.2.3 From f5d81415a7e12cc73b510bfac181411fedfe6345 Mon Sep 17 00:00:00 2001 From: Miquel Raynal Date: Tue, 26 May 2026 16:56:46 +0200 Subject: mtd: spi-nor: Add steps for testing locking with CMP Extend the test coverage by giving guidelines to verify the CMP bit acts according to our expectations. Signed-off-by: Miquel Raynal Signed-off-by: Pratyush Yadav --- Documentation/driver-api/mtd/spi-nor.rst | 37 ++++++++++++++++++++++++++++++++ 1 file changed, 37 insertions(+) (limited to 'Documentation') diff --git a/Documentation/driver-api/mtd/spi-nor.rst b/Documentation/driver-api/mtd/spi-nor.rst index f817a9193731..747a326fb6c0 100644 --- a/Documentation/driver-api/mtd/spi-nor.rst +++ b/Documentation/driver-api/mtd/spi-nor.rst @@ -336,3 +336,40 @@ section, after the ``---`` marker. ------------------+----------+--------- 00000000-0000ffff | locked | 1 00010000-03ffffff | unlocked | 1023 + + If the flash features a Complement (CMP) bit, we can protect with + more granularity above half of the capacity. Let's lock all but one + block, then unlock one more block:: + + root@1:~# all_but_one=$((($size / $bs) - ($ss / $bs))) + + root@1:~# flash_lock -u /dev/mtd0 + root@1:~# flash_lock -l /dev/mtd0 $ss $all_but_one # all but the first + root@1:~# show_sectors + software locked sectors + region (in hex) | status | #sectors + ------------------+----------+--------- + 00000000-0000ffff | unlocked | 1 + 00010000-03ffffff | locked | 1023 + root@1:~# flash_lock -u /dev/mtd0 $ss $(($ss / $bs)) # all but the two first + root@1:~# show_sectors + software locked sectors + region (in hex) | status | #sectors + ------------------+----------+--------- + 00000000-0001ffff | unlocked | 2 + 00020000-03ffffff | locked | 1022 + root@1:~# flash_lock -u /dev/mtd0 + root@1:~# flash_lock -l /dev/mtd0 0 $all_but_one # same from the other side + root@1:~# show_sectors + software locked sectors + region (in hex) | status | #sectors + ------------------+----------+--------- + 00000000-03feffff | locked | 1023 + 03ff0000-03ffffff | unlocked | 1 + root@1:~# flash_lock -u /dev/mtd0 $(($size - (2 * $ss))) $(($ss / $bs)) # all but two + root@1:~# show_sectors + software locked sectors + region (in hex) | status | #sectors + ------------------+----------+--------- + 00000000-03fdffff | locked | 1022 + 03fe0000-03ffffff | unlocked | 2 -- cgit v1.2.3