On my laptop most memcg kselftests were being skipped because it claimed
cgroup v2 hierarchy wasn't mounted, but this isn't correct.  Instead, it
seems current systemd HEAD mounts it with the name "cgroup2" instead of
"cgroup":

    % grep cgroup /proc/mounts
    cgroup2 /sys/fs/cgroup cgroup2 rw,nosuid,nodev,noexec,relatime,nsdelegate 0 0

I can't think of a reason to need to check fs_spec explicitly
since it's arbitrary, so we can just rely on fs_vfstype.

After these changes, `make TARGETS=cgroup kselftest` actually runs the
cgroup v2 tests in more cases.

Link: http://lkml.kernel.org/r/20190723210737.GA487@chrisdown.name
Signed-off-by: Chris Down <chris@chrisdown.name>
Cc: Johannes Weiner <hannes@cmpxchg.org>
Cc: Tejun Heo <tj@kernel.org>
Cc: Roman Gushchin <guro@fb.com>
Cc: <stable@vger.kernel.org>
Signed-off-by: Andrew Morton <akpm@linux-foundation.org>
Signed-off-by: Linus Torvalds <torvalds@linux-foundation.org>

Pull pidfd fixes from Christian Brauner:
 "This makes setting the exit_state in exit_notify() consistent after
  fixing the pidfd polling race pre-rc1. Related to the race fix, this
  adds a WARN_ON() to do_notify_pidfd() to catch any future exit_state
  races.

  Last, this removes an obsolete comment from the pidfd tests"

* tag 'for-linus-20190730' of git://git.kernel.org/pub/scm/linux/kernel/git/brauner/linux:
  exit: make setting exit_state consistent
  pidfd: Add warning if exit_state is 0 during notification
  pidfd: remove obsolete comments from test

Since the introduction of CLONE_PIDFD pidfd_send_signal() is independent
of CONFIG_PROC_FS.

Signed-off-by: Christian Brauner <christian@brauner.io>

Add a skip() message function that stops the test, logs an explanation,
and sets the "skip" return code (4).

Before loading a livepatch self-test kernel module, first verify that
we've built and installed it by running a 'modprobe --dry-run'.  This
should catch a few environment issues, including !CONFIG_LIVEPATCH and
!CONFIG_TEST_LIVEPATCH.  In these cases, exit gracefully with the new
skip() function.

Reported-by: Jiri Benc <jbenc@redhat.com>
Suggested-by: Shuah Khan <shuah@kernel.org>
Reviewed-by: Petr Mladek <pmladek@suse.com>
Signed-off-by: Joe Lawrence <joe.lawrence@redhat.com>
Signed-off-by: Shuah Khan <skhan@linuxfoundation.org>

This patch fixes some spelling typo in qos_mc_aware.sh

Signed-off-by: Masanari Iida <standby24x7@gmail.com>
Acked-by: Randy Dunlap <rdunlap@infradead.org>
Reviewed-by: Ido Schimmel <idosch@mellanox.com>
Signed-off-by: Shuah Khan <skhan@linuxfoundation.org>

There is an spelling mistake in an a test error message. Fix it.

Acked-by: Andy Lutomirski <luto@kernel.org>
Signed-off-by: Colin Ian King <colin.king@canonical.com>
Signed-off-by: Shuah Khan <skhan@linuxfoundation.org>

This patch fixes some spelling typos in kmod.sh

Signed-off-by: Masanari Iida <standby24x7@gmail.com>
Acked-by: Randy Dunlap <rdunlap@infradead.org>
Signed-off-by: Shuah Khan <skhan@linuxfoundation.org>

Pull NTB updates from Jon Mason:
 "New feature to add support for NTB virtual MSI interrupts, the ability
  to test and use this feature in the NTB transport layer.

  Also, bug fixes for the AMD and Switchtec drivers, as well as some
  general patches"

* tag 'ntb-5.3' of git://github.com/jonmason/ntb: (22 commits)
  NTB: Describe the ntb_msi_test client in the documentation.
  NTB: Add MSI interrupt support to ntb_transport
  NTB: Add ntb_msi_test support to ntb_test
  NTB: Introduce NTB MSI Test Client
  NTB: Introduce MSI library
  NTB: Rename ntb.c to support multiple source files in the module
  NTB: Introduce functions to calculate multi-port resource index
  NTB: Introduce helper functions to calculate logical port number
  PCI/switchtec: Add module parameter to request more interrupts
  PCI/MSI: Support allocating virtual MSI interrupts
  ntb_hw_switchtec: Fix setup MW with failure bug
  ntb_hw_switchtec: Skip unnecessary re-setup of shared memory window for crosslink case
  ntb_hw_switchtec: Remove redundant steps of switchtec_ntb_reinit_peer() function
  NTB: correct ntb_dev_ops and ntb_dev comment typos
  NTB: amd: Silence shift wrapping warning in amd_ntb_db_vector_mask()
  ntb_hw_switchtec: potential shift wrapping bug in switchtec_ntb_init_sndev()
  NTB: ntb_transport: Ensure qp->tx_mw_dma_addr is initaliazed
  NTB: ntb_hw_amd: set peer limit register
  NTB: ntb_perf: Clear stale values in doorbell and command SPAD register
  NTB: ntb_perf: Disable NTB link after clearing peer XLAT registers
  ...

Pull x86 fixes from Thomas Gleixner:
 "A set of x86 specific fixes and updates:

   - The CR2 corruption fixes which store CR2 early in the entry code
     and hand the stored address to the fault handlers.

   - Revert a forgotten leftover of the dropped FSGSBASE series.

   - Plug a memory leak in the boot code.

   - Make the Hyper-V assist functionality robust by zeroing the shadow
     page.

   - Remove a useless check for dead processes with LDT

   - Update paravirt and VMware maintainers entries.

   - A few cleanup patches addressing various compiler warnings"

* 'x86-urgent-for-linus' of git://git.kernel.org/pub/scm/linux/kernel/git/tip/tip:
  x86/entry/64: Prevent clobbering of saved CR2 value
  x86/hyper-v: Zero out the VP ASSIST PAGE on allocation
  x86, boot: Remove multiple copy of static function sanitize_boot_params()
  x86/boot/compressed/64: Remove unused variable
  x86/boot/efi: Remove unused variables
  x86/mm, tracing: Fix CR2 corruption
  x86/entry/64: Update comments and sanity tests for create_gap
  x86/entry/64: Simplify idtentry a little
  x86/entry/32: Simplify common_exception
  x86/paravirt: Make read_cr2() CALLEE_SAVE
  MAINTAINERS: Update PARAVIRT_OPS_INTERFACE and VMWARE_HYPERVISOR_INTERFACE
  x86/process: Delete useless check for dead process with LDT
  x86: math-emu: Hide clang warnings for 16-bit overflow
  x86/e820: Use proper booleans instead of 0/1
  x86/apic: Silence -Wtype-limits compiler warnings
  x86/mm: Free sme_early_buffer after init
  x86/boot: Fix memory leak in default_get_smp_config()
  Revert "x86/ptrace: Prevent ptrace from clearing the FS/GS selector" and fix the test

Pull more KVM updates from Paolo Bonzini:
 "Mostly bugfixes, but also:

   - s390 support for KVM selftests

   - LAPIC timer offloading to housekeeping CPUs

   - Extend an s390 optimization for overcommitted hosts to all
     architectures

   - Debugging cleanups and improvements"

* tag 'for-linus' of git://git.kernel.org/pub/scm/virt/kvm/kvm: (25 commits)
  KVM: x86: Add fixed counters to PMU filter
  KVM: nVMX: do not use dangling shadow VMCS after guest reset
  KVM: VMX: dump VMCS on failed entry
  KVM: x86/vPMU: refine kvm_pmu err msg when event creation failed
  KVM: s390: Use kvm_vcpu_wake_up in kvm_s390_vcpu_wakeup
  KVM: Boost vCPUs that are delivering interrupts
  KVM: selftests: Remove superfluous define from vmx.c
  KVM: SVM: Fix detection of AMD Errata 1096
  KVM: LAPIC: Inject timer interrupt via posted interrupt
  KVM: LAPIC: Make lapic timer unpinned
  KVM: x86/vPMU: reset pmc->counter to 0 for pmu fixed_counters
  KVM: nVMX: Ignore segment base for VMX memory operand when segment not FS or GS
  kvm: x86: ioapic and apic debug macros cleanup
  kvm: x86: some tsc debug cleanup
  kvm: vmx: fix coccinelle warnings
  x86: kvm: avoid constant-conversion warning
  x86: kvm: avoid -Wsometimes-uninitized warning
  KVM: x86: expose AVX512_BF16 feature to guest
  KVM: selftests: enable pgste option for the linker on s390
  KVM: selftests: Move kvm_create_max_vcpus test to generic code
  ...