linux.git/tools/testing/selftests/net/forwarding, branch v5.12

selftests: forwarding: vxlan_bridge_1d: Add more ECN decap test cases

2021-03-29T20:29:49+00:00

Test that all possible combinations of inner and outer ECN bits result
in the correct inner ECN marking according to RFC 6040 4.2.

Signed-off-by: Ido Schimmel 
Signed-off-by: David S. Miller

selftests: forwarding: vxlan_bridge_1d: Fix vxlan ecn decapsulate value

2021-03-19T20:54:28+00:00

The ECN bit defines ECT(1) = 1, ECT(0) = 2. So inner 0x02 + outer 0x01
should be inner ECT(0) + outer ECT(1). Based on the description of
__INET_ECN_decapsulate, the final decapsulate value should be
ECT(1). So fix the test expect value to 0x01.

Before the fix:
TEST: VXLAN: ECN decap: 01/02->0x02                                 [FAIL]
        Expected to capture 10 packets, got 0.

After the fix:
TEST: VXLAN: ECN decap: 01/02->0x01                                 [ OK ]

Fixes: a0b61f3d8ebf ("selftests: forwarding: vxlan_bridge_1d: Add an ECN decap test")
Signed-off-by: Hangbin Liu 
Signed-off-by: David S. Miller

selftests: forwarding: Fix race condition in mirror installation

2021-02-26T23:47:52+00:00

When mirroring to a gretap in hardware the device expects to be
programmed with the egress port and all the encapsulating headers. This
requires the driver to resolve the path the packet will take in the
software data path and program the device accordingly.

If the path cannot be resolved (in this case because of an unresolved
neighbor), then mirror installation fails until the path is resolved.
This results in a race that causes the test to sometimes fail.

Fix this by setting the neighbor's state to permanent, so that it is
always valid.

Fixes: b5b029399fa6d ("selftests: forwarding: mirror_gre_bridge_1d_vlan: Add STP test")
Signed-off-by: Danielle Ratson 
Reviewed-by: Petr Machata 
Signed-off-by: Ido Schimmel 
Signed-off-by: Jakub Kicinski

net: re-solve some conflicts after net -> net-next merge

2021-02-17T07:12:23+00:00

Signed-off-by: Jakub Kicinski

Merge git://git.kernel.org/pub/scm/linux/kernel/git/netdev/net

2021-02-17T01:51:13+00:00

selftests: tc: Add generic mpls matching support for tc-flower

2021-02-13T01:13:52+00:00

Add tests in tc_flower.sh for generic matching on MPLS Label Stack
Entries. The label, tc, bos and ttl fields are tested for the first
and second labels. For each field, the minimal and maximal values are
tested (the former at depth 1 and the later at depth 2).
There are also tests for matching the presence of a label stack entry
at a given depth.

In order to reduce the amount of code, all "lse" subcommands are tested
in match_mpls_lse_test(). Action "continue" is used, so that test
packets are evaluated by all filters. Then, we can verify if each
filter matched the expected number of packets.

Some versions of tc-flower produced invalid json output when dumping
MPLS filters with depth > 1. Skip the test if tc isn't recent enough.

Signed-off-by: Guillaume Nault 
Signed-off-by: David S. Miller

selftests: tc: Add basic mpls_* matching support for tc-flower

2021-02-13T01:13:52+00:00

Add tests in tc_flower.sh for mpls_label, mpls_tc, mpls_bos and
mpls_ttl. For each keyword, test the minimal and maximal values.

Selectively skip these new mpls tests for tc versions that don't
support them.

Signed-off-by: Guillaume Nault 
Signed-off-by: David S. Miller

flow_dissector: fix TTL and TOS dissection on IPv4 fragments

2021-02-13T01:03:51+00:00

the following command:

 # tc filter add dev $h2 ingress protocol ip pref 1 handle 101 flower \
   $tcflags dst_ip 192.0.2.2 ip_ttl 63 action drop

doesn't drop all IPv4 packets that match the configured TTL / destination
address. In particular, if "fragment offset" or "more fragments" have non
zero value in the IPv4 header, setting of FLOW_DISSECTOR_KEY_IP is simply
ignored. Fix this dissecting IPv4 TTL and TOS before fragment info; while
at it, add a selftest for tc flower's match on 'ip_ttl' that verifies the
correct behavior.

Fixes: 518d8a2e9bad ("net/flow_dissector: add support for dissection of misc ip header fields")
Reported-by: Shuang Li 
Signed-off-by: Davide Caratti 
Signed-off-by: David S. Miller

net: selftests: Add lanes setting test

2021-02-04T02:37:29+00:00

Test that setting lanes parameter is working.

Set max speed and max lanes in the list of advertised link modes,
and then try to set max speed with the lanes below max lanes if exists
in the list.

And then, test that setting number of lanes larger than max lanes fails.

Do the above for both autoneg on and off.

$ ./ethtool_lanes.sh

TEST: 4 lanes is autonegotiated                                     [ OK ]
TEST: Lanes number larger than max width is not set                 [ OK ]
TEST: Autoneg off, 4 lanes detected during force mode               [ OK ]
TEST: Lanes number larger than max width is not set                 [ OK ]

Signed-off-by: Danielle Ratson 
Signed-off-by: Jakub Kicinski

Merge git://git.kernel.org/pub/scm/linux/kernel/git/netdev/net

2021-01-29T01:09:31+00:00

drivers/net/can/dev.c
  b552766c872f ("can: dev: prevent potential information leak in can_fill_info()")
  3e77f70e7345 ("can: dev: move driver related infrastructure into separate subdir")
  0a042c6ec991 ("can: dev: move netlink related code into seperate file")

  Code move.

drivers/net/ethernet/mellanox/mlx5/core/en_ethtool.c
  57ac4a31c483 ("net/mlx5e: Correctly handle changing the number of queues when the interface is down")
  214baf22870c ("net/mlx5e: Support HTB offload")

  Adjacent code changes

net/switchdev/switchdev.c
  20776b465c0c ("net: switchdev: don't set port_obj_info->handled true when -EOPNOTSUPP")
  ffb68fc58e96 ("net: switchdev: remove the transaction structure from port object notifiers")
  bae33f2b5afe ("net: switchdev: remove the transaction structure from port attributes")

  Transaction parameter gets dropped otherwise keep the fix.

Signed-off-by: Jakub Kicinski