linux.git/net/wireless, branch v3.11-rc4

regulatory: use correct regulatory initiator on wiphy register

2013-07-25T07:52:46+00:00

The current regdomain was not always set by the core. This causes
cards with a custom regulatory domain to ignore user initiated changes
if done before the card was registered.

Signed-off-by: Arik Nemtsov 
Acked-by: Luis R. Rodriguez 
Signed-off-by: Johannes Berg

nl80211: fix the setting of RSSI threshold value for mesh

2013-07-16T06:55:58+00:00

RSSI threshold value used for mesh peering should be in
negative value. After range checks to mesh parameters is
introduced, this is not allowed. Fix this.

Signed-off-by: Chun-Yeow Yeoh 
Signed-off-by: Johannes Berg

regulatory: add missing rtnl locking

2013-07-16T06:55:55+00:00

restore_regulatory_settings() requires the RTNL to be held,
add the missing locking in reg_timeout_work().

Signed-off-by: Johannes Berg

cfg80211: fix bugs in new SME implementation

2013-07-16T06:55:54+00:00

When splitting the SME implementation from the MLME code,
I introduced a few bugs:
 * association failures no longer sent a connect-failure event
 * getting disassociated from the AP caused deauth to be sent
   but state wasn't cleaned up, leading to warnings
 * authentication failures weren't cleaned up properly, causing
   new connection attempts to warn and fail

Fix these bugs.

Signed-off-by: Johannes Berg

nl80211: fix mgmt tx status and testmode reporting for netns

2013-07-16T06:55:37+00:00

These two events were sent to the default network
namespace.

This caused AP mode in a non-default netns to not
work correctly. Mgmt tx status was multicasted to
a different (default) netns instead of the one the
AP was in.

Cc: stable@vger.kernel.org
Signed-off-by: Michal Kazior 
Signed-off-by: Johannes Berg

Merge branch 'master' of git://git.kernel.org/pub/scm/linux/kernel/git/linville/wireless-next into for-davem

2013-06-28T17:18:21+00:00

Conflicts:
	net/wireless/nl80211.c

cfg80211: fix compilation warning for cfg80211_leave_all()

2013-06-24T13:57:32+00:00

The following compilation issue popped up moving from v3.10-rc1 to
v3.10-rc6 after merging wireless-testing.

net/wireless/sysfs.c:86:13: error: 'cfg80211_leave_all' defined
but not used [-Werror=unused-function]

The function is only called when CONFIG_PM is enabled. Moving the
function under CONFIG_PM as well.

Signed-off-by: Arend van Spriel 
Signed-off-by: Johannes Berg

wireless: check for dangling wdev->current_bss pointer

2013-06-24T13:55:36+00:00

If it *is* still set when the netdev is being deleted,
then we are about to leak a pointer.  Warn and clean up
in that case.

Signed-off-by: Ben Greear 
Signed-off-by: Johannes Berg

wireless: add comments about bss refcounting

2013-06-24T13:54:45+00:00

Should help the next person that tries to understand
the bss refcounting logic.

Signed-off-by: Ben Greear 
Signed-off-by: Johannes Berg

wireless: Make sure __cfg80211_connect_result always puts bss

2013-06-24T13:51:22+00:00

Otherwise, we can leak a bss reference.

Signed-off-by: Ben Greear 
Signed-off-by: Johannes Berg