linux.git/net/ipv6, branch v4.5-rc5

tcp: do not drop syn_recv on all icmp reports

2016-02-09T09:15:37+00:00

Petr Novopashenniy reported that ICMP redirects on SYN_RECV sockets
were leading to RST.

This is of course incorrect.

A specific list of ICMP messages should be able to drop a SYN_RECV.

For instance, a REDIRECT on SYN_RECV shall be ignored, as we do
not hold a dst per SYN_RECV pseudo request.

Bugzilla: https://bugzilla.kernel.org/show_bug.cgi?id=111751
Fixes: 079096f103fa ("tcp/dccp: install syn_recv requests into ehash table")
Reported-by: Petr Novopashenniy 
Signed-off-by: Eric Dumazet 
Signed-off-by: David S. Miller

ipv6: fix a lockdep splat

2016-02-08T15:33:32+00:00

Silence lockdep false positive about rcu_dereference() being
used in the wrong context.

First one should use rcu_dereference_protected() as we own the spinlock.

Second one should be a normal assignation, as no barrier is needed.

Fixes: 18367681a10bd ("ipv6 flowlabel: Convert np->ipv6_fl_list to RCU.")
Reported-by: Dave Jones 
Signed-off-by: Eric Dumazet 
Acked-by: Hannes Frederic Sowa 
Signed-off-by: David S. Miller

ipv6: addrconf: Fix recursive spin lock call

2016-02-06T08:08:15+00:00

A rcu stall with the following backtrace was seen on a system with
forwarding, optimistic_dad and use_optimistic set. To reproduce,
set these flags and allow ipv6 autoconf.

This occurs because the device write_lock is acquired while already
holding the read_lock. Back trace below -

INFO: rcu_preempt self-detected stall on CPU { 1}  (t=2100 jiffies
 g=3992 c=3991 q=4471)
<6> Task dump for CPU 1:
<2> kworker/1:0     R  running task    12168    15   2 0x00000002
<2> Workqueue: ipv6_addrconf addrconf_dad_work
<6> Call trace:
<2> [] el1_irq+0x68/0xdc
<2> [] _raw_write_lock_bh+0x20/0x30
<2> [] __ipv6_dev_ac_inc+0x64/0x1b4
<2> [] addrconf_join_anycast+0x9c/0xc4
<2> [] __ipv6_ifa_notify+0x160/0x29c
<2> [] ipv6_ifa_notify+0x50/0x70
<2> [] addrconf_dad_work+0x314/0x334
<2> [] process_one_work+0x244/0x3fc
<2> [] worker_thread+0x2f8/0x418
<2> [] kthread+0xe0/0xec

v2: do addrconf_dad_kick inside read lock and then acquire write
lock for ipv6_ifa_notify as suggested by Eric

Fixes: 7fd2561e4ebdd ("net: ipv6: Add a sysctl to make optimistic
addresses useful candidates")

Cc: Eric Dumazet 
Cc: Erik Kline 
Cc: Hannes Frederic Sowa 
Signed-off-by: Subash Abhinov Kasiviswanathan 
Acked-by: Hannes Frederic Sowa 
Acked-by: Eric Dumazet 
Signed-off-by: David S. Miller

Merge git://git.kernel.org/pub/scm/linux/kernel/git/davem/net

2016-02-01T23:56:08+00:00

Pull networking fixes from David Miller:
 "This looks like a lot but it's a mixture of regression fixes as well
  as fixes for longer standing issues.

   1) Fix on-channel cancellation in mac80211, from Johannes Berg.

   2) Handle CHECKSUM_COMPLETE properly in xt_TCPMSS netfilter xtables
      module, from Eric Dumazet.

   3) Avoid infinite loop in UDP SO_REUSEPORT logic, also from Eric
      Dumazet.

   4) Avoid a NULL deref if we try to set SO_REUSEPORT after a socket is
      bound, from Craig Gallek.

   5) GRO key comparisons don't take lightweight tunnels into account,
      from Jesse Gross.

   6) Fix struct pid leak via SCM credentials in AF_UNIX, from Eric
      Dumazet.

   7) We need to set the rtnl_link_ops of ipv6 SIT tunnels before we
      register them, otherwise the NEWLINK netlink message is missing
      the proper attributes.  From Thadeu Lima de Souza Cascardo.

   8) Several Spectrum chip bug fixes for mlxsw switch driver, from Ido
      Schimmel

   9) Handle fragments properly in ipv4 easly socket demux, from Eric
      Dumazet.

  10) Don't ignore the ifindex key specifier on ipv6 output route
      lookups, from Paolo Abeni"

* git://git.kernel.org/pub/scm/linux/kernel/git/davem/net: (128 commits)
  tcp: avoid cwnd undo after receiving ECN
  irda: fix a potential use-after-free in ircomm_param_request
  net: tg3: avoid uninitialized variable warning
  net: nb8800: avoid uninitialized variable warning
  net: vxge: avoid unused function warnings
  net: bgmac: clarify CONFIG_BCMA dependency
  net: hp100: remove unnecessary #ifdefs
  net: davinci_cpdma: use dma_addr_t for DMA address
  ipv6/udp: use sticky pktinfo egress ifindex on connect()
  ipv6: enforce flowi6_oif usage in ip6_dst_lookup_tail()
  netlink: not trim skb for mmaped socket when dump
  vxlan: fix a out of bounds access in __vxlan_find_mac
  net: dsa: mv88e6xxx: fix port VLAN maps
  fib_trie: Fix shift by 32 in fib_table_lookup
  net: moxart: use correct accessors for DMA memory
  ipv4: ipconfig: avoid unused ic_proto_used symbol
  bnxt_en: Fix crash in bnxt_free_tx_skbs() during tx timeout.
  bnxt_en: Exclude rx_drop_pkts hw counter from the stack's rx_dropped counter.
  bnxt_en: Ring free response from close path should use completion ring
  net_sched: drr: check for NULL pointer in drr_dequeue
  ...

ipv6/udp: use sticky pktinfo egress ifindex on connect()

2016-01-30T04:31:26+00:00

Currently, the egress interface index specified via IPV6_PKTINFO
is ignored by __ip6_datagram_connect(), so that RFC 3542 section 6.7
can be subverted when the user space application calls connect()
before sendmsg().
Fix it by initializing properly flowi6_oif in connect() before
performing the route lookup.

Signed-off-by: Paolo Abeni 
Acked-by: Hannes Frederic Sowa 
Signed-off-by: David S. Miller

ipv6: enforce flowi6_oif usage in ip6_dst_lookup_tail()

2016-01-30T04:31:26+00:00

The current implementation of ip6_dst_lookup_tail basically
ignore the egress ifindex match: if the saddr is set,
ip6_route_output() purposefully ignores flowi6_oif, due
to the commit d46a9d678e4c ("net: ipv6: Dont add RT6_LOOKUP_F_IFACE
flag if saddr set"), if the saddr is 'any' the first route lookup
in ip6_dst_lookup_tail fails, but upon failure a second lookup will
be performed with saddr set, thus ignoring the ifindex constraint.

This commit adds an output route lookup function variant, which
allows the caller to specify lookup flags, and modify
ip6_dst_lookup_tail() to enforce the ifindex match on the second
lookup via said helper.

ip6_route_output() becames now a static inline function build on
top of ip6_route_output_flags(); as a side effect, out-of-tree
modules need now a GPL license to access the output route lookup
functionality.

Signed-off-by: Paolo Abeni 
Acked-by: Hannes Frederic Sowa 
Acked-by: David Ahern 
Signed-off-by: David S. Miller

sit: set rtnl_link_ops before calling register_netdevice

2016-01-25T18:51:53+00:00

When creating a SIT tunnel with ip tunnel, rtnl_link_ops is not set before
ipip6_tunnel_create is called. When register_netdevice is called, there is
no linkinfo attribute in the NEWLINK message because of that.

Setting rtnl_link_ops before calling register_netdevice fixes that.

Signed-off-by: Thadeu Lima de Souza Cascardo 
Signed-off-by: David S. Miller

ipv4+ipv6: Make INET*_ESP select CRYPTO_ECHAINIV

2016-01-25T18:45:41+00:00

The ESP algorithms using CBC mode require echainiv. Hence INET*_ESP have
to select CRYPTO_ECHAINIV in order to work properly. This solves the
issues caused by a misconfiguration as described in [1].
The original approach, patching crypto/Kconfig was turned down by
Herbert Xu [2].

[1] https://lists.strongswan.org/pipermail/users/2015-December/009074.html
[2] http://marc.info/?l=linux-crypto-vger&m=145224655809562&w=2

Signed-off-by: Thomas Egerer 
Acked-by: Herbert Xu 
Signed-off-by: David S. Miller

net: drop tcp_memcontrol.c

2016-01-21T01:09:18+00:00

tcp_memcontrol.c only contains legacy memory.tcp.kmem.* file definitions
and mem_cgroup->tcp_mem init/destroy stuff.  This doesn't belong to
network subsys.  Let's move it to memcontrol.c.  This also allows us to
reuse generic code for handling legacy memcg files.

Signed-off-by: Vladimir Davydov 
Acked-by: Johannes Weiner 
Cc: "David S. Miller" 
Acked-by: Michal Hocko 
Signed-off-by: Andrew Morton 
Signed-off-by: Linus Torvalds

udp: fix potential infinite loop in SO_REUSEPORT logic

2016-01-19T18:52:25+00:00

Using a combination of connected and un-connected sockets, Dmitry
was able to trigger soft lockups with his fuzzer.

The problem is that sockets in the SO_REUSEPORT array might have
different scores.

Right after sk2=socket(), setsockopt(sk2,...,SO_REUSEPORT, on) and
bind(sk2, ...), but _before_ the connect(sk2) is done, sk2 is added into
the soreuseport array, with a score which is smaller than the score of
first socket sk1 found in hash table (I am speaking of the regular UDP
hash table), if sk1 had the connect() done, giving a +8 to its score.

hash bucket [X] -> sk1 -> sk2 -> NULL

sk1 score = 14  (because it did a connect())
sk2 score = 6

SO_REUSEPORT fast selection is an optimization. If it turns out the
score of the selected socket does not match score of first socket, just
fallback to old SO_REUSEPORT logic instead of trying to be too smart.

Normal SO_REUSEPORT users do not mix different kind of sockets, as this
mechanism is used for load balance traffic.

Fixes: e32ea7e74727 ("soreuseport: fast reuseport UDP socket selection")
Reported-by: Dmitry Vyukov 
Signed-off-by: Eric Dumazet 
Cc: Craig Gallek 
Acked-by: Craig Gallek 
Signed-off-by: David S. Miller