linux.git/mm/page_alloc.c, branch v2.6.29

mm: fix memmap init for handling memory hole

2009-02-18T23:37:55+00:00

Now, early_pfn_in_nid(PFN, NID) may returns false if PFN is a hole.
and memmap initialization was not done. This was a trouble for
sparc boot.

To fix this, the PFN should be initialized and marked as PG_reserved.
This patch changes early_pfn_in_nid() return true if PFN is a hole.

Signed-off-by: KAMEZAWA Hiroyuki 
Reported-by: David Miller 
Tested-by: KOSAKI Motohiro 
Cc: Mel Gorman 
Cc: Heiko Carstens 
Cc: 		[2.6.25.x, 2.6.26.x, 2.6.27.x, 2.6.28.x]
Signed-off-by: Andrew Morton 
Signed-off-by: Linus Torvalds

mm: clean up for early_pfn_to_nid()

2009-02-18T23:37:55+00:00

What's happening is that the assertion in mm/page_alloc.c:move_freepages()
is triggering:

	BUG_ON(page_zone(start_page) != page_zone(end_page));

Once I knew this is what was happening, I added some annotations:

	if (unlikely(page_zone(start_page) != page_zone(end_page))) {
		printk(KERN_ERR "move_freepages: Bogus zones: "
		       "start_page[%p] end_page[%p] zone[%p]\n",
		       start_page, end_page, zone);
		printk(KERN_ERR "move_freepages: "
		       "start_zone[%p] end_zone[%p]\n",
		       page_zone(start_page), page_zone(end_page));
		printk(KERN_ERR "move_freepages: "
		       "start_pfn[0x%lx] end_pfn[0x%lx]\n",
		       page_to_pfn(start_page), page_to_pfn(end_page));
		printk(KERN_ERR "move_freepages: "
		       "start_nid[%d] end_nid[%d]\n",
		       page_to_nid(start_page), page_to_nid(end_page));
 ...

And here's what I got:

	move_freepages: Bogus zones: start_page[2207d0000] end_page[2207dffc0] zone[fffff8103effcb00]
	move_freepages: start_zone[fffff8103effcb00] end_zone[fffff8003fffeb00]
	move_freepages: start_pfn[0x81f600] end_pfn[0x81f7ff]
	move_freepages: start_nid[1] end_nid[0]

My memory layout on this box is:

[    0.000000] Zone PFN ranges:
[    0.000000]   Normal   0x00000000 -> 0x0081ff5d
[    0.000000] Movable zone start PFN for each node
[    0.000000] early_node_map[8] active PFN ranges
[    0.000000]     0: 0x00000000 -> 0x00020000
[    0.000000]     1: 0x00800000 -> 0x0081f7ff
[    0.000000]     1: 0x0081f800 -> 0x0081fe50
[    0.000000]     1: 0x0081fed1 -> 0x0081fed8
[    0.000000]     1: 0x0081feda -> 0x0081fedb
[    0.000000]     1: 0x0081fedd -> 0x0081fee5
[    0.000000]     1: 0x0081fee7 -> 0x0081ff51
[    0.000000]     1: 0x0081ff59 -> 0x0081ff5d

So it's a block move in that 0x81f600-->0x81f7ff region which triggers
the problem.

This patch:

Declaration of early_pfn_to_nid() is scattered over per-arch include
files, and it seems it's complicated to know when the declaration is used.
 I think it makes fix-for-memmap-init not easy.

This patch moves all declaration to include/linux/mm.h

After this,
  if !CONFIG_NODES_POPULATES_NODE_MAP && !CONFIG_HAVE_ARCH_EARLY_PFN_TO_NID
     -> Use static definition in include/linux/mm.h
  else if !CONFIG_HAVE_ARCH_EARLY_PFN_TO_NID
     -> Use generic definition in mm/page_alloc.c
  else
     -> per-arch back end function will be called.

Signed-off-by: KAMEZAWA Hiroyuki 
Tested-by: KOSAKI Motohiro 
Reported-by: David Miller 
Cc: Mel Gorman 
Cc: Heiko Carstens 
Cc: 		[2.6.25.x, 2.6.26.x, 2.6.27.x, 2.6.28.x]
Signed-off-by: Andrew Morton 
Signed-off-by: Linus Torvalds

mm: introduce zone_reclaim struct

2009-01-08T16:31:07+00:00

Add zone_reclam_stat struct for later enhancement.

A later patch uses this.  This patch doesn't any behavior change (yet).

Reviewed-by: KAMEZAWA Hiroyuki 
Signed-off-by: KOSAKI Motohiro 
Acked-by: Rik van Riel 
Cc: Balbir Singh 
Cc: Daisuke Nishimura 
Cc: Hugh Dickins 
Cc: KOSAKI Motohiro 
Signed-off-by: Andrew Morton 
Signed-off-by: Linus Torvalds

mm: remove CONFIG_OUT_OF_LINE_PFN_TO_PAGE

2009-01-06T23:59:10+00:00

No architectures use CONFIG_OUT_OF_LINE_PFN_TO_PAGE - it can be removed.

Signed-off-by: KOSAKI Motohiro 
Cc: KAMEZAWA Hiroyuki 
Signed-off-by: Andrew Morton 
Signed-off-by: Linus Torvalds

badpage: KERN_ALERT BUG instead of KERN_EMERG

2009-01-06T23:59:08+00:00

bad_page() and rmap Eeek messages have said KERN_EMERG for a few years,
which I've followed in print_bad_pte().  These are serious system errors,
on a par with BUGs, but they're not quite emergencies, and we do our best
to carry on: say KERN_ALERT "BUG: " like the x86 oops does.

And remove the "Trying to fix it up, but a reboot is needed" line: it's
not untrue, but I hope the KERN_ALERT "BUG: " conveys as much.

Signed-off-by: Hugh Dickins 
Cc: Nick Piggin 
Cc: Christoph Lameter 
Cc: Mel Gorman 
Cc: Rik van Riel 
Signed-off-by: Andrew Morton 
Signed-off-by: Linus Torvalds

badpage: ratelimit print_bad_pte and bad_page

2009-01-06T23:59:07+00:00

print_bad_pte() and bad_page() might each need ratelimiting - especially
for their dump_stacks, almost never of interest, yet not quite
dispensible.  Correlating corruption across neighbouring entries can be
very helpful, so allow a burst of 60 reports before keeping quiet for the
remainder of that minute (or allow a steady drip of one report per
second).

Signed-off-by: Hugh Dickins 
Cc: Nick Piggin 
Cc: Christoph Lameter 
Cc: Mel Gorman 
Cc: Rik van Riel 
Signed-off-by: Andrew Morton 
Signed-off-by: Linus Torvalds

badpage: vm_normal_page use print_bad_pte

2009-01-06T23:59:07+00:00

print_bad_pte() is so far being called only when zap_pte_range() finds
negative page_mapcount, or there's a fault on a pte_file where it does not
belong.  That's weak coverage when we suspect pagetable corruption.

Originally, it was called when vm_normal_page() found an invalid pfn: but
pfn_valid is expensive on some architectures and configurations, so 2.6.24
put that under CONFIG_DEBUG_VM (which doesn't help in the field), then
2.6.26 replaced it by a VM_BUG_ON (likewise).

Reinstate the print_bad_pte() in vm_normal_page(), but use a cheaper test
than pfn_valid(): memmap_init_zone() (used in bootup and hotplug) keep a
__read_mostly note of the highest_memmap_pfn, vm_normal_page() then check
pfn against that.  We could call this pfn_plausible() or pfn_sane(), but I
doubt we'll need it elsewhere: of course it's not reliable, but gives much
stronger pagetable validation on many boxes.

Also use print_bad_pte() when the pte_special bit is found outside a
VM_PFNMAP or VM_MIXEDMAP area, instead of VM_BUG_ON.

Signed-off-by: Hugh Dickins 
Cc: Nick Piggin 
Cc: Christoph Lameter 
Cc: Mel Gorman 
Cc: Rik van Riel 
Signed-off-by: Andrew Morton 
Signed-off-by: Linus Torvalds

badpage: replace page_remove_rmap Eeek and BUG

2009-01-06T23:59:07+00:00

Now that bad pages are kept out of circulation, there is no need for the
infamous page_remove_rmap() BUG() - once that page is freed, its negative
mapcount will issue a "Bad page state" message and the page won't be
freed.  Removing the BUG() allows more info, on subsequent pages, to be
gathered.

We do have more info about the page at this point than bad_page() can know
- notably, what the pmd is, which might pinpoint something like low 64kB
corruption - but page_remove_rmap() isn't given the address to find that.

In practice, there is only one call to page_remove_rmap() which has ever
reported anything, that from zap_pte_range() (usually on exit, sometimes
on munmap).  It has all the info, so remove page_remove_rmap()'s "Eeek"
message and leave it all to zap_pte_range().

mm/memory.c already has a hardly used print_bad_pte() function, showing
some of the appropriate info: extend it to show what we want for the rmap
case: pte info, page info (when there is a page) and vma info to compare.
zap_pte_range() already knows the pmd, but print_bad_pte() is easier to
use if it works that out for itself.

Some of this info is also shown in bad_page()'s "Bad page state" message.
Keep them separate, but adjust them to match each other as far as
possible.  Say "Bad page map" in print_bad_pte(), and add a TAINT_BAD_PAGE
there too.

print_bad_pte() show current->comm unconditionally (though it should get
repeated in the usually irrelevant stack trace): sorry, I misled Nick
Piggin to make it conditional on vm_mm == current->mm, but current->mm is
already NULL in the exit case.  Usually current->comm is good, though
exceptionally it may not be that of the mm (when "swapoff" for example).

Signed-off-by: Hugh Dickins 
Cc: Nick Piggin 
Cc: Christoph Lameter 
Cc: Mel Gorman 
Cc: Rik van Riel 
Signed-off-by: Andrew Morton 
Signed-off-by: Linus Torvalds

badpage: keep any bad page out of circulation

2009-01-06T23:59:07+00:00

Until now the bad_page() checkers have special-cased PageReserved, keeping
those pages out of circulation thereafter.  Now extend the special case to
all: we want to keep ANY page with bad state out of circulation - the
"free" page may well be in use by something.

Leave the bad state of those pages untouched, for examination by
debuggers; except for PageBuddy - leaving that set would risk bringing the
page back.

Signed-off-by: Hugh Dickins 
Cc: Nick Piggin 
Cc: Christoph Lameter 
Cc: Mel Gorman 
Cc: Rik van Riel 
Signed-off-by: Andrew Morton 
Signed-off-by: Linus Torvalds

badpage: simplify page_alloc flag check+clear

2009-01-06T23:59:07+00:00

Simplify the PAGE_FLAGS checking and clearing when freeing and allocating
a page: check the same flags as before when freeing, clear ALL the flags
(unless PageReserved) when freeing, check ALL flags off when allocating.

Signed-off-by: Hugh Dickins 
Cc: Nick Piggin 
Cc: Christoph Lameter 
Cc: Mel Gorman 
Cc: Rik van Riel 
Signed-off-by: Andrew Morton 
Signed-off-by: Linus Torvalds