linux.git/include/net/sctp/constants.h, branch for-next

sctp: move 198 addresses from unusable to private scope

2021-07-01T18:47:13+00:00

The doc draft-stewart-tsvwg-sctp-ipv4-00 that restricts 198 addresses
was never published. These addresses as private addresses should be
allowed to use in SCTP.

As Michael Tuexen suggested, this patch is to move 198 addresses from
unusable to private scope.

Reported-by: Sérgio 
Signed-off-by: Xin Long 
Acked-by: Marcelo Ricardo Leitner 
Signed-off-by: David S. Miller

sctp: add the probe timer in transport for PLPMTUD

2021-06-22T18:28:52+00:00

There are 3 timers described in rfc8899#section-5.1.1:

  PROBE_TIMER, PMTU_RAISE_TIMER, CONFIRMATION_TIMER

This patches adds a 'probe_timer' in transport, and it works as either
PROBE_TIMER or PMTU_RAISE_TIMER. At most time, it works as PROBE_TIMER
and expires every a 'probe_interval' time to send the HB probe packet.
When transport pl enters COMPLETE state, it works as PMTU_RAISE_TIMER
and expires in 'probe_interval * 30' time to go back to SEARCH state
and do searching again.

SCTP HB is an acknowledged packet, CONFIRMATION_TIMER is not needed.

The timer will start when transport pl enters BASE state and stop
when it enters DISABLED state.

Signed-off-by: Xin Long 
Acked-by: Marcelo Ricardo Leitner 
Signed-off-by: David S. Miller

sctp: add the constants/variables and states and some APIs for transport

2021-06-22T18:28:52+00:00

These are 4 constants described in rfc8899#section-5.1.2:

  MAX_PROBES, MIN_PLPMTU, MAX_PLPMTU, BASE_PLPMTU;

And 2 variables described in rfc8899#section-5.1.3:

  PROBED_SIZE, PROBE_COUNT;

And 5 states described in rfc8899#section-5.2:

  DISABLED, BASE, SEARCH, SEARCH_COMPLETE, ERROR;

And these 4 APIs are used to reset/update PLPMTUD, check if PLPMTUD is
enabled, and calculate the additional headers length for a transport.

Note the member 'probe_high' in transport will be set to the probe
size when a probe fails with this probe size in the next patches.

Signed-off-by: Xin Long 
Acked-by: Marcelo Ricardo Leitner 
Signed-off-by: David S. Miller

sctp: add probe_interval in sysctl and sock/asoc/transport

2021-06-22T18:28:51+00:00

PLPMTUD can be enabled by doing 'sysctl -w net.sctp.probe_interval=n'.
'n' is the interval for PLPMTUD probe timer in milliseconds, and it
can't be less than 5000 if it's not 0.

All asoc/transport's PLPMTUD in a new socket will be enabled by default.

Signed-off-by: Xin Long 
Acked-by: Marcelo Ricardo Leitner 
Signed-off-by: David S. Miller

sctp: create udp4 sock and add its encap_rcv

2020-10-30T22:23:52+00:00

This patch is to add the functions to create/release udp4 sock,
and set the sock's encap_rcv to process the incoming udp encap
sctp packets. In sctp_udp_rcv(), as we can see, all we need to
do is fix the transport header for sctp_rcv(), then it would
implement the part of rfc6951#section-5.4:

  "When an encapsulated packet is received, the UDP header is removed.
   Then, the generic lookup is performed, as done by an SCTP stack
   whenever a packet is received, to find the association for the
   received SCTP packet"

Note that these functions will be called in the last patch of
this patchset when enabling this feature.

v1->v2:
  - Add pr_err() when fails to create udp v4 sock.
v2->v3:
  - Add 'select NET_UDP_TUNNEL' in sctp Kconfig.
v3->v4:
  - No change.
v4->v5:
  - Change to set udp_port to 0 by default.

Signed-off-by: Xin Long 
Acked-by: Marcelo Ricardo Leitner 
Signed-off-by: Jakub Kicinski

sctp: Don't advertise IPv4 addresses if ipv6only is set on the socket

2020-06-25T23:11:33+00:00

If a socket is set ipv6only, it will still send IPv4 addresses in the
INIT and INIT_ACK packets. This potentially misleads the peer into using
them, which then would cause association termination.

The fix is to not add IPv4 addresses to ipv6only sockets.

Fixes: 1da177e4c3f4 ("Linux-2.6.12-rc2")
Reported-by: Corey Minyard 
Signed-off-by: Marcelo Ricardo Leitner 
Tested-by: Corey Minyard 
Signed-off-by: David S. Miller

sctp: add support for Primary Path Switchover

2019-11-08T22:18:32+00:00

This is a new feature defined in section 5 of rfc7829: "Primary Path
Switchover". By introducing a new tunable parameter:

  Primary.Switchover.Max.Retrans (PSMR)

The primary path will be changed to another active path when the path
error counter on the old primary path exceeds PSMR, so that "the SCTP
sender is allowed to continue data transmission on a new working path
even when the old primary destination address becomes active again".

This patch is to add this tunable parameter, 'ps_retrans' per netns,
sock, asoc and transport. It also allows a user to change ps_retrans
per netns by sysctl, and ps_retrans per sock/asoc/transport will be
initialized with it.

The check will be done in sctp_do_8_2_transport_strike() when this
feature is enabled.

Note this feature is disabled by initializing 'ps_retrans' per netns
as 0xffff by default, and its value can't be less than 'pf_retrans'
when changing by sysctl.

v3->v4:
  - add define SCTP_PS_RETRANS_MAX 0xffff, and use it on extra2 of
    sysctl 'ps_retrans'.
  - add a new entry for ps_retrans on ip-sysctl.txt.

Signed-off-by: Xin Long 
Acked-by: Neil Horman 
Signed-off-by: David S. Miller

sctp: add pf_expose per netns and sock and asoc

2019-11-08T22:18:32+00:00

As said in rfc7829, section 3, point 12:

  The SCTP stack SHOULD expose the PF state of its destination
  addresses to the ULP as well as provide the means to notify the
  ULP of state transitions of its destination addresses from
  active to PF, and vice versa.  However, it is recommended that
  an SCTP stack implementing SCTP-PF also allows for the ULP to be
  kept ignorant of the PF state of its destinations and the
  associated state transitions, thus allowing for retention of the
  simpler state transition model of [RFC4960] in the ULP.

Not only does it allow to expose the PF state to ULP, but also
allow to ignore sctp-pf to ULP.

So this patch is to add pf_expose per netns, sock and asoc. And in
sctp_assoc_control_transport(), ulp_notify will be set to false if
asoc->expose is not 'enabled' in next patch.

It also allows a user to change pf_expose per netns by sysctl, and
pf_expose per sock and asoc will be initialized with it.

Note that pf_expose also works for SCTP_GET_PEER_ADDR_INFO sockopt,
to not allow a user to query the state of a sctp-pf peer address
when pf_expose is 'disabled', as said in section 7.3.

v1->v2:
  - Fix a build warning noticed by Nathan Chancellor.
v2->v3:
  - set pf_expose to UNUSED by default to keep compatible with old
    applications.
v3->v4:
  - add a new entry for pf_expose on ip-sysctl.txt, as Marcelo suggested.
  - change this patch to 1/5, and move sctp_assoc_control_transport
    change into 2/5, as Marcelo suggested.
  - use SCTP_PF_EXPOSE_UNSET instead of SCTP_PF_EXPOSE_UNUSED, and
    set SCTP_PF_EXPOSE_UNSET to 0 in enum, as Marcelo suggested.

Signed-off-by: Xin Long 
Acked-by: Neil Horman 
Signed-off-by: David S. Miller

treewide: Replace GPLv2 boilerplate/reference with SPDX - rule 104

2019-05-24T15:39:00+00:00

Based on 1 normalized pattern(s):

  this sctp implementation is free software you can redistribute it
  and or modify it under the terms of the gnu general public license
  as published by the free software foundation either version 2 or at
  your option any later version this sctp implementation is
  distributed in the hope that it will be useful but without any
  warranty without even the implied warranty of merchantability or
  fitness for a particular purpose see the gnu general public license
  for more details you should have received a copy of the gnu general
  public license along with gnu cc see the file copying if not see
  http www gnu org licenses

extracted by the scancode license scanner the SPDX license identifier

  GPL-2.0-or-later

has been chosen to replace the boilerplate/reference in 42 file(s).

Signed-off-by: Thomas Gleixner 
Reviewed-by: Kate Stewart 
Reviewed-by: Richard Fontana 
Reviewed-by: Allison Randal 
Cc: linux-spdx@vger.kernel.org
Link: https://lkml.kernel.org/r/20190523091649.683323110@linutronix.de
Signed-off-by: Greg Kroah-Hartman

sctp: rename enum sctp_event to sctp_event_type

2018-11-19T20:25:43+00:00

sctp_event is a structure name defined in RFC for sockopt
SCTP_EVENT. To avoid the conflict, rename it.

Signed-off-by: Xin Long 
Signed-off-by: David S. Miller