Pull networking fixes from David Miller:

 1) Fix checksumming regressions, from Tom Herbert.

 2) Undo unintentional permissions changes for SCTP rto_alpha and
    rto_beta sysfs knobs, from Denial Borkmann.

 3) VXLAN, like other IP tunnels, should advertize it's encapsulation
    size using dev->needed_headroom instead of dev->hard_header_len.
    From Cong Wang.

* git://git.kernel.org/pub/scm/linux/kernel/git/davem/net:
  net: sctp: fix permissions for rto_alpha and rto_beta knobs
  vxlan: Checksum fixes
  net: add skb_pop_rcv_encapsulation
  udp: call __skb_checksum_complete when doing full checksum
  net: Fix save software checksum complete
  net: Fix GSO constants to match NETIF flags
  udp: ipv4: do not waste time in __udp4_lib_mcast_demux_lookup
  vxlan: use dev->needed_headroom instead of dev->hard_header_len
  MAINTAINERS: update cxgb4 maintainer

Pull more clock framework updates from Mike Turquette:
 "This contains the second half the of the clk changes for 3.16.

  They are simply fixes and code refactoring for the OMAP clock drivers.
  The sunxi clock driver changes include splitting out the one
  mega-driver into several smaller pieces and adding support for the A31
  SoC clocks"

* tag 'clk-for-linus-3.16-part2' of git://git.linaro.org/people/mike.turquette/linux: (25 commits)
  clk: sunxi: document PRCM clock compatible strings
  clk: sunxi: add PRCM (Power/Reset/Clock Management) clks support
  clk: sun6i: Protect SDRAM gating bit
  clk: sun6i: Protect CPU clock
  clk: sunxi: Rework clock protection code
  clk: sunxi: Move the GMAC clock to a file of its own
  clk: sunxi: Move the 24M oscillator to a file of its own
  clk: sunxi: Remove calls to clk_put
  clk: sunxi: document new A31 USB clock compatible
  clk: sunxi: Implement A31 USB clock
  ARM: dts: OMAP5/DRA7: use omap5-mpu-dpll-clock capable of dealing with higher frequencies
  CLK: TI: dpll: support OMAP5 MPU DPLL that need special handling for higher frequencies
  ARM: OMAP5+: dpll: support Duty Cycle Correction(DCC)
  CLK: TI: clk-54xx: Set the rate for dpll_abe_m2x2_ck
  CLK: TI: Driver for DRA7 ATL (Audio Tracking Logic)
  dt:/bindings: DRA7 ATL (Audio Tracking Logic) clock bindings
  ARM: dts: dra7xx-clocks: Correct name for atl clkin3 clock
  CLK: TI: gate: add composite interface clock to OMAP2 only build
  ARM: OMAP2: clock: add DT boot support for cpufreq_ck
  CLK: TI: OMAP2: add clock init support
  ...

Pull NVMe update from Matthew Wilcox:
 "Mostly bugfixes again for the NVMe driver.  I'd like to call out the
  exported tracepoint in the block layer; I believe Keith has cleared
  this with Jens.

  We've had a few reports from people who're really pounding on NVMe
  devices at scale, hence the timeout changes (and new module
  parameters), hotplug cpu deadlock, tracepoints, and minor performance
  tweaks"

[ Jens hadn't seen that tracepoint thing, but is ok with it - it will
  end up going away when mq conversion happens ]

* git://git.infradead.org/users/willy/linux-nvme: (22 commits)
  NVMe: Fix START_STOP_UNIT Scsi->NVMe translation.
  NVMe: Use Log Page constants in SCSI emulation
  NVMe: Define Log Page constants
  NVMe: Fix hot cpu notification dead lock
  NVMe: Rename io_timeout to nvme_io_timeout
  NVMe: Use last bytes of f/w rev SCSI Inquiry
  NVMe: Adhere to request queue block accounting enable/disable
  NVMe: Fix nvme get/put queue semantics
  NVMe: Delete NVME_GET_FEAT_TEMP_THRESH
  NVMe: Make admin timeout a module parameter
  NVMe: Make iod bio timeout a parameter
  NVMe: Prevent possible NULL pointer dereference
  NVMe: Fix the buffer size passed in GetLogPage(CDW10.NUMD)
  NVMe: Update data structures for NVMe 1.2
  NVMe: Enable BUILD_BUG_ON checks
  NVMe: Update namespace and controller identify structures to the 1.1a spec
  NVMe: Flush with data support
  NVMe: Configure support for block flush
  NVMe: Add tracepoints
  NVMe: Protect against badly formatted CQEs
  ...

This function is used by UDP encapsulation protocols in RX when
crossing encapsulation boundary. If ip_summed is set to
CHECKSUM_UNNECESSARY and encapsulation is not set, change to
CHECKSUM_NONE since the checksum has not been validated within the
encapsulation. Clears csum_valid by the same rationale.

Signed-off-by: Tom Herbert <therbert@google.com>
Signed-off-by: David S. Miller <davem@davemloft.net>

Joseph Gasparakis reported that VXLAN GSO offload stopped working with
i40e device after recent UDP changes. The problem is that the
SKB_GSO_* bits are out of sync with the corresponding NETIF flags. This
patch fixes that. Also, we add BUILD_BUG_ONs in net_gso_ok for several
GSO constants that were missing to avoid the problem in the future.

Reported-by: Joseph Gasparakis <joseph.gasparakis@intel.com>
Signed-off-by: Tom Herbert <therbert@google.com>
Signed-off-by: David S. Miller <davem@davemloft.net>

Pull hwmon updates from Guenter Roeck:
 - new driver for Sensirion SHTC1 humidity / temperature sensor
 - convert ltc4151 and vexpress drivers to use devm functions
 - drop generic chip detection from lm85 driver
 - avoid forward declarations in atxp1 driver
 - fix sign extensions in ina2xx driver

* tag 'hwmon-for-linus' of git://git.kernel.org/pub/scm/linux/kernel/git/groeck/linux-staging:
  hwmon: vexpress: Use devm helper for hwmon device registration
  hwmon: (atxp1) Avoid forward declaration
  hwmon: add support for Sensirion SHTC1 sensor
  hwmon: (ltc4151) Convert to devm_hwmon_device_register_with_groups
  hwmon: (lm85) Drop generic detection
  hwmon: (ina2xx) Cast to s16 on shunt and current regs

There is a potential dead lock if a cpu event occurs during nvme probe
since it registered with hot cpu notification. This fixes the race by
having the module register with notification outside of probe rather
than have each device register.

The actual work is done in a scheduled work queue instead of in the
notifier since assigning IO queues has the potential to block if the
driver creates additional queues.

Signed-off-by: Keith Busch <keith.busch@intel.com>
Signed-off-by: Matthew Wilcox <matthew.r.wilcox@intel.com>

Pull Ceph updates from Sage Weil:
 "This has a mix of bug fixes and cleanups.

  Alex's patch fixes a rare race in RBD.  Ilya's patches fix an ENOENT
  check when a second rbd image is mapped and a couple memory leaks.
  Zheng fixes several issues with fragmented directories and multiple
  MDSs.  Josh fixes a spin/sleep issue, and Josh and Guangliang's
  patches fix setting and unsetting RBD images read-only.

  Naturally there are several other cleanups mixed in for good measure"

* 'for-linus' of git://git.kernel.org/pub/scm/linux/kernel/git/sage/ceph-client: (23 commits)
  rbd: only set disk to read-only once
  rbd: move calls that may sleep out of spin lock range
  rbd: add ioctl for rbd
  ceph: use truncate_pagecache() instead of truncate_inode_pages()
  ceph: include time stamp in every MDS request
  rbd: fix ida/idr memory leak
  rbd: use reference counts for image requests
  rbd: fix osd_request memory leak in __rbd_dev_header_watch_sync()
  rbd: make sure we have latest osdmap on 'rbd map'
  libceph: add ceph_monc_wait_osdmap()
  libceph: mon_get_version request infrastructure
  libceph: recognize poolop requests in debugfs
  ceph: refactor readpage_nounlock() to make the logic clearer
  mds: check cap ID when handling cap export message
  ceph: remember subtree root dirfrag's auth MDS
  ceph: introduce ceph_fill_fragtree()
  ceph: handle cap import atomically
  ceph: pre-allocate ceph_cap struct for ceph_add_cap()
  ceph: update inode fields according to issued caps
  rbd: replace IS_ERR and PTR_ERR with PTR_ERR_OR_ZERO
  ...

Pull SCSI target updates from Nicholas Bellinger:
 "The highlights this round include:

   - Add support for T10 PI pass-through between vhost-scsi +
     virtio-scsi (MST + Paolo + MKP + nab)
   - Add support for T10 PI in qla2xxx target mode (Quinn + MKP + hch +
     nab, merged through scsi.git)
   - Add support for percpu-ida pre-allocation in qla2xxx target code
     (Quinn + nab)
   - A number of iser-target fixes related to hardening the network
     portal shutdown path (Sagi + Slava)
   - Fix response length residual handling for a number of control CDBs
     (Roland + Christophe V.)
   - Various iscsi RFC conformance fixes in the CHAP authentication path
     (Tejas and Calsoft folks + nab)
   - Return TASK_SET_FULL status for tcm_fc(FCoE) DataIn + Response
     failures (Vasu + Jun + nab)
   - Fix long-standing ABORT_TASK + session reset hang (nab)
   - Convert iser-initiator + iser-target to include T10 bytes into EDTL
     (Sagi + Or + MKP + Mike Christie)
   - Fix NULL pointer dereference regression related to XCOPY introduced
     in v3.15 + CC'ed to v3.12.y (nab)"

* 'for-next' of git://git.kernel.org/pub/scm/linux/kernel/git/nab/target-pending: (34 commits)
  target: Fix NULL pointer dereference for XCOPY in target_put_sess_cmd
  vhost-scsi: Include prot_bytes into expected data transfer length
  TARGET/sbc,loopback: Adjust command data length in case pi exists on the wire
  libiscsi, iser: Adjust data_length to include protection information
  scsi_cmnd: Introduce scsi_transfer_length helper
  target: Report correct response length for some commands
  target/sbc: Check that the LBA and number of blocks are correct in VERIFY
  target/sbc: Remove sbc_check_valid_sectors()
  Target/iscsi: Fix sendtargets response pdu for iser transport
  Target/iser: Fix a wrong dereference in case discovery session is over iser
  iscsi-target: Fix ABORT_TASK + connection reset iscsi_queue_req memory leak
  target: Use complete_all for se_cmd->t_transport_stop_comp
  target: Set CMD_T_ACTIVE bit for Task Management Requests
  target: cleanup some boolean tests
  target/spc: Simplify INQUIRY EVPD=0x80
  tcm_fc: Generate TASK_SET_FULL status for response failures
  tcm_fc: Generate TASK_SET_FULL status for DataIN failures
  iscsi-target: Reject mutual authentication with reflected CHAP_C
  iscsi-target: Remove no-op from iscsit_tpg_del_portal_group
  iscsi-target: Fix CHAP_A parameter list handling
  ...

Pull tracing cleanups and bugfixes from Steven Rostedt:
 "One bug fix that goes back to 3.10.  Accessing a non existent buffer
  if "possible cpus" is greater than actual CPUs (including offline
  CPUs).

  Namhyung Kim did some reviews of the patches I sent this merge window
  and found a memory leak and had a few clean ups"

* tag 'trace-3.16-2' of git://git.kernel.org/pub/scm/linux/kernel/git/rostedt/linux-trace:
  tracing: Fix check of ftrace_trace_arrays list_empty() check
  tracing: Fix leak of per cpu max data in instances
  tracing: Cleanup saved_cmdlines_size changes
  ring-buffer: Check if buffer exists before polling