Pull networking fixes from David Miller:

 1) There was a simplification in the ipv6 ndisc packet sending
    attempted here, which avoided using memory accounting on the
    per-netns ndisc socket for sending NDISC packets.  It did fix some
    important issues, but it causes regressions so it gets reverted here
    too.  Specifically, the problem with this change is that the IPV6
    output path really depends upon there being a valid skb->sk
    attached.

    The reason we want to do this change in some form when we figure out
    how to do it right, is that if a device goes down the ndisc_sk
    socket send queue will fill up and block NDISC packets that we want
    to send to other devices too.  That's really bad behavior.

    Hopefully Thomas can come up with a better version of this change.

 2) Fix a severe TCP performance regression by reverting a change made
    to dev_pick_tx() quite some time ago.  From Eric Dumazet.

 3) TIPC returns wrongly signed error codes, fix from Erik Hugne.

 4) Fix OOPS when doing IPSEC over ipv4 tunnels due to orphaning the
    skb->sk too early.  Fix from Li Hongjun.

 5) RAW ipv4 sockets can use the wrong routing key during lookup, from
    Chris Clark.

 6) Similar to #1 revert an older change that tried to use plain
    alloc_skb() for SYN/ACK TCP packets, this broke the netfilter owner
    mark which needs to see the skb->sk for such frames.  From Phil
    Oester.

 7) BNX2x driver bug fixes from Ariel Elior and Yuval Mintz,
    specifically in the handling of virtual functions.

 8) IPSEC path error propagations to sockets is not done properly when
    we have v4 in v6, and v6 in v4 type rules.  Fix from Hannes Frederic
    Sowa.

 9) Fix missing channel context release in mac80211, from Johannes Berg.

10) Fix network namespace handing wrt.  SCM_RIGHTS, from Andy
    Lutomirski.

11) Fix usage of bogus NAPI weight in jme, netxen, and ps3_gelic
    drivers.  From Michal Schmidt.

12) Hopefully a complete and correct fix for the genetlink dump locking
    and module reference counting.  From Pravin B Shelar.

13) sk_busy_loop() must do a cpu_relax(), from Eliezer Tamir.

14) Fix handling of timestamp offset when restoring a snapshotted TCP
    socket.  From Andrew Vagin.

* git://git.kernel.org/pub/scm/linux/kernel/git/davem/net: (44 commits)
  net: fec: fix time stamping logic after napi conversion
  net: bridge: convert MLDv2 Query MRC into msecs_to_jiffies for max_delay
  mISDN: return -EINVAL on error in dsp_control_req()
  net: revert 8728c544a9c ("net: dev_pick_tx() fix")
  Revert "ipv6: Don't depend on per socket memory for neighbour discovery messages"
  ipv4 tunnels: fix an oops when using ipip/sit with IPsec
  tipc: set sk_err correctly when connection fails
  tcp: tcp_make_synack() should use sock_wmalloc
  bridge: separate querier and query timer into IGMP/IPv4 and MLD/IPv6 ones
  ipv6: Don't depend on per socket memory for neighbour discovery messages
  ipv4: sendto/hdrincl: don't use destination address found in header
  tcp: don't apply tsoffset if rcv_tsecr is zero
  tcp: initialize rcv_tstamp for restored sockets
  net: xilinx: fix memleak
  net: usb: Add HP hs2434 device to ZLP exception table
  net: add cpu_relax to busy poll loop
  net: stmmac: fixed the pbl setting with DT
  genl: Hold reference on correct module while netlink-dump.
  genl: Fix genl dumpit() locking.
  xfrm: Fix potential null pointer dereference in xdst_queue_output
  ...

This just replaces the dentry count/lock combination with the lockref
structure that contains both a count and a spinlock, and does the
mechanical conversion to use the lockref infrastructure.

There are no semantic changes here, it's purely syntactic.  The
reference lockref implementation uses the spinlock exactly the same way
that the old dcache code did, and the bulk of this patch is just
expanding the internal "d_count" use in the dcache code to use
"d_lockref.count" instead.

This is purely preparation for the real change to make the reference
count updates be lockless during the 3.12 merge window.

[ As with the previous commit, this is a rewritten version of a concept
  originally from Waiman, so credit goes to him, blame for any errors
  goes to me.

  Waiman's patch had some semantic differences for taking advantage of
  the lockless update in dget_parent(), while this patch is
  intentionally a pure search-and-replace change with no semantic
  changes.     - Linus ]

Signed-off-by: Waiman Long <Waiman.Long@hp.com>
Signed-off-by: Linus Torvalds <torvalds@linux-foundation.org>

This introduces a new "lockref" structure that supports the concept of
lockless updates of reference counts that still honor an attached
spinlock.

NOTE! This reference implementation is not the optimized lockless
version, rather it is the fallback implementation using standard
spinlocks.  The actual optimized versions will be merged into 3.12, but
I wanted to get the infrastructure in place and document the new
interfaces.

[ Also note that this particular commit is drastically cut-down minimal
  version of the original patch by Waiman.  In order to properly credit
  the original author I'm marking Waiman as the author here, but in the
  end this patch bears little resemblance to the patch by Waiman.  So
  blame any errors on me editing things down to the point where I can
  introduce the infrastructure before the merge window for 3.12 actually
  opens.     - Linus ]

Signed-off-by: Waiman Long <Waiman.Long@hp.com>
Signed-off-by: Linus Torvalds <torvalds@linux-foundation.org>

nsproxy.pid_ns is *not* the task's pid namespace.  The name should clarify
that.

This makes it more obvious that setns on a pid namespace is weird --
it won't change the pid namespace shown in procfs.

Signed-off-by: Andy Lutomirski <luto@amacapital.net>
Reviewed-by: "Eric W. Biederman" <ebiederm@xmission.com>
Signed-off-by: David S. Miller <davem@davemloft.net>

Pull regmap fixes from Mark Brown:
 "Two changes here:

   - Fix a bug in the rbtree code which could cause it to create two
     different cache entries for the same register by adding a single
     register at a time to the cache.  This isn't awesome for
     performance but it's non-invasive which we need for this late in
     the release cycle and the I/O costs we're trying to avoid are high.

   - Add another header used in the !CONFIG_REGMAP stubs where we had
     been relying on implicit inclusion"

* tag 'regmap-v3.11-rc7' of git://git.kernel.org/pub/scm/linux/kernel/git/broonie/regmap:
  regmap: rbtree: Fix overlapping rbnodes.
  regmap: Add another missing header for !CONFIG_REGMAP stubs

Pull vfs fixes from Al Viro:
 "Assorted fixes from the last week or so"

* 'for-linus' of git://git.kernel.org/pub/scm/linux/kernel/git/viro/vfs:
  VFS: collect_mounts() should return an ERR_PTR
  bfs: iget_locked() doesn't return an ERR_PTR
  efs: iget_locked() doesn't return an ERR_PTR()
  proc: kill the extra proc_readfd_common()->dir_emit_dots()
  cope with potentially long ->d_dname() output for shmem/hugetlb

Pull SCSI fixes from James Bottomley:
 "This is a set of small bug fixes for lpfc and zfcp and a fix for a
  fairly nasty bug in sg where a process which cancels I/O completes in
  a kernel thread which would then try to write back to the now gone
  userspace and end up writing to a random kernel address instead"

* tag 'scsi-fixes' of git://git.kernel.org/pub/scm/linux/kernel/git/jejb/scsi:
  [SCSI] zfcp: remove access control tables interface (keep sysfs files)
  [SCSI] zfcp: fix schedule-inside-lock in scsi_device list loops
  [SCSI] zfcp: fix lock imbalance by reworking request queue locking
  [SCSI] sg: Fix user memory corruption when SG_IO is interrupted by a signal
  [SCSI] lpfc: Don't force CONFIG_GENERIC_CSUM on

dynamic_dname() is both too much and too little for those - the
output may be well in excess of 64 bytes dynamic_dname() assumes
to be enough (thanks to ashmem feeding really long names to
shmem_file_setup()) and vsnprintf() is an overkill for those
guys.

Signed-off-by: Al Viro <viro@zeniv.linux.org.uk>

Merge networking fixes from David Miller:

 1) Revert Johannes Berg's genetlink locking fix, because it causes
    regressions.

    Johannes and Pravin Shelar are working on fixing things properly.

 2) Do not drop ipv6 ICMP messages without a redirected header option,
    they are legal.  From Duan Jiong.

 3) Missing error return propagation in probing of via-ircc driver.
    From Alexey Khoroshilov.

 4) Do not clear out broadcast/multicast/unicast/WOL bits in r8169 when
    initializing, from Peter Wu.

 5) realtek phy driver programs wrong interrupt status bit, from
    Giuseppe CAVALLARO.

 6) Fix statistics regression in AF_PACKET code, from Willem de Bruijn.

 7) Bridge code uses wrong bitmap length, from Toshiaki Makita.

 8) SFC driver uses wrong indexes to look up MAC filters, from Ben
    Hutchings.

 9) Don't pass stack buffers into usb control operations in hso driver,
    from Daniel Gimpelevich.

10) Multiple ipv6 fragmentation headers in one packet is illegal and
    such packets should be dropped, from Hannes Frederic Sowa.

11) When TCP sockets are "repaired" as part of checkpoint/restart, the
    timestamp field of SKBs need to be refreshed otherwise RTOs can be
    wildly off.  From Andrey Vagin.

12) Fix memcpy args (uses 'address of pointer' instead of 'pointer') in
    hostp driver.  From Dan Carpenter.

13) nl80211hdr_put() doesn't return an ERR_PTR, but some code believes
    it does.  From Dan Carpenter.

14) Fix regression in wireless SME disconnects, from Johannes Berg.

15) Don't use a stack buffer for DMA in zd1201 USB wireless driver, from
    Jussi Kivilinna.

* git://git.kernel.org/pub/scm/linux/kernel/git/davem/net: (33 commits)
  ipv4: expose IPV4_DEVCONF
  ipv6: handle Redirect ICMP Message with no Redirected Header option
  be2net: fix disabling TX in be_close()
  Revert "genetlink: fix family dump race"
  hso: Fix stack corruption on some architectures
  hso: Earlier catch of error condition
  sfc: Fix lookup of default RX MAC filters when steered using ethtool
  bridge: Use the correct bit length for bitmap functions in the VLAN code
  packet: restore packet statistics tp_packets to include drops
  net: phy: rtl8211: fix interrupt on status link change
  r8169: remember WOL preferences on driver load
  via-ircc: don't return zero if via_ircc_open() failed
  macvtap: Ignore tap features when VNET_HDR is off
  macvtap: Correctly set tap features when IFF_VNET_HDR is disabled.
  macvtap: simplify usage of tap_features
  tcp: set timestamps for restored skb-s
  bnx2x: set VF DMAE when first function has 0 supported VFs
  bnx2x: Protect against VFs' ndos when SR-IOV is disabled
  bnx2x: prevent VF benign attentions
  bnx2x: Consider DCBX remote error
  ...

IP sends device configuration (see inet_fill_link_af) as an array
in the netlink information, but the indices in that array are not
exposed to userspace through any current santized header file.

It was available back in 2.6.32 (in /usr/include/linux/sysctl.h)
but was broken by:
  commit 02291680ffba92e5b5865bc0c5e7d1f3056b80ec
  Author: Eric W. Biederman <ebiederm@xmission.com>
  Date:   Sun Feb 14 03:25:51 2010 +0000

    net ipv4: Decouple ipv4 interface parameters from binary sysctl numbers

Eric was solving the sysctl problem but then the indices were re-exposed
by a later addition of devconf support for IPV4

  commit 9f0f7272ac9506f4c8c05cc597b7e376b0b9f3e4
  Author: Thomas Graf <tgraf@infradead.org>
  Date:   Tue Nov 16 04:32:48 2010 +0000

    ipv4: AF_INET link address family

Putting them in /usr/include/linux/ip.h seemed the logical match
for the DEVCONF_ definitions for IPV6 in /usr/include/linux/ip6.h

Signed-off-by: Stephen Hemminger <stephen@networkplumber.org>
Signed-off-by: David S. Miller <davem@davemloft.net>