Pull arm-soc clock driver changes from Olof Johansson:
 "The new clock subsystem was merged in linux-3.4 without any users,
  this now moves the first three platforms over to it: imx, mxs and
  spear.

  The series also contains the changes for the clock subsystem itself,
  since Mike preferred to have it together with the platforms that
  require these changes, in order to avoid interdependencies and
  conflicts."

Fix up trivial conflicts in arch/arm/mach-kirkwood/common.c (code
removed in one branch, added OF support in another) and
drivers/dma/imx-sdma.c (independent changes next to each other).

* tag 'clock' of git://git.kernel.org/pub/scm/linux/kernel/git/arm/arm-soc: (97 commits)
  clk: Fix CLK_SET_RATE_GATE flag validation in clk_set_rate().
  clk: Provide dummy clk_unregister()
  SPEAr: Update defconfigs
  SPEAr: Add SMI NOR partition info in dts files
  SPEAr: Switch to common clock framework
  SPEAr: Call clk_prepare() before calling clk_enable
  SPEAr: clk: Add General Purpose Timer Synthesizer clock
  SPEAr: clk: Add Fractional Synthesizer clock
  SPEAr: clk: Add Auxiliary Synthesizer clock
  SPEAr: clk: Add VCO-PLL Synthesizer clock
  SPEAr: Add DT bindings for SPEAr's timer
  ARM i.MX: remove now unused clock files
  ARM: i.MX6: implement clocks using common clock framework
  ARM i.MX35: implement clocks using common clock framework
  ARM i.MX5: implement clocks using common clock framework
  ARM: Kirkwood: Replace clock gating
  ARM: Orion: Audio: Add clk/clkdev support
  ARM: Orion: PCIE: Add support for clk
  ARM: Orion: XOR: Add support for clk
  ARM: Orion: CESA: Add support for clk
  ...

Pull SPI changes from Grant Likely:
 "Bug fixes and new features for SPI device drivers.  Also move device
  tree support code out of drivers/of and into drivers/spi/spi.c where
  it makes more sense."

* tag 'spi-for-linus' of git://git.secretlab.ca/git/linux-2.6:
  spi: By default setup spi_masters with 1 chipselect and dynamics bus number
  SPI: PRIMA2: use the newest APIs of PINCTRL to fix compiling errors
  spi/spi-fsl-spi: reference correct pdata in fsl_spi_cs_control
  spi: refactor spi-coldfire-qspi to use SPI queue framework.
  spi/omap2-mcspi: convert to the pump message infrastructure
  spi/rspi: add dmaengine support
  spi/topcliff: use correct __devexit_p annotation
  spi: Dont call prepare/unprepare transfer if not populated
  spi/ep93xx: clean probe/remove routines
  spi/devicetree: Move devicetree support code into spi directory
  spi: use module_pci_driver
  spi/omap2-mcspi: Trivial optimisation
  spi: omap2-mcspi: add support for pm_runtime autosuspend
  spi/omap: Remove bus_num usage for instance index
  OMAP : SPI : use devm_* functions
  spi: omap2-mcspi: convert to module_platform_driver
  spi: omap2-mcspi: make it behave as a module

Pull Char/Misc patches from Greg Kroah-Hartman:
 "Here are a few various char/misc tree patches for the 3.5-rc1 merge
  window.

  Nothing major here at all, just different driver updates and some
  parport dead code removal.

  Signed-off-by: Greg Kroah-Hartman <gregkh@linuxfoundation.org>"

* tag 'char-misc-3.5-rc1' of git://git.kernel.org/pub/scm/linux/kernel/git/gregkh/char-misc:
  parport: remove unused dead code from lowlevel drivers
  xilinx_hwicap: reset XHI_MAX_RETRIES
  xilinx_hwicap: add support for virtex6 FPGAs
  Support M95040 SPI EEPROM
  misc: add support for bmp18x chips to the bmp085 driver
  misc: bmp085: add device tree properties
  misc: clean up bmp085 driver
  misc: do not mark exported functions __devexit
  misc: add missing __devexit_p() annotations
  pch_phub: delete duplicate definitions
  misc: Fix irq leak in max8997_muic_probe error path

This patch adds dmaengine supporting using sh_dma driver. The module
receives data by DMAC, it also needs TX DMAC to generate SPI's clocks.

Signed-off-by: Yoshihiro Shimoda <yoshihiro.shimoda.uh@renesas.com>
Signed-off-by: Grant Likely <grant.likely@secretlab.ca>

* 'clk-next' of git://git.linaro.org/people/mturquette/linux:
  clk: Fix CLK_SET_RATE_GATE flag validation in clk_set_rate().
  clk: Provide dummy clk_unregister()
  ARM: Kirkwood: Replace clock gating
  ARM: Orion: Audio: Add clk/clkdev support
  ARM: Orion: PCIE: Add support for clk
  ARM: Orion: XOR: Add support for clk
  ARM: Orion: CESA: Add support for clk
  ARM: Orion: SDIO: Add support for clk.
  ARM: Orion: NAND: Add support for clk, if there is one.
  ARM: Orion: EHCI: Add support for enabling clocks
  ARM: Orion: SATA: Add per channel clk/clkdev support.
  ARM: Orion: UART: Get the clock rate via clk_get_rate().
  ARM: Orion: WDT: Add clk/clkdev support
  ARM: Orion: Eth: Add clk/clkdev support.
  ARM: Orion: SPI: Add clk/clkdev support.
  ARM: Orion: Add clocks using the generic clk infrastructure.

Signed-off-by: Arnd Bergmann <arnd@arndb.de>

Remove now redundant tclk from SPI platform data. This makes the platform
data empty, so remove it.

Signed-off-by: Andrew Lunn <andrew@lunn.ch>
Tested-by: Jamie Lentin <jm@lentin.co.uk>
Signed-off-by: Mike Turquette <mturquette@linaro.org>

Fix kernel-doc warning in spi.h (copy/paste):

Warning(include/linux/spi/spi.h:365): No description found for parameter 'unprepare_transfer_hardware'

Signed-off-by: Randy Dunlap <rdunlap@xenotime.net>
Signed-off-by: Grant Likely <grant.likely@secretlab.ca>

Updated the generic SPI EEPROM driver AT25 for support of an additional address
bit in the instruction byte. Certain EEPROMS have a size that is larger than the
number of address bytes would allow (e.g. like M95040 from ST that has 512 Byte
size but uses only one address byte (A0 to A7) for addressing.) For the extra
address bit (A8, A16 or A24) bit 3 of the instruction byte is used. This
instruction bit is normally defined as don't care for other AT25 like chips.

Reviewed-by: Wolfram Sang <w.sang@pengutronix.de>
Signed-off-by: Ivo Sieben <meltedpianoman@gmail.com>
Acked-by: Chris Wright <chrisw@sous-sol.org>
Signed-off-by: Greg Kroah-Hartman <gregkh@linuxfoundation.org>

Pull "ARM: More device tree support updates" from Olof Johansson:
 "This branch contains a number of updates for device tree support on
  several ARM platforms, in particular:

   * AT91 continues the device tree conversion adding support for a
     number of on-chip drivers and other functionality
   * ux500 adds probing of some of the core SoC blocks through device
     tree
   * Initial device tree support for ST SPEAr600 platforms
   * kirkwood continues the conversion to device-tree probing"

Manually merge arch/arm/mach-ux500/Kconfig due to MACH_U8500 rename, and
drivers/usb/gadget/at91_udc.c due to header file include cleanups.

Also do an "evil merge" for the MACH_U8500 config option rename that the
affected RMI4 touchscreen driver in staging.  It's called MACH_MOP500
now, and it was missed during previous merges.

* tag 'dt2' of git://git.kernel.org/pub/scm/linux/kernel/git/arm/arm-soc: (48 commits)
  ARM: SPEAr600: Add device-tree support to SPEAr600 boards
  ARM: ux500: Provide local timer support for Device Tree
  ARM: ux500: Enable PL022 SSP Controller in Device Tree
  ARM: ux500: Enable PL310 Level 2 Cache Controller in Device Tree
  ARM: ux500: Enable PL011 AMBA UART Controller for Device Tree
  ARM: ux500: Enable Cortex-A9 GIC (Generic Interrupt Controller) in Device Tree
  ARM: ux500: db8500: list most devices in the snowball device tree
  ARM: ux500: split dts file for snowball into generic part
  ARM: ux500: combine the board init functions for DT boot
  ARM: ux500: Initial Device Tree support for Snowball
  ARM: ux500: CONFIG: Enable Device Tree support for future endeavours
  ARM: kirkwood: use devicetree for rtc-mv
  ARM: kirkwood: rtc-mv devicetree bindings
  ARM: kirkwood: fdt: define uart[01] as disabled, enable uart0
  ARM: kirkwood: fdt: facilitate new boards during fdt migration
  ARM: kirkwood: fdt: absorb kirkwood_init()
  ARM: kirkwood: fdt: use mrvl ticker symbol
  ARM: orion: wdt: use resource vice direct access
  ARM: Kirkwood: Remove tclk from kirkwood_asoc_platform_data.
  ARM: orion: spi: remove enable_clock_fix which is not used
  ...

Pull "ARM: global cleanups" from Arnd Bergmann:
 "Quite a bit of code gets removed, and some stuff moved around, mostly
  the old samsung s3c24xx stuff.  There should be no functional changes
  in this series otherwise.  Some cleanups have dependencies on other
  arm-soc branches and will be sent in the second round.

  Signed-off-by: Arnd Bergmann <arnd@arndb.de>"

Fixed up trivial conflicts mainly due to #include's being changes on
both sides.

* tag 'cleanup' of git://git.kernel.org/pub/scm/linux/kernel/git/arm/arm-soc: (121 commits)
  ep93xx: Remove unnecessary includes of ep93xx-regs.h
  ep93xx: Move EP93XX_SYSCON defines to SoC private header
  ep93xx: Move crunch code to mach-ep93xx directory
  ep93xx: Make syscon access functions private to SoC
  ep93xx: Configure GPIO ports in core code
  ep93xx: Move peripheral defines to local SoC header
  ep93xx: Convert the watchdog driver into a platform device.
  ep93xx: Use ioremap for backlight driver
  ep93xx: Move GPIO defines to gpio-ep93xx.h
  ep93xx: Don't use system controller defines in audio drivers
  ep93xx: Move PHYS_BASE defines to local SoC header file
  ARM: EXYNOS: Add clock register addresses for EXYNOS4X12 bus devfreq driver
  ARM: EXYNOS: add clock registers for exynos4x12-cpufreq
  PM / devfreq: update the name of EXYNOS clock registers that were omitted
  PM / devfreq: update the name of EXYNOS clock register
  ARM: EXYNOS: change the prefix S5P_ to EXYNOS4_ for clock
  ARM: EXYNOS: use static declaration on regarding clock
  ARM: EXYNOS: replace clock.c for other new EXYNOS SoCs
  ARM: OMAP2+: Fix build error after merge
  ARM: S3C24XX: remove call to s3c24xx_setup_clocks
  ...