Pull MMC updates from Ulf Hansson:
 "This time, this pull request contains changes crossing subsystems and
  archs/platforms, which is mainly because of a bigger modernization of
  moving from legacy GPIO to GPIO descriptors for MMC (by Linus
  Walleij).

  Additionally, once again, I am funneling changes to
  drivers/misc/cardreader/* and drivers/memstick/* through my MMC tree,
  mostly due to that we lack a maintainer for these.

  Summary:

  MMC core:
   - Cleanup BKOPS support
   - Introduce MMC_CAP_SYNC_RUNTIME_PM
   - slot-gpio: Delete legacy slot GPIO handling

  MMC host:
   - alcor: Add new mmc host driver for Alcor Micro PCI based cardreader
   - bcm2835: Several improvements to better recover from errors
   - jz4740: Rework and fixup pre|post_req support
   - mediatek: Add support for SDIO IRQs
   - meson-gx: Improve clock phase management
   - meson-gx: Stop descriptor on errors
   - mmci: Complete the sbc error path by sending a stop command
   - renesas_sdhi/tmio: Fixup reset/resume operations
   - renesas_sdhi: Add support for r8a774c0 and R7S9210
   - renesas_sdhi: Whitelist R8A77990 SDHI
   - renesas_sdhi: Fixup eMMC HS400 compatibility issues for H3 and M3-W
   - rtsx_usb_sdmmc: Re-work card detection/removal support
   - rtsx_usb_sdmmc: Re-work runtime PM support
   - sdhci: Fix timeout loops for some variant drivers
   - sdhci: Improve support for error handling due to failing commands
   - sdhci-acpi/pci: Disable LED control for Intel BYT-based controllers
   - sdhci_am654: Add new SDHCI variant driver to support TI's AM654 SOCs
   - sdhci-of-esdhc: Add support for eMMC HS400 mode
   - sdhci-omap: Fixup reset support
   - sdhci-omap: Workaround errata regarding SDR104/HS200 tuning failures
   - sdhci-msm: Fixup sporadic write transfers issues for SDR104/HS200
   - sdhci-msm: Fixup dynamical clock gating issues
   - various: Complete converting all hosts into using slot GPIO descriptors

  Other:
   - Move GPIO mmc platform data for mips/sh/arm to GPIO descriptors
   - Add new Alcor Micro cardreader PCI driver
   - Support runtime power management for memstick rtsx_usb_ms driver
   - Use USB remote wakeups for card detection for rtsx_usb misc driver"

* tag 'mmc-v4.21' of git://git.kernel.org/pub/scm/linux/kernel/git/ulfh/mmc: (99 commits)
  mmc: mediatek: Add MMC_CAP_SDIO_IRQ support
  mmc: renesas_sdhi_internal_dmac: Whitelist r8a774c0
  dt-bindings: mmc: renesas_sdhi: Add r8a774c0 support
  mmc: core: Cleanup BKOPS support
  mmc: core: Drop redundant check in mmc_send_hpi_cmd()
  mmc: sdhci-omap: Workaround errata regarding SDR104/HS200 tuning failures (i929)
  dt-bindings: sdhci-omap: Add note for cpu_thermal
  mmc: sdhci-acpi: Disable LED control for Intel BYT-based controllers
  mmc: sdhci-pci: Disable LED control for Intel BYT-based controllers
  mmc: sdhci: Add quirk to disable LED control
  mmc: mmci: add variant property to set command stop bit
  misc: alcor_pci: fix spelling mistake "invailid" -> "invalid"
  mmc: meson-gx: add signal resampling
  mmc: meson-gx: align default phase on soc vendor tree
  mmc: meson-gx: remove useless lock
  mmc: meson-gx: make sure the descriptor is stopped on errors
  mmc: sdhci_am654: Add Initial Support for AM654 SDHCI driver
  dt-bindings: mmc: sdhci-of-arasan: Add deprecated message for AM65
  dt-bindings: mmc: sdhci-am654: Document bindings for the host controllers on TI's AM654 SOCs
  mmc: sdhci-msm: avoid unused function warning
  ...

To allow mmc host drivers to inform the mmc core about rather using
pm_runtime_put_sync_suspend() instead of pm_runtime_put_autosuspend(),
let's introduce MMC_CAP_SYNC_RUNTIME_PM.

This is especially useful for those mmc host drivers that don't benefit
from using the runtime PM autosuspend feature. Typically this is those that
relies on parent devices to power the card via runtime PM, like some USB
host drivers for example.

Signed-off-by: Ulf Hansson <ulf.hansson@linaro.org>
Tested-by: Kai-Heng Feng <kai.heng.feng@canonical.com>
Tested-by: Oleksandr Natalenko <oleksandr@natalenko.name>

All host drivers are converted to look up GPIO descriptors
from device tree, ACPI or machine descriptor tables, so now
we can delete the legacy GPIO handling using hardcoded GPIO
numbers from the kernel.

Signed-off-by: Linus Walleij <linus.walleij@linaro.org>
Signed-off-by: Ulf Hansson <ulf.hansson@linaro.org>

Some eMMC controllers need specific settings for HS400 mode before the
speed mode can be switched to DDR mode, during the HS400 initialization
sequence. For that reason, let's introduce a new host callback,
->hs400_prepare_ddr() and invoked it just before switching to DDR mode.

Signed-off-by: Yinbo Zhu <yinbo.zhu@nxp.com>
Signed-off-by: Ulf Hansson <ulf.hansson@linaro.org>

CYW43012 is a 1x1 802.11a/b/g/n Dual-Band HT20, 256-QAM/Turbo QAM. It
is an Ultra Low Power WLAN+BT combo chip.

Reviewed-by: Arend van Spriel <arend.vanspriel@broadcom.com>
Signed-off-by: Chi-Hsien Lin <chi-hsien.lin@cypress.com>
Signed-off-by: Praveen Babu C <praveen.chandran@cypress.com>
Signed-off-by: Kalle Valo <kvalo@codeaurora.org>

Add a helper to allow host drivers checking if a retune is in progress.

Signed-off-by: Niklas Söderlund <niklas.soderlund+renesas@ragnatech.se>
Reviewed-by: Wolfram Sang <wsa+renesas@sang-engineering.com>
Tested-by: Wolfram Sang <wsa+renesas@sang-engineering.com>
Signed-off-by: Ulf Hansson <ulf.hansson@linaro.org>

The last user of mmc_power_save|restore_host() APIs is gone, hence let's
drop them. Drop also the corresponding bus_ops callback,
->power_save|restore() as those becomes redundant.

Cc: Tony Lindgren <tony@atomide.com>
Cc: Eyal Reizer <eyalreizer@gmail.com>
Signed-off-by: Ulf Hansson <ulf.hansson@linaro.org>

This adds two new HS400 tuning operations:
* hs400_downgrade
* hs400_complete

These supplement the existing HS400 operation:
* prepare_hs400_tuning

This is motivated by a requirement of Renesas SDHI for the following:
1. Disabling SCC before selecting to HS if selection of HS400 has occurred.
   This can be done in an implementation of prepare_hs400_tuning_downgrade
2. Updating registers after switching to HS400
   This can be done in an implementation of complete_hs400_tuning

If hs400_downgrade or hs400_complete are not implemented then they are not
called. Thus means there should be no affect for existing drivers as none
implemt these ops.

Signed-off-by: Simon Horman <horms+renesas@verge.net.au>
Signed-off-by: Ulf Hansson <ulf.hansson@linaro.org>

R1_STATUS(x) now is only used by ioctl_rpmb_card_status_poll(),
which checks all bits as possible. But according to the spec,
bit 17 and bit 18 should be ignored, as well bit 14 which is
reserved(must be set to 0) quoting from the spec and these rule
apply to all places checking the device status. So change
its checking from 0xFFFFE000 to 0xFFF9A000.

As a bonus, we reuse it for mmc_do_erase() as well as
mmc_switch_status_error().
(1) Currently mmc_switch_status_error() doesn't check bit 25, but
it means device is locked but not unlocked by CMD42 prior to any
operations which need check busy, which is also not allowed.
(2) mmc_do_erase() also forgot to to check bit 15, WP_ERASE_SKIP.
The spec says "Only partial address space was erased due to existing
write protected blocks.", which obviously means we should fail this I/O.
Otherwise, the partial erased data stored in nonvalatile flash violates
the data integrity from the view of I/O owner, which probably confuse
it when further used.

So reusing R1_STATUS for them not only improve the readability but also
slove real problems.

Signed-off-by: Shawn Lin <shawn.lin@rock-chips.com>
Signed-off-by: Ulf Hansson <ulf.hansson@linaro.org>

Pull networking updates from David Miller:

 1) Add Maglev hashing scheduler to IPVS, from Inju Song.

 2) Lots of new TC subsystem tests from Roman Mashak.

 3) Add TCP zero copy receive and fix delayed acks and autotuning with
    SO_RCVLOWAT, from Eric Dumazet.

 4) Add XDP_REDIRECT support to mlx5 driver, from Jesper Dangaard
    Brouer.

 5) Add ttl inherit support to vxlan, from Hangbin Liu.

 6) Properly separate ipv6 routes into their logically independant
    components. fib6_info for the routing table, and fib6_nh for sets of
    nexthops, which thus can be shared. From David Ahern.

 7) Add bpf_xdp_adjust_tail helper, which can be used to generate ICMP
    messages from XDP programs. From Nikita V. Shirokov.

 8) Lots of long overdue cleanups to the r8169 driver, from Heiner
    Kallweit.

 9) Add BTF ("BPF Type Format"), from Martin KaFai Lau.

10) Add traffic condition monitoring to iwlwifi, from Luca Coelho.

11) Plumb extack down into fib_rules, from Roopa Prabhu.

12) Add Flower classifier offload support to igb, from Vinicius Costa
    Gomes.

13) Add UDP GSO support, from Willem de Bruijn.

14) Add documentation for eBPF helpers, from Quentin Monnet.

15) Add TLS tx offload to mlx5, from Ilya Lesokhin.

16) Allow applications to be given the number of bytes available to read
    on a socket via a control message returned from recvmsg(), from
    Soheil Hassas Yeganeh.

17) Add x86_32 eBPF JIT compiler, from Wang YanQing.

18) Add AF_XDP sockets, with zerocopy support infrastructure as well.
    From Björn Töpel.

19) Remove indirect load support from all of the BPF JITs and handle
    these operations in the verifier by translating them into native BPF
    instead. From Daniel Borkmann.

20) Add GRO support to ipv6 gre tunnels, from Eran Ben Elisha.

21) Allow XDP programs to do lookups in the main kernel routing tables
    for forwarding. From David Ahern.

22) Allow drivers to store hardware state into an ELF section of kernel
    dump vmcore files, and use it in cxgb4. From Rahul Lakkireddy.

23) Various RACK and loss detection improvements in TCP, from Yuchung
    Cheng.

24) Add TCP SACK compression, from Eric Dumazet.

25) Add User Mode Helper support and basic bpfilter infrastructure, from
    Alexei Starovoitov.

26) Support ports and protocol values in RTM_GETROUTE, from Roopa
    Prabhu.

27) Support bulking in ->ndo_xdp_xmit() API, from Jesper Dangaard
    Brouer.

28) Add lots of forwarding selftests, from Petr Machata.

29) Add generic network device failover driver, from Sridhar Samudrala.

* ra.kernel.org:/pub/scm/linux/kernel/git/davem/net-next: (1959 commits)
  strparser: Add __strp_unpause and use it in ktls.
  rxrpc: Fix terminal retransmission connection ID to include the channel
  net: hns3: Optimize PF CMDQ interrupt switching process
  net: hns3: Fix for VF mailbox receiving unknown message
  net: hns3: Fix for VF mailbox cannot receiving PF response
  bnx2x: use the right constant
  Revert "net: sched: cls: Fix offloading when ingress dev is vxlan"
  net: dsa: b53: Fix for brcm tag issue in Cygnus SoC
  enic: fix UDP rss bits
  netdev-FAQ: clarify DaveM's position for stable backports
  rtnetlink: validate attributes in do_setlink()
  mlxsw: Add extack messages for port_{un, }split failures
  netdevsim: Add extack error message for devlink reload
  devlink: Add extack to reload and port_{un, }split operations
  net: metrics: add proper netlink validation
  ipmr: fix error path when ipmr_new_table fails
  ip6mr: only set ip6mr_table from setsockopt when ip6mr_new_table succeeds
  net: hns3: remove unused hclgevf_cfg_func_mta_filter
  netfilter: provide udp*_lib_lookup for nf_tproxy
  qed*: Utilize FW 8.37.2.0
  ...