linux.git/include/asm-powerpc/eeh.h, branch master

powerpc: Move include files to arch/powerpc/include/asm

2008-08-04T02:02:00+00:00

from include/asm-powerpc.  This is the result of a

mkdir arch/powerpc/include/asm
git mv include/asm-powerpc/* arch/powerpc/include/asm

Followed by a few documentation/comment fixups and a couple of places
where  was being used explicitly.  Of the latter only
one was outside the arch code and it is a driver only built for powerpc.

Signed-off-by: Stephen Rothwell 
Signed-off-by: Paul Mackerras

[POWERPC] Merge 32 and 64 bits asm-powerpc/io.h

2006-12-04T09:39:05+00:00

powerpc: Merge 32 and 64 bits asm-powerpc/io.h

The rework on io.h done for the new hookable accessors made it easier,
so I just finished the work and merged 32 and 64 bits io.h for arch/powerpc.

arch/ppc still uses the old version in asm-ppc, there is just too much gunk
in there that I really can't be bothered trying to cleanup.

Signed-off-by: Benjamin Herrenschmidt 
Signed-off-by: Paul Mackerras

[POWERPC] Allow hooking of PCI MMIO & PIO accessors on 64 bits

2006-12-04T09:38:52+00:00

This patch reworks the way iSeries hooks on PCI IO operations (both MMIO
and PIO) and provides a generic way for other platforms to do so (we
have need to do that for various other platforms).

While reworking the IO ops, I ended up doing some spring cleaning in
io.h and eeh.h which I might want to split into 2 or 3 patches (among
others, eeh.h had a lot of useless stuff in it).

A side effect is that EEH for PIO should work now (it used to pass IO
ports down to the eeh address check functions which is bogus).

Also, new are MMIO "repeat" ops, which other archs like ARM already had,
and that we have too now: readsb, readsw, readsl, writesb, writesw,
writesl.

In the long run, I might also make EEH use the hooks instead
of wrapping at the toplevel, which would make things even cleaner and
relegate EEH completely in platforms/iseries, but we have to measure the
performance impact there (though it's really only on MMIO reads)

Since I also need to hook on ioremap, I shuffled the functions a bit
there. I introduced ioremap_flags() to use by drivers who want to pass
explicit flags to ioremap (and it can be hooked). The old __ioremap() is
still there as a low level and cannot be hooked, thus drivers who use it
should migrate unless they know they want the low level version.

The patch "arch provides generic iomap missing accessors" (should be
number 4 in this series) is a pre-requisite to provide full iomap
API support with this patch.

Signed-off-by: Benjamin Herrenschmidt 
Signed-off-by: Paul Mackerras

[POWERPC] Fix MMIO ops to provide expected barrier behaviour

2006-09-13T12:08:26+00:00

This changes the writeX family of functions to have a sync instruction
before the MMIO store rather than after, because the generally expected
behaviour is that the device receiving the MMIO store can be guaranteed
to see the effects of any preceding writes to normal memory.

To preserve ordering between writeX and readX, and to preserve ordering
between preceding stores and the readX, the readX family of functions
have had an sync added before the load.

Although writeX followed by spin_unlock is not officially guaranteed
to keep the writeX inside the spin-locked region unless an mmiowb()
is used, there are currently drivers that depend on the previous
behaviour on powerpc, which was that the mmiowb wasn't actually required.
Therefore we have a per-cpu flag that is set by writeX, cleared by
__raw_spin_lock and mmiowb, and tested by __raw_spin_unlock.  If it is
set, __raw_spin_unlock does a sync and clears it.

This changes both 32-bit and 64-bit readX/writeX.  32-bit already has a
sync in __raw_spin_unlock (since lwsync doesn't exist on 32-bit), and thus
doesn't need the per-cpu flag.

Tested on G5 (PPC970) and POWER5.

Signed-off-by: Paul Mackerras

Merge git://git.kernel.org/pub/scm/linux/kernel/git/paulus/powerpc

2006-06-23T05:11:30+00:00

* git://git.kernel.org/pub/scm/linux/kernel/git/paulus/powerpc: (139 commits)
  [POWERPC] re-enable OProfile for iSeries, using timer interrupt
  [POWERPC] support ibm,extended-*-frequency properties
  [POWERPC] Extra sanity check in EEH code
  [POWERPC] Dont look for class-code in pci children
  [POWERPC] Fix mdelay badness on shared processor partitions
  [POWERPC] disable floating point exceptions for init
  [POWERPC] Unify ppc syscall tables
  [POWERPC] mpic: add support for serial mode interrupts
  [POWERPC] pseries: Print PCI slot location code on failure
  [POWERPC] spufs: one more fix for 64k pages
  [POWERPC] spufs: fail spu_create with invalid flags
  [POWERPC] spufs: clear class2 interrupt status before wakeup
  [POWERPC] spufs: fix Makefile for "make clean"
  [POWERPC] spufs: remove stop_code from struct spu
  [POWERPC] spufs: fix spu irq affinity setting
  [POWERPC] spufs: further abstract priv1 register access
  [POWERPC] spufs: split the Cell BE support into generic and platform dependant parts
  [POWERPC] spufs: dont try to access SPE channel 1 count
  [POWERPC] spufs: use kzalloc in create_spu
  [POWERPC] spufs: fix initial state of wbox file
  ...

Manually resolved conflicts in:
	drivers/net/phy/Makefile
	include/asm-powerpc/spu.h

Don't include linux/config.h from anywhere else in include/

2006-04-26T11:56:16+00:00

Signed-off-by: David Woodhouse

[PATCH] powerpc: remove io_page_mask

2006-04-22T08:45:05+00:00

Cleanup patch which removes the io_page_mask.  It fixes the reset on
some e1000 devices which is needed for clean kexec reboots.  The legacy
devices which broke with this patch (parallel port and PC speaker) have
now been fixed in Linus' tree.

Signed-off-by: Anton Blanchard 
Acked-by: Michael Neuling 
Signed-off-by: Paul Mackerras

[PATCH] powerpc/pseries: EEH Cleanup

2006-04-01T11:37:11+00:00

This patch removes unnecessary exports, marks functions as static when
possible, and simplifies some list-related code.

Signed-off-by: Nathan Fontenot 
Signed-off-by: Linas Vepstas 
Signed-off-by: Paul Mackerras

[PATCH] powerpc: restore eeh_add_device_late() prototype stub

2006-03-08T22:14:00+00:00

We fixed this:

arch/powerpc/platforms/pseries/eeh.c: In function `eeh_add_device_tree_late':
arch/powerpc/platforms/pseries/eeh.c:901: warning: implicit declaration of function `eeh_add_device_late'
arch/powerpc/platforms/pseries/eeh.c: At top level:
arch/powerpc/platforms/pseries/eeh.c:918: error: conflicting types for 'eeh_add_device_late'
arch/powerpc/platforms/pseries/eeh.c:901: error: previous implicit declaration of 'eeh_add_device_late' was here
make[2]: *** [arch/powerpc/platforms/pseries/eeh.o] Error 1

But we forgot the !CONFIG_EEH stub.

Signed-off-by: Mark Fasheh 
Cc: Paul Mackerras 
Signed-off-by: Andrew Morton 
Signed-off-by: Linus Torvalds

[PATCH] fix build breakage in eeh.c in 2.6.16-rc5-git5

2006-03-01T21:53:02+00:00

This patch should fixe a problem with eeh_add_device_late() not being
defined in the ppc64 build process, causing the build to break.

Signed-off-by: Greg Kroah-Hartman 
Signed-off-by: Linus Torvalds