Pull phy fixes from Vinod Koul:

 - mapphone-mdm6600 runtime pm & pinctrl handling fixes

 - Qualcomm qmp usb pcs register fixes, qmp pcie register size warning
   fix, m31 fixes for wrong pointer in PTR_ERR and dropping wrong vreg
   check, qmp combo fix for 8550 power config register

 - realtek usb fix for debugfs_create_dir() and kconfig dependency

* tag 'phy-fixes-6.6' of git://git.kernel.org/pub/scm/linux/kernel/git/phy/linux-phy:
  phy: realtek: Realtek PHYs should depend on ARCH_REALTEK
  phy: qualcomm: Fix typos in comments
  phy: qcom-qmp-combo: initialize PCS_USB registers
  phy: qcom-qmp-combo: Square out 8550 POWER_STATE_CONFIG1
  phy: qcom: m31: Remove unwanted qphy->vreg is NULL check
  phy: realtek: usb: Drop unnecessary error check for debugfs_create_dir()
  phy: qcom: phy-qcom-m31: change m31_ipq5332_regs to static
  phy: qcom: phy-qcom-m31: fix wrong pointer pass to PTR_ERR()
  dt-bindings: phy: qcom,ipq8074-qmp-pcie: fix warning regarding reg size
  phy: qcom-qmp-usb: split PCS_USB init table for sc8280xp and sa8775p
  phy: qcom-qmp-usb: initialize PCS_USB registers
  phy: mapphone-mdm6600: Fix pinctrl_pm handling for sleep pins
  phy: mapphone-mdm6600: Fix runtime PM for remove
  phy: mapphone-mdm6600: Fix runtime disable on probe

Pull EFI fixes from Ard Biesheuvel:
 "The boot_params pointer fix uses a somewhat ugly extern struct
  declaration but this will be cleaned up the next cycle.

   - don't try to print warnings to the console when it is no longer
     available

   - fix theoretical memory leak in SSDT override handling

   - make sure that the boot_params global variable is set before the
     KASLR code attempts to hash it for 'randomness'

   - avoid soft lockups in the memory acceptance code"

* tag 'efi-fixes-for-v6.6-3' of git://git.kernel.org/pub/scm/linux/kernel/git/efi/efi:
  efi/unaccepted: Fix soft lockups caused by parallel memory acceptance
  x86/boot: efistub: Assign global boot_params variable
  efi: fix memory leak in krealloc failure handling
  x86/efistub: Don't try to print after ExitBootService()

Pull gpio fixes from Bartosz Golaszewski:

 - fix interrupt handling in suspend and wakeup in gpio-vf610

 - fix a bug on setting direction to output in gpio-vf610

 - add a missing memset() in gpio ACPI code

* tag 'gpio-fixes-for-v6.6-rc7' of git://git.kernel.org/pub/scm/linux/kernel/git/brgl/linux:
  gpiolib: acpi: Add missing memset(0) to acpi_get_gpiod_from_data()
  gpio: vf610: set value before the direction to avoid a glitch
  gpio: vf610: mask the gpio irq in system suspend and support wakeup

Pull s390 fixes from Vasily Gorbik:

 - Fix IOMMU bitmap allocation in s390 PCI to avoid out of bounds access
   when IOMMU pages aren't a multiple of 64

 - Fix kasan crashes when accessing DCSS mapping in memory holes by
   adding corresponding kasan zero shadow mappings

 - Fix a memory leak in css_alloc_subchannel in case
   dma_set_coherent_mask fails

* tag 's390-6.6-4' of git://git.kernel.org/pub/scm/linux/kernel/git/s390/linux:
  s390/pci: fix iommu bitmap allocation
  s390/kasan: handle DCSS mapping in memory holes
  s390/cio: fix a memleak in css_alloc_subchannel

Pull x86 platform driver fixes from Hans de Goede:

 -  Fix spurious brightness down presses on newer Asus laptop models

 -  Fix backlight control not working on T2 Mac Pro all-in-ones

 -  Add Armin Wolf as new maintainer for the WMI bus driver and change
    its status from orphaned to maintained

 -  A few other small fixes

* tag 'platform-drivers-x86-v6.6-5' of git://git.kernel.org/pub/scm/linux/kernel/git/pdx86/platform-drivers-x86:
  platform/mellanox: mlxbf-tmfifo: Fix a warning message
  apple-gmux: Hard Code max brightness for MMIO gmux
  platform/surface: platform_profile: Propagate error if profile registration fails
  platform/x86: asus-wmi: Map 0x2a code, Ignore 0x2b and 0x2c events
  platform/x86: asus-wmi: Only map brightness codes when using asus-wmi backlight control
  platform/x86: asus-wmi: Change ASUS_WMI_BRN_DOWN code from 0x20 to 0x2e
  platform/x86: wmi: Update MAINTAINERS entry
  platform/x86: msi-ec: Fix the 3rd config
  platform/x86: intel-uncore-freq: Conditionally create attribute for read frequency
  platform: mellanox: Fix a resource leak in an error handling path in probing flow

Pull USB / Thunderbolt fixes and ids from Greg KH:
 "Here are four small patches for USB and Thunderbolt for 6.6-rc7 that
  do the following:

   - new usb-serial device ids

   - thunderbolt driver fix for reported issue

  All of these have been in linux-next with no reported problems"

* tag 'usb-6.6-rc7' of git://git.kernel.org/pub/scm/linux/kernel/git/gregkh/usb:
  USB: serial: option: add Fibocom to DELL custom modem FM101R-GL
  USB: serial: option: add entry for Sierra EM9191 with new firmware
  USB: serial: option: add Telit LE910C4-WWX 0x1035 composition
  thunderbolt: Call tb_switch_put() once DisplayPort bandwidth request is finished

Pull ACPI fixes from Rafael Wysocki:
 "These fix the ACPI initialization ordering on ARM and ACPI IRQ
  management in the cases when irq_create_fwspec_mapping() fails.

  Specifics:

   - Fix ACPI initialization ordering on ARM that was changed
     incorrectly during the 6.5 development cycle (Hanjun Guo)

   - Make acpi_register_gsi() return an error code as appropriate when
     irq_create_fwspec_mapping() returns 0 on failure (Sunil V L)"

* tag 'acpi-6.6-rc7' of git://git.kernel.org/pub/scm/linux/kernel/git/rafael/linux-pm:
  ACPI: bus: Move acpi_arm_init() to the place of after acpi_ghes_init()
  ACPI: irq: Fix incorrect return value in acpi_register_gsi()

Pull SCSI fixes from James Bottomley:
 "Two small fixes, both in drivers.

  The mptsas one is really fixing an error path issue where it can leave
  the misc driver loaded even though the sas driver fails to initialize"

* tag 'scsi-fixes' of git://git.kernel.org/pub/scm/linux/kernel/git/jejb/scsi:
  scsi: qla2xxx: Fix double free of dsd_list during driver load
  scsi: mpt3sas: Fix in error path

Pull pin control fixes from Linus Walleij:

 - Concurrent register updates in the Qualcomm LPASS pin controller gets
   a proper lock.

 - revert a mutex fix that was causing problems: contention on the mutex
   or something of the sort lead to probe reordering and MMC block
   devices start to register in a different order, which unsuspecting
   userspace is not ready to handle

* tag 'pinctrl-v6.6-3' of git://git.kernel.org/pub/scm/linux/kernel/git/linusw/linux-pinctrl:
  Revert "pinctrl: avoid unsafe code pattern in find_pinctrl()"
  pinctrl: qcom: lpass-lpi: fix concurrent register updates

Pull MTD fixes from Miquel Raynal:
 "In the raw NAND subsystem, the major fix prevents using cached reads
  with devices not supporting it. There was two bug reports about this.

  Apart from that, three drivers (pl353, arasan and marvell) could
  sometimes hide page program failures due to their their own program
  page helper not being fully compliant with the specification (many
  drivers use the default helpers shared by the core). Adding a missing
  check prevents these situation.

  Finally, the Qualcomm driver had a broken error path.

  In the SPI-NAND subsystem one Micron device used a wrong bitmak
  reporting possibly corrupted ECC status.

  Finally, the physmap-core got stripped from its map_rom fallback by
  mistake, this feature is added back"

* tag 'mtd/fixes-for-6.6-rc7' of git://git.kernel.org/pub/scm/linux/kernel/git/mtd/linux:
  mtd: rawnand: Ensure the nand chip supports cached reads
  mtd: rawnand: qcom: Unmap the right resource upon probe failure
  mtd: rawnand: pl353: Ensure program page operations are successful
  mtd: rawnand: arasan: Ensure program page operations are successful
  mtd: spinand: micron: correct bitmask for ecc status
  mtd: physmap-core: Restore map_rom fallback
  mtd: rawnand: marvell: Ensure program page operations are successful