Pull i2c fixes from Wolfram Sang:
 "Some I2C driver bugfixes for 5.18. Nothing spectacular but worth
  fixing"

* 'i2c/for-current' of git://git.kernel.org/pub/scm/linux/kernel/git/wsa/linux:
  drivers: i2c: thunderx: Allow driver to work with ACPI defined TWSI controllers
  i2c: ismt: Provide a DMA buffer for Interrupt Cause Logging
  i2c: mt7621: fix missing clk_disable_unprepare() on error in mtk_i2c_probe()

Pull input fixes from Dmitry Torokhov:
 "A small fixup to ili210x touchscreen driver, and updated maintainer
  entry for the device tree binding of Mediatek 6779 keypad:

   - fix reset timing of Ilitek touchscreens

   - update maintainer entry of DT binding of Mediatek 6779 keypad"

* tag 'input-for-v5.18-rc7' of git://git.kernel.org/pub/scm/linux/kernel/git/dtor/input:
  Input: ili210x - use one common reset implementation
  Input: ili210x - fix reset timing
  dt-bindings: input: mediatek,mt6779-keypad: update maintainer

Pull SCSI fixes from James Bottomley:
 "Two patches, both in drivers.

  The iscsi one is fixing the cpumask issue you commented on and the ufs
  one is a late arriving fix for conditions that can occur in Host
  Performance Booster reads"

* tag 'scsi-fixes' of git://git.kernel.org/pub/scm/linux/kernel/git/jejb/scsi:
  scsi: ufs: core: Fix referencing invalid rsp field
  scsi: target: Fix incorrect use of cpumask_t

Due to i2c->adap.dev.fwnode not being set, ACPI_COMPANION() wasn't properly
found for TWSI controllers.

Signed-off-by: Szymon Balcerak <sbalcerak@marvell.com>
Signed-off-by: Piyush Malgujar <pmalgujar@marvell.com>
Signed-off-by: Wolfram Sang <wsa@kernel.org>

Before sending a MSI the hardware writes information pertinent to the
interrupt cause to a memory location pointed by SMTICL register. This
memory holds three double words where the least significant bit tells
whether the interrupt cause of master/target/error is valid. The driver
does not use this but we need to set it up because otherwise it will
perform DMA write to the default address (0) and this will cause an
IOMMU fault such as below:

  DMAR: DRHD: handling fault status reg 2
  DMAR: [DMA Write] Request device [00:12.0] PASID ffffffff fault addr 0
        [fault reason 05] PTE Write access is not set

To prevent this from happening, provide a proper DMA buffer for this
that then gets mapped by the IOMMU accordingly.

Signed-off-by: Mika Westerberg <mika.westerberg@linux.intel.com>
Reviewed-by: From: Andy Shevchenko <andriy.shevchenko@linux.intel.com>
Signed-off-by: Wolfram Sang <wsa@kernel.org>

Fix the missing clk_disable_unprepare() before return
from mtk_i2c_probe() in the error handling case.

Fixes: d04913ec5f89 ("i2c: mt7621: Add MediaTek MT7621/7628/7688 I2C driver")
Signed-off-by: Yang Yingliang <yangyingliang@huawei.com>
Reviewed-by: Stefan Roese <sr@denx.de>
Signed-off-by: Wolfram Sang <wsa@kernel.org>

Pull clk fixes from Stephen Boyd:
 "Three clk driver fixes to close out the release

   - Fix a divider calculation breaking boot on Broadcom bcm2835

   - Fix HDMI output on Tanix TX6 mini board by reverting a patch

   - Fix clk_set_rate_range() calls on at91 by considering the range
     while calculating the divisor"

* tag 'clk-fixes-for-linus' of git://git.kernel.org/pub/scm/linux/kernel/git/clk/linux:
  clk: at91: generated: consider range when calculating best rate
  Revert "clk: sunxi-ng: sun6i-rtc: Add support for H6"
  clk: bcm2835: fix bcm2835_clock_choose_div

Pull drm fixes from Dave Airlie:
 "Few final fixes for 5.18, one amdgpu, core dp mst leak fix, dma-buf
  two fixes, and i915 has a few fixes, one for a regression on older
  GM45 chipsets,

  dma-buf:
   - ioctl userspace use fix
   - fix dma-buf sysfs name generation

  core:
   - dp/mst leak fix

  amdgpu:
   - suspend/resume regression fix

  i915:
   - fix for #5806: GPU hangs and display artifacts on Intel GM45
   - reject DMC with out-of-spec MMIO
   - correctly mark guilty contexts on GuC reset"

* tag 'drm-fixes-2022-05-21' of git://anongit.freedesktop.org/drm/drm:
  drm/i915: Use i915_gem_object_ggtt_pin_ww for reloc_iomap
  drm/amd: Don't reset dGPUs if the system is going to s2idle
  drm/dp/mst: fix a possible memory leak in fetch_monitor_name()
  dma-buf: fix use of DMA_BUF_SET_NAME_{A,B} in userspace
  i915/guc/reset: Make __guc_reset_context aware of guilty engines
  drm/i915/dmc: Add MMIO range restrictions
  dma-buf: ensure unique directory name for dmabuf stats

- fix for #5806: GPU hangs and display artifacts on 5.18-rc3 on Intel GM45
- reject DMC with out-of-spec MMIO (Cc: stable)
- correctly mark guilty contexts on GuC reset.

Signed-off-by: Dave Airlie <airlied@redhat.com>
From: Joonas Lahtinen <joonas.lahtinen@linux.intel.com>
Link: https://patchwork.freedesktop.org/patch/msgid/YocqqvG6PbYx3QgJ@jlahtine-mobl.ger.corp.intel.com

Fix for a memory leak in dp_mst, a (userspace) build fix for
DMA_BUF_SET_NAME defines and a directory name generation fix for dmabuf
stats

Signed-off-by: Dave Airlie <airlied@redhat.com>

From: Maxime Ripard <maxime@cerno.tech>
Link: https://patchwork.freedesktop.org/patch/msgid/20220520072408.cpjzy2taugagvrh7@houat