Pull IOMMU fix from Joerg Roedel:
 "Another fix, this time in common IOMMU sysfs code.

  In the conversion from the old iommu sysfs-code to the
  iommu_device_register interface, I missed to update the release path
  for the struct device associated with an IOMMU. It freed the 'struct
  device', which was a pointer before, but is now embedded in another
  struct.

  Freeing from the middle of allocated memory had all kinds of nasty
  side effects when an IOMMU was unplugged. Unfortunatly nobody
  unplugged and IOMMU until now, so this was not discovered earlier. The
  fix is to make the 'struct device' a pointer again"

* tag 'iommu-fixes-v4.13-rc6' of git://git.kernel.org/pub/scm/linux/kernel/git/joro/iommu:
  iommu: Fix wrong freeing of iommu_device->dev

Pull char/misc fix from Greg KH:
 "Here is a single misc driver fix for 4.13-rc7. It resolves a reported
  problem in the Android binder driver due to previous patches in
  4.13-rc.

  It's been in linux-next with no reported issues"

* tag 'char-misc-4.13-rc7' of git://git.kernel.org/pub/scm/linux/kernel/git/gregkh/char-misc:
  ANDROID: binder: fix proc->tsk check.

Pull staging/iio fixes from Greg KH:
 "Here are few small staging driver fixes, and some more IIO driver
  fixes for 4.13-rc7. Nothing major, just resolutions for some reported
  problems.

  All of these have been in linux-next with no reported problems"

* tag 'staging-4.13-rc7' of git://git.kernel.org/pub/scm/linux/kernel/git/gregkh/staging:
  iio: magnetometer: st_magn: remove ihl property for LSM303AGR
  iio: magnetometer: st_magn: fix status register address for LSM303AGR
  iio: hid-sensor-trigger: Fix the race with user space powering up sensors
  iio: trigger: stm32-timer: fix get trigger mode
  iio: imu: adis16480: Fix acceleration scale factor for adis16480
  PATCH] iio: Fix some documentation warnings
  staging: rtl8188eu: add RNX-N150NUB support
  Revert "staging: fsl-mc: be consistent when checking strcmp() return"
  iio: adc: stm32: fix common clock rate
  iio: adc: ina219: Avoid underflow for sleeping time
  iio: trigger: stm32-timer: add enable attribute
  iio: trigger: stm32-timer: fix get/set down count direction
  iio: trigger: stm32-timer: fix write_raw return value
  iio: trigger: stm32-timer: fix quadrature mode get routine
  iio: bmp280: properly initialize device for humidity reading

Pull NTB fixes from Jon Mason:
 "NTB bug fixes to address an incorrect ntb_mw_count reference in the
  NTB transport, improperly bringing down the link if SPADs are
  corrupted, and an out-of-order issue regarding link negotiation and
  data passing"

* tag 'ntb-4.13-bugfixes' of git://github.com/jonmason/ntb:
  ntb: ntb_test: ensure the link is up before trying to configure the mws
  ntb: transport shouldn't disable link due to bogus values in SPADs
  ntb: use correct mw_count function in ntb_tool and ntb_transport

Pull input fixes from Dmitry Torokhov:

 - a tweak to the IBM Trackpoint driver that helps recognizing
   trackpoints on never Lenovo Carbons

 - a fix to the ALPS driver solving scroll issues on some Dells

 - yet another ACPI ID has been added to Elan I2C toucpad driver

 - quieted diagnostic message in soc_button_array driver

* 'for-linus' of git://git.kernel.org/pub/scm/linux/kernel/git/dtor/input:
  Input: ALPS - fix two-finger scroll breakage in right side on ALPS touchpad
  Input: soc_button_array - silence -ENOENT error on Dell XPS13 9365
  Input: trackpoint - add new trackpoint firmware ID
  Input: elan_i2c - add ELAN0602 ACPI ID to support Lenovo Yoga310

Pull PCI fix from Bjorn Helgaas:
 "Remove needlessly alarming MSI affinity warning (this is not actually
  a bug fix, but the warning prompts unnecessary bug reports)"

* tag 'pci-v4.13-fixes-3' of git://git.kernel.org/pub/scm/linux/kernel/git/helgaas/pci:
  PCI/MSI: Don't warn when irq_create_affinity_masks() returns NULL

Pull virtio fixes from Michael Tsirkin:
 "Fixes two obvious bugs in virtio pci"

* tag 'for_linus' of git://git.kernel.org/pub/scm/linux/kernel/git/mst/vhost:
  virtio_pci: fix cpu affinity support
  virtio_blk: fix incorrect message when disk is resized

Pull MTD fixes from Brian Norris:
 "Two fixes - one for a 4.13 regression, and the other for an older one:

   - Atmel NAND: since we started utilizing ONFI timings, we found that
     we were being too restrict at rejecting them, partly due to
     discrepancies in ONFI 4.0 and earlier versions. Relax the
     restriction to keep these platforms booting. This is a 4.13-rc1
     regression.

   - nandsim: repeated probe/removal may not work after a failed init,
     because we didn't free up our debugfs files properly on the failure
     path. This has been around since 3.8, but it's nice to get this
     fixed now in a nice easy patch that can target -stable, since
     there's already refactoring work (that also fixes the issue)
     targeted for the next merge window"

* tag 'for-linus-20170825' of git://git.infradead.org/linux-mtd:
  mtd: nand: atmel: Relax tADL_min constraint
  mtd: nandsim: remove debugfs entries in error path

Pull block fixes from Jens Axboe:
 "A small batch of fixes that should be included for the 4.13 release.
  This contains:

   - Revert of the 4k loop blocksize support. Even with a recent batch
     of 4 fixes, we're still not really happy with it. Rather than be
     stuck with an API issue, let's revert it and get it right for 4.14.

   - Trivial patch from Bart, adding a few flags to the blk-mq debugfs
     exports that were added in this release, but not to the debugfs
     parts.

   - Regression fix for bsg, fixing a potential kernel panic. From
     Benjamin.

   - Tweak for the blk throttling, improving how we account discards.
     From Shaohua"

* 'for-linus' of git://git.kernel.dk/linux-block:
  blk-mq-debugfs: Add names for recently added flags
  bsg-lib: fix kernel panic resulting from missing allocation of reply-buffer
  Revert "loop: support 4k physical blocksize"
  blk-throttle: cap discard request size

Pull i2c fixes from Wolfram Sang:
 "I2C has some bugfixes for you: mainly Jarkko fixed up a few things in
  the designware driver regarding the new slave mode. But Ulf also fixed
  a long-standing and now agreed suspend problem. Plus, some simple
  stuff which nonetheless needs fixing"

* 'i2c/for-current' of git://git.kernel.org/pub/scm/linux/kernel/git/wsa/linux:
  i2c: designware: Fix runtime PM for I2C slave mode
  i2c: designware: Remove needless pm_runtime_put_noidle() call
  i2c: aspeed: fixed potential null pointer dereference
  i2c: simtec: use release_mem_region instead of release_resource
  i2c: core: Make comment about I2C table requirement to reflect the code
  i2c: designware: Fix standard mode speed when configuring the slave mode
  i2c: designware: Fix oops from i2c_dw_irq_handler_slave
  i2c: designware: Fix system suspend