Pull char/misc drivers updates from Greg KH:
 "Here is the "big" set of char/misc and other driver subsystems for
  6.4-rc1.

  It's pretty big, but due to the removal of pcmcia drivers, almost
  breaks even for number of lines added vs. removed, a nice change.

  Included in here are:

   - removal of unused PCMCIA drivers (finally!)

   - Interconnect driver updates and additions

   - Lots of IIO driver updates and additions

   - MHI driver updates

   - Coresight driver updates

   - NVMEM driver updates, which required some OF updates

   - W1 driver updates and a new maintainer to manage the subsystem

   - FPGA driver updates

   - New driver subsystem, CDX, for AMD systems

   - lots of other small driver updates and additions

  All of these have been in linux-next for a while with no reported
  issues"

* tag 'char-misc-6.4-rc1' of git://git.kernel.org/pub/scm/linux/kernel/git/gregkh/char-misc: (196 commits)
  mcb-lpc: Reallocate memory region to avoid memory overlapping
  mcb-pci: Reallocate memory region to avoid memory overlapping
  mcb: Return actual parsed size when reading chameleon table
  kernel/configs: Drop Android config fragments
  virt: acrn: Replace obsolete memalign() with posix_memalign()
  spmi: Add a check for remove callback when removing a SPMI driver
  spmi: fix W=1 kernel-doc warnings
  spmi: mtk-pmif: Drop of_match_ptr for ID table
  spmi: pmic-arb: Convert to platform remove callback returning void
  spmi: mtk-pmif: Convert to platform remove callback returning void
  spmi: hisi-spmi-controller: Convert to platform remove callback returning void
  w1: gpio: remove unnecessary ENOMEM messages
  w1: omap-hdq: remove unnecessary ENOMEM messages
  w1: omap-hdq: add SPDX tag
  w1: omap-hdq: allow compile testing
  w1: matrox: remove unnecessary ENOMEM messages
  w1: matrox: use inline over __inline__
  w1: matrox: switch from asm to linux header
  w1: ds2482: do not use assignment in if condition
  w1: ds2482: drop unnecessary header
  ...

Pull driver core updates from Greg KH:
 "Here is the large set of driver core changes for 6.4-rc1.

  Once again, a busy development cycle, with lots of changes happening
  in the driver core in the quest to be able to move "struct bus" and
  "struct class" into read-only memory, a task now complete with these
  changes.

  This will make the future rust interactions with the driver core more
  "provably correct" as well as providing more obvious lifetime rules
  for all busses and classes in the kernel.

  The changes required for this did touch many individual classes and
  busses as many callbacks were changed to take const * parameters
  instead. All of these changes have been submitted to the various
  subsystem maintainers, giving them plenty of time to review, and most
  of them actually did so.

  Other than those changes, included in here are a small set of other
  things:

   - kobject logging improvements

   - cacheinfo improvements and updates

   - obligatory fw_devlink updates and fixes

   - documentation updates

   - device property cleanups and const * changes

   - firwmare loader dependency fixes.

  All of these have been in linux-next for a while with no reported
  problems"

* tag 'driver-core-6.4-rc1' of git://git.kernel.org/pub/scm/linux/kernel/git/gregkh/driver-core: (120 commits)
  device property: make device_property functions take const device *
  driver core: update comments in device_rename()
  driver core: Don't require dynamic_debug for initcall_debug probe timing
  firmware_loader: rework crypto dependencies
  firmware_loader: Strip off \n from customized path
  zram: fix up permission for the hot_add sysfs file
  cacheinfo: Add use_arch[|_cache]_info field/function
  arch_topology: Remove early cacheinfo error message if -ENOENT
  cacheinfo: Check cache properties are present in DT
  cacheinfo: Check sib_leaf in cache_leaves_are_shared()
  cacheinfo: Allow early level detection when DT/ACPI info is missing/broken
  cacheinfo: Add arm64 early level initializer implementation
  cacheinfo: Add arch specific early level initializer
  tty: make tty_class a static const structure
  driver core: class: remove struct class_interface * from callbacks
  driver core: class: mark the struct class in struct class_interface constant
  driver core: class: make class_register() take a const *
  driver core: class: mark class_release() as taking a const *
  driver core: remove incorrect comment for device_create*
  MIPS: vpe-cmp: remove module owner pointer from struct class usage.
  ...

Pull spi updates from Mark Brown:
 "A fairly standard release for SPI with the exception of a change to
  the API for specifying chip selects done in preparation for supporting
  devices with more than one chip select, this required some mechanical
  changes throughout the tree which have been cooking in -next happily
  for a while.

  There's also a new API to allow us to support TPM chips on half duplex
  controllers.

  Summary:

   - Refactoring in preparation for supporting multiple chip selects for
     a single device, needed by some flash devices, which required a
     change in the SPI device API visible throughout the tree

   - Support for hardware assisted interaction with SPI TPMs on half
     duplex controllers, implemented on nVidia Tedra210 QuadSPI

   - Optimisation for large transfers on fsl-cpm devices

   - Cleanups around device property use which fix some sisues with
     fwnode

   - Use of both void remove() and devm_platform_.*ioremap_resource()

   - Support for AMD Pensando Elba, Amlogic A1, Cadence device mode,
     Intel MetorLake-S and StarFive J7110 QuadSPI"

* tag 'spi-v6.4' of git://git.kernel.org/pub/scm/linux/kernel/git/broonie/spi: (185 commits)
  spi: bcm63xx: use macro DEFINE_SIMPLE_DEV_PM_OPS
  spi: tegra210-quad: Enable TPM wait polling
  spi: Add TPM HW flow flag
  spi: bcm63xx: remove PM_SLEEP based conditional compilation
  spi: cadence-quadspi: use macro DEFINE_SIMPLE_DEV_PM_OPS
  spi: spi-cadence: Add support for Slave mode
  spi: spi-cadence: Switch to spi_controller structure
  spi: cadence-quadspi: fix suspend-resume implementations
  spi: dw: Add support for AMD Pensando Elba SoC
  spi: dw: Add AMD Pensando Elba SoC SPI Controller
  spi: cadence-quadspi: Disable the SPI before reconfiguring
  spi: cadence-quadspi: Update the read timeout based on the length
  spi: spi-loopback-test: Add module param for iteration length
  spi: add support for Amlogic A1 SPI Flash Controller
  dt-bindings: spi: add Amlogic A1 SPI controller
  spi: fsl-spi: No need to check transfer length versus word size
  spi: fsl-spi: Change mspi_apply_cpu_mode_quirks() to void
  spi: fsl-cpm: Use 16 bit mode for large transfers with even size
  spi: fsl-spi: Re-organise transfer bits_per_word adaptation
  spi: fsl-spi: Fix CPM/QE mode Litte Endian
  ...

Using this macro makes the code more readable.
It also inits the members of dev_pm_ops in the following manner
without us explicitly needing to:

.suspend = bcm63xx_spi_suspend, \
.resume = bcm63xx_spi_resume, \
.freeze = bcm63xx_spi_suspend, \
.thaw = bcm63xx_spi_resume, \
.poweroff = bcm63xx_spi_suspend, \
.restore = bcm63xx_spi_resume

Signed-off-by: Dhruva Gole <d-gole@ti.com>
Link: https://lore.kernel.org/r/20230424102546.1604484-1-d-gole@ti.com
Signed-off-by: Mark Brown <broonie@kernel.org>

Merge series from Krishna Yarlagadda <kyarlagadda@nvidia.com>:

TPM devices may insert wait state on last clock cycle of ADDR phase.
For SPI controllers that support full-duplex transfers, this can be
detected using software by reading the MISO line. For SPI controllers
that only support half-duplex transfers, such as the Tegra QSPI, it is
not possible to detect the wait signal from software. The QSPI
controller in Tegra234 and Tegra241 implement hardware detection of the
wait signal which can be enabled in the controller for TPM devices.

Add a flag for this in the SPI core and implement support in the Tegra
QuadSPI driver.

Trusted Platform Module requires flow control. As defined in TPM
interface specification, client would drive MISO line at same cycle as
last address bit on MOSI.
Tegra234 and Tegra241 QSPI controllers have TPM wait state detection
feature which is enabled for TPM client devices reported in SPI device
mode bits.

Signed-off-by: Krishna Yarlagadda <kyarlagadda@nvidia.com>
Reviewed-by: Jon Hunter <jonathanh@nvidia.com>
Reviewed-by: Jerry Snitselaar <jsnitsel@redhat.com>
Link: https://lore.kernel.org/r/20230421091309.2672-4-kyarlagadda@nvidia.com
Signed-off-by: Mark Brown <broonie@kernel.org>

Get rid of conditional compilation based on CONFIG_PM_SLEEP because
it may introduce build issues with certain configs where it maybe disabled
This is because if above config is not enabled the suspend-resume
functions are never part of the code but the bcm63xx_spi_pm_ops struct
still inits them to non-existent suspend-resume functions.

Fixes: b42dfed83d95 ("spi: add Broadcom BCM63xx SPI controller driver")

Signed-off-by: Dhruva Gole <d-gole@ti.com>
Link: https://lore.kernel.org/r/20230420121615.967487-1-d-gole@ti.com
Signed-off-by: Mark Brown <broonie@kernel.org>

Using this macro makes the code more readable.
It also inits the members of dev_pm_ops in the following manner
without us explicitly needing to:

.suspend = cqspi_suspend, \
.resume = cqspi_resume, \
.freeze = cqspi_suspend, \
.thaw = cqspi_resume, \
.poweroff = cqspi_suspend, \
.restore = cqspi_resume

Also get rid of conditional compilation based on CONFIG_PM_SLEEP because
it introduces build issues with certain configs when CQSPI_DEV_PM_OPS is
just NULL.

Reported-by: kernel test robot <lkp@intel.com>
Link: https://lore.kernel.org/oe-kbuild-all/202304191900.2fARFQW9-lkp@intel.com/
Fixes: 140623410536 ("mtd: spi-nor: Add driver for Cadence Quad SPI Flash Controller")
Signed-off-by: Dhruva Gole <d-gole@ti.com>
Link: https://lore.kernel.org/r/20230420054257.925092-1-d-gole@ti.com
Signed-off-by: Mark Brown <broonie@kernel.org>

Pull spi fix from Mark Brown:
 "A small fix in the error handling for the rockchip driver, ensuring we
  don't leak clock enables if we fail to request the interrupt for the
  device"

* tag 'spi-fix-v6.3-rc7' of git://git.kernel.org/pub/scm/linux/kernel/git/broonie/spi:
  spi: spi-rockchip: Fix missing unwind goto in rockchip_sfc_probe()

If devm_request_irq() fails, then we are directly return 'ret' without
clk_disable_unprepare(sfc->clk) and clk_disable_unprepare(sfc->hclk).

Fix this by changing direct return to a goto 'err_irq'.

Fixes: 0b89fc0a367e ("spi: rockchip-sfc: add rockchip serial flash controller")
Signed-off-by: Li Lanzhe <u202212060@hust.edu.cn>
Reviewed-by: Dongliang Mu <dzm91@hust.edu.cn>
Link: https://lore.kernel.org/r/20230419115030.6029-1-u202212060@hust.edu.cn
Signed-off-by: Mark Brown <broonie@kernel.org>