Pull spi fixes from Mark Brown:
 "A small set of fixes for SPI drivers, Krishna has been doing a bunch
  of work on Tegra210 QuadSPI and found a bunch of issues there and
  there's a couple of small fixes for other drivers too"

* tag 'spi-fix-v6.3' of git://git.kernel.org/pub/scm/linux/kernel/git/broonie/spi:
  spi: tegra210-quad: Fix iterator outside loop
  spi: tegra210-quad: Fix validate combined sequence
  spi: tegra210-quad: set half duplex flag
  spi: spi-sn-f-ospi: fix duplicate flag while assigning to mode_bits
  spi: cadence-quadspi: Fix cancel the indirect read mask

Fix warn: iterator used outside loop: 'xfer'. 'xfer' variable contain
invalid value in few conditions. Complete transfer within DATA phase
in successful case and at the end for failed transfer.

Reported-by: Dan Carpenter <dan.carpenter@oracle.com>
Link:https://lore.kernel.org/all/202210191211.46FkzKmv-lkp@intel.com/
Fixes: 8777dd9dff40 ("spi: tegra210-quad: Fix combined sequence")

Signed-off-by: Krishna Yarlagadda <kyarlagadda@nvidia.com>
Link: https://lore.kernel.org/r/20230227200428.45832-1-kyarlagadda@nvidia.com
Signed-off-by: Mark Brown <broonie@kernel.org>

Pull ARM SoC driver updates from Arnd Bergmann:
 "As usual, there are lots of minor driver changes across SoC platforms
  from NXP, Amlogic, AMD Zynq, Mediatek, Qualcomm, Apple and Samsung.
  These usually add support for additional chip variations in existing
  drivers, but also add features or bugfixes.

  The SCMI firmware subsystem gains a unified raw userspace interface
  through debugfs, which can be used for validation purposes.

  Newly added drivers include:

   - New power management drivers for StarFive JH7110, Allwinner D1 and
     Renesas RZ/V2M

   - A driver for Qualcomm battery and power supply status

   - A SoC device driver for identifying Nuvoton WPCM450 chips

   - A regulator coupler driver for Mediatek MT81xxv"

* tag 'soc-drivers-6.3' of git://git.kernel.org/pub/scm/linux/kernel/git/soc/soc: (165 commits)
  power: supply: Introduce Qualcomm PMIC GLINK power supply
  soc: apple: rtkit: Do not copy the reg state structure to the stack
  soc: sunxi: SUN20I_PPU should depend on PM
  memory: renesas-rpc-if: Remove redundant division of dummy
  soc: qcom: socinfo: Add IDs for IPQ5332 and its variant
  dt-bindings: arm: qcom,ids: Add IDs for IPQ5332 and its variant
  dt-bindings: power: qcom,rpmpd: add RPMH_REGULATOR_LEVEL_LOW_SVS_L1
  firmware: qcom_scm: Move qcom_scm.h to include/linux/firmware/qcom/
  MAINTAINERS: Update qcom CPR maintainer entry
  dt-bindings: firmware: document Qualcomm SM8550 SCM
  dt-bindings: firmware: qcom,scm: add qcom,scm-sa8775p compatible
  soc: qcom: socinfo: Add Soc IDs for IPQ8064 and variants
  dt-bindings: arm: qcom,ids: Add Soc IDs for IPQ8064 and variants
  soc: qcom: socinfo: Add support for new field in revision 17
  soc: qcom: smd-rpm: Add IPQ9574 compatible
  soc: qcom: pmic_glink: remove redundant calculation of svid
  soc: qcom: stats: Populate all subsystem debugfs files
  dt-bindings: soc: qcom,rpmh-rsc: Update to allow for generic nodes
  soc: qcom: pmic_glink: add CONFIG_NET/CONFIG_OF dependencies
  soc: qcom: pmic_glink: Introduce altmode support
  ...

Pull driver core updates from Greg KH:
 "Here is the large set of driver core changes for 6.3-rc1.

  There's a lot of changes this development cycle, most of the work
  falls into two different categories:

   - fw_devlink fixes and updates. This has gone through numerous review
     cycles and lots of review and testing by lots of different devices.
     Hopefully all should be good now, and Saravana will be keeping a
     watch for any potential regression on odd embedded systems.

   - driver core changes to work to make struct bus_type able to be
     moved into read-only memory (i.e. const) The recent work with Rust
     has pointed out a number of areas in the driver core where we are
     passing around and working with structures that really do not have
     to be dynamic at all, and they should be able to be read-only
     making things safer overall. This is the contuation of that work
     (started last release with kobject changes) in moving struct
     bus_type to be constant. We didn't quite make it for this release,
     but the remaining patches will be finished up for the release after
     this one, but the groundwork has been laid for this effort.

  Other than that we have in here:

   - debugfs memory leak fixes in some subsystems

   - error path cleanups and fixes for some never-able-to-be-hit
     codepaths.

   - cacheinfo rework and fixes

   - Other tiny fixes, full details are in the shortlog

  All of these have been in linux-next for a while with no reported
  problems"

[ Geert Uytterhoeven points out that that last sentence isn't true, and
  that there's a pending report that has a fix that is queued up - Linus ]

* tag 'driver-core-6.3-rc1' of git://git.kernel.org/pub/scm/linux/kernel/git/gregkh/driver-core: (124 commits)
  debugfs: drop inline constant formatting for ERR_PTR(-ERROR)
  OPP: fix error checking in opp_migrate_dentry()
  debugfs: update comment of debugfs_rename()
  i3c: fix device.h kernel-doc warnings
  dma-mapping: no need to pass a bus_type into get_arch_dma_ops()
  driver core: class: move EXPORT_SYMBOL_GPL() lines to the correct place
  Revert "driver core: add error handling for devtmpfs_create_node()"
  Revert "devtmpfs: add debug info to handle()"
  Revert "devtmpfs: remove return value of devtmpfs_delete_node()"
  driver core: cpu: don't hand-override the uevent bus_type callback.
  devtmpfs: remove return value of devtmpfs_delete_node()
  devtmpfs: add debug info to handle()
  driver core: add error handling for devtmpfs_create_node()
  driver core: bus: update my copyright notice
  driver core: bus: add bus_get_dev_root() function
  driver core: bus: constify bus_unregister()
  driver core: bus: constify some internal functions
  driver core: bus: constify bus_get_kset()
  driver core: bus: constify bus_register/unregister_notifier()
  driver core: remove private pointer from struct bus_type
  ...

Pull tty / serial driver updates from Greg KH:
 "Here is the big set of serial and tty driver updates for 6.3-rc1.

  Once again, Jiri and Ilpo have done a number of core vt and tty/serial
  layer cleanups that were much needed and appreciated. Other than that,
  it's just a bunch of little tty/serial driver updates:

   - qcom-geni-serial driver updates

   - liteuart driver updates

   - hvcs driver cleanups

   - n_gsm updates and additions for new features

   - more 8250 device support added

   - fpga/dfl update and additions

   - imx serial driver updates

   - fsl_lpuart updates

   - other tiny fixes and updates for serial drivers

  All of these have been in linux-next for a while with no reported
  problems"

* tag 'tty-6.3-rc1' of git://git.kernel.org/pub/scm/linux/kernel/git/gregkh/tty: (143 commits)
  tty: n_gsm: add keep alive support
  serial: imx: remove a redundant check
  dt-bindings: serial: snps-dw-apb-uart: add dma & dma-names properties
  soc: qcom: geni-se: Move qcom-geni-se.h to linux/soc/qcom/geni-se.h
  tty: n_gsm: add TIOCMIWAIT support
  tty: n_gsm: add RING/CD control support
  tty: n_gsm: mark unusable ioctl structure fields accordingly
  serial: imx: get rid of registers shadowing
  serial: imx: refine local variables in rxint()
  serial: imx: stop using USR2 in FIFO reading loop
  serial: imx: remove redundant USR2 read from FIFO reading loop
  serial: imx: do not break from FIFO reading loop prematurely
  serial: imx: do not sysrq broken chars
  serial: imx: work-around for hardware RX flood
  serial: imx: factor-out common code to imx_uart_soft_reset()
  serial: 8250_pci1xxxx: Add power management functions to quad-uart driver
  serial: 8250_pci1xxxx: Add RS485 support to quad-uart driver
  serial: 8250_pci1xxxx: Add driver for quad-uart support
  serial: 8250_pci: Add serial8250_pci_setup_port definition in 8250_pcilib.c
  tty: pcn_uart: fix memory leak with using debugfs_lookup()
  ...

Check for non dma transfers that do not fit in FIFO has issue and skips
combined sequence for Tegra234 & Tegra241 which does not have GPCDMA.

Fixes: 1b8342cc4a38 ("spi: tegra210-quad: combined sequence mode")

Signed-off-by: Krishna Yarlagadda <kyarlagadda@nvidia.com>
Link: https://lore.kernel.org/r/20230224164034.56933-1-kyarlagadda@nvidia.com
Signed-off-by: Mark Brown <broonie@kernel.org>

Tegra QSPI controller only supports half duplex transfers.
Set half duplex constrain flag.

Signed-off-by: Krishna Yarlagadda <kyarlagadda@nvidia.com>
Link: https://lore.kernel.org/r/20230223162635.19747-3-kyarlagadda@nvidia.com
Signed-off-by: Mark Brown <broonie@kernel.org>

Replace the SPI_TX_OCTAL flag that appeared two time with SPI_RX_OCTAL
in the chain of '|' operators while assigning to mode_bits

Fixes: 1b74dd64c861 ("spi: Add Socionext F_OSPI SPI flash controller driver")

Reported-by: David Binderman <dcb314@hotmail.com>
Link: https://lore.kernel.org/all/DB6P189MB0568F3BE9384315F5C8C1A3E9CA49@DB6P189MB0568.EURP189.PROD.OUTLOOK.COM/

Cc: stable@vger.kernel.org
Signed-off-by: Dhruva Gole <d-gole@ti.com>
Link: https://lore.kernel.org/r/20230223095202.924626-1-d-gole@ti.com
Signed-off-by: Mark Brown <broonie@kernel.org>

This is to cancel the indirect read transfer process,
so should be use CQSPI_REG_INDIRECTRD_CANCEL_MASK

Signed-off-by: Hongbin Ji <jhb_ee@163.com>
Link: https://lore.kernel.org/r/20230222092128.4237-1-jhb_ee@163.com
Signed-off-by: Mark Brown <broonie@kernel.org>

Pull spi updates from Mark Brown:
 "This has been a fairly quiet release for SPI, though it is likely that
  the next release will have some big changes as there's some
  preparatory work for multiple chip select support gone in - the rest
  of the code is on the list but will need to be rebased onto -rc1.
  Otherwise there's a couple of new tunables for chip select timings,
  some new devices and smaller device specific updates and fixes.

   - Support for configuring the hold and minimum inactive times for
     chip selects.

   - Beginnings of support for supporting devices which have multiple
     chip selects on a single device.

   - Support for newer Broadcom HSSPI and Intel controllers, Silicon
     Labs EM3581 and SI3210"

* tag 'spi-v6.3' of git://git.kernel.org/pub/scm/linux/kernel/git/broonie/spi: (67 commits)
  spi: dt-bindings: qcom,spi-qcom-qspi: document OPP and power-domains
  spi: spidev: drop the incorrect notice from Kconfig
  spi: bcm63xx-hsspi: fix error code in probe
  spi: bcmbca-hsspi: Fix error code in probe() function
  spi: synquacer: Fix timeout handling in synquacer_spi_transfer_one()
  spi: intel: Check number of chip selects after reading the descriptor
  spi: xilinx: add force_irq for QSPI mode
  spi: spi-st-ssc: convert to DT schema
  spi: Reorder fields in 'struct spi_transfer'
  spi: cadence-quadspi: use STIG mode for small reads
  spi: cadence-quadspi: setup ADDR Bits in cmd reads
  spi: cadence-quadspi: Add flag for direct mode writes
  spi: cadence-quadspi: Reset CMD_CTRL Reg on cmd r/w completion
  MAINTAINERS: Remove file reference for Broadcom Broadband SoC HS SPI driver entry
  spi: bcm63xx-hsspi: bcmbca-hsspi: fix _be16 type usage
  MAINTAINERS: Add entry for Broadcom Broadband SoC HS SPI drivers
  spi: bcmbca-hsspi: Add driver for newer HSSPI controller
  spi: bcm63xx-hsspi: Disable spi mem dual io read op support
  spi: spi-mem: Allow controller supporting mem_ops without exec_op
  spi: bcm63xx-hsspi: Add prepend mode support
  ...