Commit 5de85b9d57ab ("PM / runtime: Re-init runtime PM states at probe
error and driver unbind") introduced pm_runtime_reinit() that is used
to reinitialize PM runtime after -EPROBE_DEFER. This allows shutting
down the device after a failed probe.

However, for drivers using pm_runtime_use_autosuspend() this can cause
a state where suspend callback is never called after -EPROBE_DEFER.
On the following device driver probe, hardware state is different from
the PM runtime state causing omap_device to produce the following
error:

omap_device_enable() called from invalid state 1

And with omap_device and omap hardware being picky for PM, this will
block any deeper idle states in hardware.

The solution is to fix the drivers to follow the PM runtime documentation:

1. For sections of code that needs the device disabled, use
   pm_runtime_put_sync_suspend() if pm_runtime_set_autosuspend() has
   been set.

2. For driver exit code, use pm_runtime_dont_use_autosuspend() before
   pm_runtime_put_sync() if pm_runtime_use_autosuspend() has been
   set.

Fixes: 5de85b9d57ab ("PM / runtime: Re-init runtime PM states at probe
error and driver unbind")
Cc: linux-spi@vger.kernel.org
Cc: Alan Stern <stern@rowland.harvard.edu>
Cc: Kevin Hilman <khilman@baylibre.com>
Cc: Mark Brown <broonie@kernel.org>
Cc: Nishanth Menon <nm@ti.com>
Cc: Rafael J. Wysocki <rafael@kernel.org>
Cc: Ulf Hansson <ulf.hansson@linaro.org>
Cc: Tero Kristo <t-kristo@ti.com>
Signed-off-by: Tony Lindgren <tony@atomide.com>
Signed-off-by: Mark Brown <broonie@kernel.org>

The bitmasks for txempty and idle interrupts were interchanged.

Signed-off-by: Stephan Olbrich <stephanolbrich@gmx.de>
Reviewed-by: Eric Anholt <eric@anholt.net>
Signed-off-by: Mark Brown <broonie@kernel.org>

The non-DT platform that uses this driver (actually the AVR32) was taking a bad
branch for determining if the IP would use gpio for CS.
Adding the presence of DT as a condition fixes this issue.

Fixes: 4820303480a1 ("spi: atmel: add support for the internal chip-select of the spi controller")
Reported-by: Mans Rullgard <mans@mansr.com>
Signed-off-by: Cyrille Pitchen <cyrille.pitchen@atmel.com>
[nicolas.ferre@atmel.com: extract from ml discussion]
Signed-off-by: Nicolas Ferre <nicolas.ferre@atmel.com>
Tested-by: Mans Rullgard <mans@mansr.com>
Signed-off-by: Mark Brown <broonie@kernel.org>
Cc: stable@vger.kernel.org

The maximum length during one transcation is 64KiB.

Signed-off-by: Hou Zhiqiang <B48286@freescale.com>
Signed-off-by: Mark Brown <broonie@kernel.org>

In spi_imx_dma_transfer(), when desc_rx = dmaengine_prep_slave_sg()
fails, the context goes to label no_dma and then return. However,
the memory allocated for desc_tx has not been freed yet, which leads
to resource leak.

Signed-off-by: Gao Pan <pandy.gao@nxp.com>
Reviewed-by: Fugang Duan <B38611@freescale.com>
Signed-off-by: Mark Brown <broonie@kernel.org>

Pull powerpc updates from Michael Ellerman:
 "Core:
   - Ground work for the new Power9 MMU from Aneesh Kumar K.V
   - Optimise FP/VMX/VSX context switching from Anton Blanchard

  Misc:
   - Various cleanups from Krzysztof Kozlowski, John Ogness, Rashmica
     Gupta, Russell Currey, Gavin Shan, Daniel Axtens, Michael Neuling,
     Andrew Donnellan
   - Allow wrapper to work on non-english system from Laurent Vivier
   - Add rN aliases to the pt_regs_offset table from Rashmica Gupta
   - Fix module autoload for rackmeter & axonram drivers from Luis de
     Bethencourt
   - Include KVM guest test in all interrupt vectors from Paul Mackerras
   - Fix DSCR inheritance over fork() from Anton Blanchard
   - Make value-returning atomics & {cmp}xchg* & their atomic_ versions
     fully ordered from Boqun Feng
   - Print MSR TM bits in oops messages from Michael Neuling
   - Add TM signal return & invalid stack selftests from Michael Neuling
   - Limit EPOW reset event warnings from Vipin K Parashar
   - Remove the Cell QPACE code from Rashmica Gupta
   - Append linux_banner to exception information in xmon from Rashmica
     Gupta
   - Add selftest to check if VSRs are corrupted from Rashmica Gupta
   - Remove broken GregorianDay() from Daniel Axtens
   - Import Anton's context_switch2 benchmark into selftests from
     Michael Ellerman
   - Add selftest script to test HMI functionality from Daniel Axtens
   - Remove obsolete OPAL v2 support from Stewart Smith
   - Make enter_rtas() private from Michael Ellerman
   - PPR exception cleanups from Michael Ellerman
   - Add page soft dirty tracking from Laurent Dufour
   - Add support for Nvlink NPUs from Alistair Popple
   - Add support for kexec on 476fpe from Alistair Popple
   - Enable kernel CPU dlpar from sysfs from Nathan Fontenot
   - Copy only required pieces of the mm_context_t to the paca from
     Michael Neuling
   - Add a kmsg_dumper that flushes OPAL console output on panic from
     Russell Currey
   - Implement save_stack_trace_regs() to enable kprobe stack tracing
     from Steven Rostedt
   - Add HWCAP bits for Power9 from Michael Ellerman
   - Fix _PAGE_PTE breaking swapoff from Aneesh Kumar K.V
   - Fix _PAGE_SWP_SOFT_DIRTY breaking swapoff from Hugh Dickins
   - scripts/recordmcount.pl: support data in text section on powerpc
     from Ulrich Weigand
   - Handle R_PPC64_ENTRY relocations in modules from Ulrich Weigand

  cxl:
   - cxl: Fix possible idr warning when contexts are released from
     Vaibhav Jain
   - cxl: use correct operator when writing pcie config space values
     from Andrew Donnellan
   - cxl: Fix DSI misses when the context owning task exits from Vaibhav
     Jain
   - cxl: fix build for GCC 4.6.x from Brian Norris
   - cxl: use -Werror only with CONFIG_PPC_WERROR from Brian Norris
   - cxl: Enable PCI device ID for future IBM CXL adapter from Uma
     Krishnan

  Freescale:
   - Freescale updates from Scott: Highlights include moving QE code out
     of arch/powerpc (to be shared with arm), device tree updates, and
     minor fixes"

* tag 'powerpc-4.5-1' of git://git.kernel.org/pub/scm/linux/kernel/git/powerpc/linux: (149 commits)
  powerpc/module: Handle R_PPC64_ENTRY relocations
  scripts/recordmcount.pl: support data in text section on powerpc
  powerpc/powernv: Fix OPAL_CONSOLE_FLUSH prototype and usages
  powerpc/mm: fix _PAGE_SWP_SOFT_DIRTY breaking swapoff
  powerpc/mm: Fix _PAGE_PTE breaking swapoff
  cxl: Enable PCI device ID for future IBM CXL adapter
  cxl: use -Werror only with CONFIG_PPC_WERROR
  cxl: fix build for GCC 4.6.x
  powerpc: Add HWCAP bits for Power9
  powerpc/powernv: Reserve PE#0 on NPU
  powerpc/powernv: Change NPU PE# assignment
  powerpc/powernv: Fix update of NVLink DMA mask
  powerpc/powernv: Remove misleading comment in pci.c
  powerpc: Implement save_stack_trace_regs() to enable kprobe stack tracing
  powerpc: Fix build break due to paca mm_context_t changes
  cxl: Fix DSI misses when the context owning task exits
  MAINTAINERS: Update Scott Wood's e-mail address
  powerpc/powernv: Fix minor off-by-one error in opal_mce_check_early_recovery()
  powerpc: Fix style of self-test config prompts
  powerpc/powernv: Only delay opal_rtc_read() retry when necessary
  ...

These variables are always used uninitialized:

drivers/spi/spi-loopback-test.c: In function 'spi_test_run_iter':
drivers/spi/spi-loopback-test.c:768:17: warning: 'rx_count' may be used uninitialized in this function [-Wmaybe-uninitialized]
drivers/spi/spi-loopback-test.c:762:17: warning: 'tx_count' may be used uninitialized in this function [-Wmaybe-uninitialized]

Adding an explicit initialization seems to be the only
workable solution here, to make the code behave correctly
and build without warning.

Fixes: 84e0c4e5e2c4 ("spi: add loopback test driver to allow for spi_master regression tests")
Signed-off-by: Arnd Bergmann <arnd@arndb.de>
Acked-by: Geert Uytterhoeven <geert@linux-m68k.org>
Signed-off-by: Mark Brown <broonie@kernel.org>

Pull spi updates from Mark Brown:
 "A quiet release for SPI, not even many driver updates:

   - Add a dummy loopback driver for use in exercising framework
     features during development.

   - Move the test utilities to tools/ and add support for transferring
     data to and from a file instead of stdin and stdout to spidev_test.

   - Support for Mediatek MT2701 and Renesas AG5 deices"

* tag 'spi-v4.5' of git://git.kernel.org/pub/scm/linux/kernel/git/broonie/spi: (69 commits)
  spi: loopback: fix typo in MODULE_PARM_DESC
  spi: sun4i: Prevent chip-select from being activated twice before a transfer
  spi: loopback-test: spi_check_rx_ranges can get always done
  spi: loopback-test: rename method spi_test_fill_tx to spi_test_fill_pattern
  spi: loopback-test: write rx pattern also when running without tx_buf
  spi: fsl-espi: expose maximum transfer size limit
  spi: expose master transfer size limitation.
  spi: zynq: use to_platform_device()
  spi: cadence: use to_platform_device()
  spi: mediatek: Add spi support for mt2701 IC
  spi: mediatek: merge all identical compat to mtk_common_compat
  spi: mtk: Add bindings for mediatek MT2701 soc platform
  spi: mediatek: Prevent overflows in FIFO transfers
  spi: s3c64xx: Remove unused platform_device_id entries
  spi: use to_spi_device
  spi: dw: Use SPI_TMOD_TR rather than magic const 0 to set tmode
  spi: imx: defer spi initialization, if DMA engine is
  spi: imx: return error from dma channel request
  spi: imx: enable loopback only for ECSPI controller family
  spi: imx: fix loopback mode setup after controller reset
  ...