linux.git/drivers/soc/tegra, branch v5.2-rc2

treewide: Add SPDX license identifier - Makefile/Kconfig

2019-05-21T08:50:46+00:00

Add SPDX license identifiers to all Make/Kconfig files which:

 - Have no license information of any form

These files fall under the project license, GPL v2 only. The resulting SPDX
license identifier is:

  GPL-2.0-only

Signed-off-by: Thomas Gleixner 
Signed-off-by: Greg Kroah-Hartman

soc/tegra: pmc: Move powergate initialisation to probe

2019-04-17T08:32:33+00:00

Commit 8df127456f29 ("soc/tegra: pmc: Enable XUSB partitions on boot")
was added as a workaround to ensure that the XUSB powergates or domains
were turned on early during boot because as this time the Tegra XHCI
driver did not handle the power domains at all. Now that the Tegra XHCI
driver has been updated to properly managed the power domains, the
workaround to enable the XUSB power domain early has been removed. This
also means that we can now move the initialisation of the powergates
into the PMC driver probe. Therefore, move the powergate initialisation
into the PMC driver probe and return any errors detected. To handle any
errors, functions to cleanup and remove any power-domains registered
with the generic power-domain framework have been added.

Finally the initialisation of the 'powergates_available' bitmask is kept
in the PMC early init function to allow the legacy PMC powergate APIs to
be called during early boot for enabling secondary CPUs on 32-bit Tegra
devices.

Signed-off-by: Jon Hunter 
Signed-off-by: Thierry Reding

soc/tegra: pmc: Remove reset sysfs entries on error

2019-04-17T08:32:08+00:00

Commit 5f84bb1a4099 ("soc/tegra: pmc: Add sysfs entries for reset info")
added sysfs entries for Tegra reset source and level. However, these
sysfs are not removed on error and so if the registering of PMC device
is probe deferred, then the next time we attempt to probe the PMC device
warnings such as the following will be displayed on boot ...

  sysfs: cannot create duplicate filename '/devices/platform/7000e400.pmc/reset_reason'

Fix this by calling device_remove_file() for each sysfs entry added on
failure. Note that we call device_remove_file() unconditionally without
checking if the sysfs entry was created in the first place, but this
should be OK because kernfs_remove_by_name_ns() will fail silently.

Fixes: 5f84bb1a4099 ("soc/tegra: pmc: Add sysfs entries for reset info")
Signed-off-by: Jon Hunter 
Signed-off-by: Thierry Reding

soc/tegra: pmc: Fix reset sources and levels

2019-04-17T08:30:08+00:00

Commit 5f84bb1a4099 ("soc/tegra: pmc: Add sysfs entries for reset info")
added support for reading the Tegra reset source and level from sysfs.
However, there are a few issues with this commit which are ...
1. The number of reset sources for Tegra210 is defined as 5 but it
   should be 6.
2. The number of reset sources for Tegra186 is defined as 13 but it
   should be 15.
3. The SoC data variables num_reset_sources and num_reset_levels are
   defined but never used.

Fix the above by ...

1. Removing the reset source 'AOTAG' from the tegra30_reset_sources
   because this is only applicable for Tegra210.
2. Adding a new tegra210_reset_sources structure for Tegra210 reset
   sources.
3. Correct the number of reset sources for Tegra210 and Tegra186 by
   using the ARRAY_SIZE macro.
4. Updating the functions reset_reason_show() and reset_level_show()
   to check whether the value read is valid. While we are at it
   clean-up these functions to remove an unnecessary u32 variable.

Fixes: 5f84bb1a4099 ("soc/tegra: pmc: Add sysfs entries for reset info")
Signed-off-by: Jon Hunter 
Signed-off-by: Thierry Reding

soc/tegra: pmc: Implement acquire/release for resets

2019-03-22T13:05:07+00:00

By implementing the acquire/release protocol, the resets can be shared
with other drivers that also adhere to this protocol. This will be used
for example by the SOR driver to put hardware into a known good state,
irrespective of whether or not the power domain can be reset.

Signed-off-by: Thierry Reding

Merge tag 'armsoc-drivers' of git://git.kernel.org/pub/scm/linux/kernel/git/soc/soc

2019-03-06T17:41:12+00:00

Pull ARM SoC driver updates from Arnd Bergmann:
 "As usual, the drivers/tee and drivers/reset subsystems get merged
  here, with the expected set of smaller updates and some new hardware
  support. The tee subsystem now supports device drivers to be attached
  to a tee, the first example here is a random number driver with its
  implementation in the secure world.

  Three new power domain drivers get added for specific chip families:
   - Broadcom BCM283x chips (used in Raspberry Pi)
   - Qualcomm Snapdragon phone chips
   - Xilinx ZynqMP FPGA SoCs

  One new driver is added to talk to the BPMP firmware on NVIDIA
  Tegra210

  Existing drivers are extended for new SoC variants from NXP, NVIDIA,
  Amlogic and Qualcomm"

* tag 'armsoc-drivers' of git://git.kernel.org/pub/scm/linux/kernel/git/soc/soc: (113 commits)
  tee: optee: update optee_msg.h and optee_smc.h to dual license
  tee: add cancellation support to client interface
  dpaa2-eth: configure the cache stashing amount on a queue
  soc: fsl: dpio: configure cache stashing destination
  soc: fsl: dpio: enable frame data cache stashing per software portal
  soc: fsl: guts: make fsl_guts_get_svr() static
  hwrng: make symbol 'optee_rng_id_table' static
  tee: optee: Fix unsigned comparison with less than zero
  hwrng: Fix unsigned comparison with less than zero
  tee: fix possible error pointer ctx dereferencing
  hwrng: optee: Initialize some structs using memset instead of braces
  tee: optee: Initialize some structs using memset instead of braces
  soc: fsl: dpio: fix memory leak of a struct qbman on error exit path
  clk: tegra: dfll: Make symbol 'tegra210_cpu_cvb_tables' static
  soc: qcom: llcc-slice: Fix typos
  qcom: soc: llcc-slice: Consolidate some code
  qcom: soc: llcc-slice: Clear the global drv_data pointer on error
  drivers: soc: xilinx: Add ZynqMP power domain driver
  firmware: xilinx: Add APIs to control node status/power
  dt-bindings: power: Add ZynqMP power domain bindings
  ...

soc/tegra: default select TEGRA_TIMER for Tegra210

2019-02-23T11:13:45+00:00

The tegra timer is necessary for Tegra210 to support CPU idle power-down
state. So select it by default.

Signed-off-by: Joseph Lo 
Acked-by: Thierry Reding 
Acked-by: Jon Hunter 
Signed-off-by: Daniel Lezcano

soc/tegra: pmc: Support systems where PMC is marked secure

2019-01-25T15:18:24+00:00

On Tegra210 systems with new enough boot software, direct register
accesses to PMC register space from the non-secure world are not
allowed. Instead a monitor call may be used to read and write PMC
registers.

Add code to detect such a system by attempting to write a scratch
register and detecting if the write happened or not. If not, we switch
to doing all register accesses through the monitor call.

Signed-off-by: Mikko Perttunen 
Signed-off-by: Thierry Reding 
Acked-by: Jon Hunter

soc/tegra: pmc: Explicitly initialize all fields

2019-01-25T15:18:24+00:00

It's not strictly necessary to initialize the fields in struct
tegra_pmc_soc if they are 0/false. However, we already initialize them
explicitly even if unnecessary, so keep doing that for consistency.

Signed-off-by: Thierry Reding 
Acked-by: Jon Hunter

soc/tegra: pmc: Make alignment consistent

2019-01-25T15:18:23+00:00

Some recently added code used weird alignment and indentation. Fix these
occurrences to make them consistent with the rest of the code.

Signed-off-by: Thierry Reding 
Acked-by: Jon Hunter