This driver does not use any symbols from gpiolib-of.c. There's no
reason for it to select OF_GPIO directly. This addresses a kismet issue
reported by the build bot.

Fixes: 8e86af65f39d ("pinctrl: at91: allow building the module with COMPILE_TEST=y")
Reported-by: kernel test robot <lkp@intel.com>
Closes: https://lore.kernel.org/oe-kbuild-all/202505010447.kUlI61vt-lkp@intel.com/
Signed-off-by: Bartosz Golaszewski <bartosz.golaszewski@linaro.org>
Link: https://lore.kernel.org/20250502100841.113091-1-brgl@bgdev.pl
Signed-off-by: Linus Walleij <linus.walleij@linaro.org>

Extend the build coverage by allowing to build the module with
COMPILE_TEST enabled. We can do this as the driver doesn't depend on any
architecture-specific bits.

Signed-off-by: Bartosz Golaszewski <bartosz.golaszewski@linaro.org>
Link: https://lore.kernel.org/20250424-gpiochip-set-rv-pinctrl-part2-v1-8-504f91120b99@linaro.org
Signed-off-by: Linus Walleij <linus.walleij@linaro.org>

The AMD Image Signal Processor GPIO pin control functionality is only
present on AMD platforms with ISP support, and its platform device is
instantiated by the AMD ISP driver.  Hence add a dependency on
DRM_AMD_ISP, to prevent asking the user about this driver when
configuring a kernel that does not support the AMD ISP.

Fixes: e97435ab09f3ad7b ("pinctrl: amd: isp411: Add amdisp GPIO pinctrl")
Signed-off-by: Geert Uytterhoeven <geert+renesas@glider.be>
Link: https://lore.kernel.org/3685561e8e3cd1d94bce220eeb6001d659da615c.1742306024.git.geert+renesas@glider.be
Signed-off-by: Linus Walleij <linus.walleij@linaro.org>

Add pinctrl driver support for AMD SoC with isp41 hw ip block.

Signed-off-by: Pratap Nirujogi <pratap.nirujogi@amd.com>
Link: https://lore.kernel.org/20250304232051.2936557-1-pratap.nirujogi@amd.com
Signed-off-by: Linus Walleij <linus.walleij@linaro.org>

SpacemiT's K1 SoC has a pinctrl controller which use single register
to describe all functions, which include bias pull up/down(strong pull),
drive strength, schmitter trigger, slew rate, mux mode.

Signed-off-by: Yixun Lan <dlan@gentoo.org>
Link: https://lore.kernel.org/20241016-02-k1-pinctrl-v5-2-03d395222e4f@gentoo.org
Signed-off-by: Linus Walleij <linus.walleij@linaro.org>

The Canaan Kendryte K230 pin controller is only present on Canaan
Kendryte K230 SoCs.  Hence add a dependency on ARCH_CANAAN, to prevent
asking the user about this driver when configuring a kernel without
Canaan Kendryte series SoC platform support.

Fixes: 545887eab6f6776a ("pinctrl: canaan: Add support for k230 SoC")
Signed-off-by: Geert Uytterhoeven <geert+renesas@glider.be>
Link: https://lore.kernel.org/d70279ba02a67250203744b38314f4475b3c5671.1728986052.git.geert+renesas@glider.be
Signed-off-by: Linus Walleij <linus.walleij@linaro.org>

When compile-testing without CONfIG_OF:

drivers/pinctrl/pinctrl-th1520.c: In function 'th1520_pinctrl_dt_node_to_map':
drivers/pinctrl/pinctrl-th1520.c:455:23: error: implicit declaration of function 'pinconf_generic_parse_dt_config'; did you mean 'pinconf_generic_dump_config'? [-Wimplicit-function-declaration]
  455 |                 ret = pinconf_generic_parse_dt_config(child, pctldev, &configs, &nconfigs);
      |                       ^~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~
      |                       pinconf_generic_dump_config

Enforce this using Kconig dependencies.

Fixes: bed5cd6f8a98 ("pinctrl: Add driver for the T-Head TH1520 SoC")
Signed-off-by: Arnd Bergmann <arnd@arndb.de>
Acked-by: Drew Fustini <drew@pdp7.com>
Link: https://lore.kernel.org/20241015151126.2401855-1-arnd@kernel.org
Signed-off-by: Linus Walleij <linus.walleij@linaro.org>

Configuration of the K230 is similar to that of the K210. However, in
K210, the 256 functions for each pin are shared, whereas in K230,
multiplex functions are different for every pin.

`drv_data` of `pinctrl_pin_desc` is pointing to currently activated
group, which is used to print the name of current function of pin in
`pin_dbg_show` and will be updated in `set_mux`, so they are not set
const.

Signed-off-by: Ze Huang <18771902331@163.com>
Link: https://lore.kernel.org/20240926-k230-pinctrl-v2-2-a9a36fba4b34@163.com
Signed-off-by: Linus Walleij <linus.walleij@linaro.org>

Add pinctrl driver for the T-Head TH1520 RISC-V SoC.

Tested-by: Thomas Bonnefille <thomas.bonnefille@bootlin.com>
Signed-off-by: Emil Renner Berthing <emil.renner.berthing@canonical.com>
[dfustini: use thead,pad-group to identify the pin controller instance]
Signed-off-by: Drew Fustini <dfustini@tenstorrent.com>
Link: https://lore.kernel.org/20240930-th1520-pinctrl-v3-2-32cea2bdbecb@tenstorrent.com
Signed-off-by: Linus Walleij <linus.walleij@linaro.org>

Pull SoC update from Arnd Bergmann:
 "Convert ep93xx to devicetree

  This concludes a long journey towards replacing the old board files
  with devictree description on the Cirrus Logic EP93xx platform.

  Nikita Shubin has been working on this for a long time, for details
  see the last post on

    https://lore.kernel.org/lkml/20240909-ep93xx-v12-0-e86ab2423d4b@maquefel.me/"

* tag 'soc-ep93xx-dt-6.12' of git://git.kernel.org/pub/scm/linux/kernel/git/soc/soc: (47 commits)
  dt-bindings: gpio: ep9301: Add missing "#interrupt-cells" to examples
  MAINTAINERS: Update EP93XX ARM ARCHITECTURE maintainer
  soc: ep93xx: drop reference to removed EP93XX_SOC_COMMON config
  net: cirrus: use u8 for addr to calm down sparse
  dmaengine: cirrus: use snprintf() to calm down gcc 13.3.0
  dmaengine: ep93xx: Fix a NULL vs IS_ERR() check in probe()
  pinctrl: ep93xx: Fix raster pins typo
  spi: ep93xx: update kerneldoc comments for ep93xx_spi
  clk: ep93xx: Fix off by one in ep93xx_div_recalc_rate()
  clk: ep93xx: add module license
  dmaengine: cirrus: remove platform code
  ASoC: cirrus: edb93xx: Delete driver
  ARM: ep93xx: soc: drop defines
  ARM: ep93xx: delete all boardfiles
  ata: pata_ep93xx: remove legacy pinctrl use
  pwm: ep93xx: drop legacy pinctrl
  ARM: ep93xx: DT for the Cirrus ep93xx SoC platforms
  ARM: dts: ep93xx: Add EDB9302 DT
  ARM: dts: ep93xx: add ts7250 board
  ARM: dts: add Cirrus EP93XX SoC .dtsi
  ...