linux.git/drivers/net/wireless/ti, branch v5.10

wl1251/wl12xx: fix a typo in comments

2020-09-29T08:24:58+00:00

Modify the comment typo: "compliment" -> "complement".

Signed-off-by: Wang Qing 
Signed-off-by: Kalle Valo 
Link: https://lore.kernel.org/r/1601087891-11281-1-git-send-email-wangqing@vivo.com

Merge tag 'wireless-drivers-next-2020-09-25' of git://git.kernel.org/pub/scm/linux/kernel/git/kvalo/wireless-drivers-next

2020-09-25T20:16:29+00:00

Kalle Valo says:

====================
wireless-drivers-next patches for v5.10

Second set of patches for v5.10. Biggest change here is wcn3680
support to wcn36xx driver, otherwise smaller features. And naturally
the usual fixes and cleanups.

Major changes:

brcmfmac

* support 4-way handshake offloading for WPA/WPA2-PSK in AP mode

* support SAE authentication offload in AP mode

mt76

* mt7663 runtime power management improvements

* mt7915 A-MSDU offload

wcn36xx

* add support wcn3680 Wi-Fi 5 devices

ath11k

* spectral scan support for ipq6018
====================

Signed-off-by: David S. Miller

Merge git://git.kernel.org/pub/scm/linux/kernel/git/netdev/net

2020-09-22T23:45:34+00:00

Two minor conflicts:

1) net/ipv4/route.c, adding a new local variable while
   moving another local variable and removing it's
   initial assignment.

2) drivers/net/dsa/microchip/ksz9477.c, overlapping changes.
   One pretty prints the port mode differently, whilst another
   changes the driver to try and obtain the port mode from
   the port node rather than the switch node.

Signed-off-by: David S. Miller

wlcore: Remove unused function no_write_handler()

2020-09-22T07:14:42+00:00

There is no caller in tree, so can remove it.

Signed-off-by: YueHaibing 
Signed-off-by: Kalle Valo 
Link: https://lore.kernel.org/r/20200918131305.20976-1-yuehaibing@huawei.com

wlcore: Remove unused macro WL1271_SUSPEND_SLEEP

2020-09-16T06:07:49+00:00

commit 45aa7f071b06 ("wlcore: Use generic runtime pm calls for wowlan elp configuration")
left behind this, remove it.

Signed-off-by: YueHaibing 
Signed-off-by: Kalle Valo 
Link: https://lore.kernel.org/r/20200909135905.35728-1-yuehaibing@huawei.com

Revert "wlcore: Adding suppoprt for IGTK key in wlcore driver"

2020-09-07T08:39:32+00:00

This patch causes a regression betwen Kernel 5.7 and 5.8 at wlcore:
with it applied, WiFi stops working, and the Kernel starts printing
this message every second:

   wlcore: PHY firmware version: Rev 8.2.0.0.242
   wlcore: firmware booted (Rev 8.9.0.0.79)
   wlcore: ERROR command execute failure 14
   ------------[ cut here ]------------
   WARNING: CPU: 0 PID: 133 at drivers/net/wireless/ti/wlcore/main.c:795 wl12xx_queue_recovery_work.part.0+0x6c/0x74 [wlcore]
   Modules linked in: wl18xx wlcore mac80211 libarc4 cfg80211 rfkill snd_soc_hdmi_codec crct10dif_ce wlcore_sdio adv7511 cec kirin9xx_drm(C) kirin9xx_dw_drm_dsi(C) drm_kms_helper drm ip_tables x_tables ipv6 nf_defrag_ipv6
   CPU: 0 PID: 133 Comm: kworker/0:1 Tainted: G        WC        5.8.0+ #186
   Hardware name: HiKey970 (DT)
   Workqueue: events_freezable ieee80211_restart_work [mac80211]
   pstate: 60000005 (nZCv daif -PAN -UAO BTYPE=--)
   pc : wl12xx_queue_recovery_work.part.0+0x6c/0x74 [wlcore]
   lr : wl12xx_queue_recovery_work+0x24/0x30 [wlcore]
   sp : ffff8000126c3a60
   x29: ffff8000126c3a60 x28: 00000000000025de
   x27: 0000000000000010 x26: 0000000000000005
   x25: ffff0001a5d49e80 x24: ffff8000092cf580
   x23: ffff0001b7c12623 x22: ffff0001b6fcf2e8
   x21: ffff0001b7e46200 x20: 00000000fffffffb
   x19: ffff0001a78e6400 x18: 0000000000000030
   x17: 0000000000000001 x16: 0000000000000001
   x15: ffff0001b7e46670 x14: ffffffffffffffff
   x13: ffff8000926c37d7 x12: ffff8000126c37e0
   x11: ffff800011e01000 x10: ffff8000120526d0
   x9 : 0000000000000000 x8 : 3431206572756c69
   x7 : 6166206574756365 x6 : 0000000000000c2c
   x5 : 0000000000000000 x4 : ffff0001bf1361e8
   x3 : ffff0001bf1790b0 x2 : 0000000000000000
   x1 : ffff0001a5d49e80 x0 : 0000000000000001
   Call trace:
    wl12xx_queue_recovery_work.part.0+0x6c/0x74 [wlcore]
    wl12xx_queue_recovery_work+0x24/0x30 [wlcore]
    wl1271_cmd_set_sta_key+0x258/0x25c [wlcore]
    wl1271_set_key+0x7c/0x2dc [wlcore]
    wlcore_set_key+0xe4/0x360 [wlcore]
    wl18xx_set_key+0x48/0x1d0 [wl18xx]
    wlcore_op_set_key+0xa4/0x180 [wlcore]
    ieee80211_key_enable_hw_accel+0xb0/0x2d0 [mac80211]
    ieee80211_reenable_keys+0x70/0x110 [mac80211]
    ieee80211_reconfig+0xa00/0xca0 [mac80211]
    ieee80211_restart_work+0xc4/0xfc [mac80211]
    process_one_work+0x1cc/0x350
    worker_thread+0x13c/0x470
    kthread+0x154/0x160
    ret_from_fork+0x10/0x30
   ---[ end trace b1f722abf9af5919 ]---
   wlcore: WARNING could not set keys
   wlcore: ERROR Could not add or replace key
   wlan0: failed to set key (4, ff:ff:ff:ff:ff:ff) to hardware (-5)
   wlcore: Hardware recovery in progress. FW ver: Rev 8.9.0.0.79
   wlcore: pc: 0x0, hint_sts: 0x00000040 count: 39
   wlcore: down
   wlcore: down
   ieee80211 phy0: Hardware restart was requested
   mmc_host mmc0: Bus speed (slot 0) = 400000Hz (slot req 400000Hz, actual 400000HZ div = 0)
   mmc_host mmc0: Bus speed (slot 0) = 25000000Hz (slot req 25000000Hz, actual 25000000HZ div = 0)
   wlcore: PHY firmware version: Rev 8.2.0.0.242
   wlcore: firmware booted (Rev 8.9.0.0.79)
   wlcore: ERROR command execute failure 14
   ------------[ cut here ]------------

Tested on Hikey 970.

This reverts commit 2b7aadd3b9e17e8b81eeb8d9cc46756ae4658265.

Signed-off-by: Mauro Carvalho Chehab 
Signed-off-by: Kalle Valo 
Link: https://lore.kernel.org/r/f0a2cb7ea606f1a284d4c23cbf983da2954ce9b6.1598420968.git.mchehab+huawei@kernel.org

wlcore: debugfs: Remove unused variable 'res'

2020-09-01T13:14:44+00:00

Fixes the following W=1 kernel build warning(s):

Cc: Kalle Valo 
Cc: "David S. Miller" 
Cc: Jakub Kicinski 
Cc: Luciano Coelho 
Cc: linux-wireless@vger.kernel.org
Cc: netdev@vger.kernel.org
Signed-off-by: Lee Jones 
Signed-off-by: Kalle Valo 
Link: https://lore.kernel.org/r/20200826093401.1458456-16-lee.jones@linaro.org

wlcore: cmd: Fix some parameter description disparities

2020-09-01T09:02:38+00:00

Firstly a rename, then a split (there are 2 'len's that need documenting).

Fixes the following W=1 kernel build warning(s):

 drivers/net/wireless/ti/wlcore/cmd.c:832: warning: Function parameter or member 'buf_len' not described in 'wl1271_cmd_test'
 drivers/net/wireless/ti/wlcore/cmd.c:832: warning: Excess function parameter 'len' description in 'wl1271_cmd_test'
 drivers/net/wireless/ti/wlcore/cmd.c:862: warning: Function parameter or member 'cmd_len' not described in 'wl1271_cmd_interrogate'
 drivers/net/wireless/ti/wlcore/cmd.c:862: warning: Function parameter or member 'res_len' not described in 'wl1271_cmd_interrogate'
 drivers/net/wireless/ti/wlcore/cmd.c:862: warning: Excess function parameter 'len' description in 'wl1271_cmd_interrogate'

Cc: Kalle Valo 
Cc: "David S. Miller" 
Cc: Jakub Kicinski 
Cc: Hari Nagalla 
Cc: Guy Mishol 
Cc: Maital Hahn 
Cc: Luciano Coelho 
Cc: linux-wireless@vger.kernel.org
Cc: netdev@vger.kernel.org
Signed-off-by: Lee Jones 
Signed-off-by: Kalle Valo 
Link: https://lore.kernel.org/r/20200819072402.3085022-7-lee.jones@linaro.org

wl1251, wlcore: fix spelling mistake "buld" -> "build"

2020-08-18T12:50:31+00:00

There are spelling mistakes in warning messages. Fix these.

Signed-off-by: Colin Ian King 
Signed-off-by: Kalle Valo 
Link: https://lore.kernel.org/r/20200806113326.53779-1-colin.king@canonical.com

wl1251: fix always return 0 error

2020-08-02T15:25:14+00:00

wl1251_event_ps_report() should not always return 0 because
wl1251_ps_set_mode() may fail. Change it to return 'ret'.

Fixes: f7ad1eed4d4b ("wl1251: retry power save entry")
Reported-by: Hulk Robot 
Signed-off-by: Wang Hai 
Signed-off-by: Kalle Valo 
Link: https://lore.kernel.org/r/20200730073939.33704-1-wanghai38@huawei.com