linux.git/drivers/net/wireless/ath5k, branch master

atheros: put atheros wireless drivers into ath/

2009-04-22T20:54:38+00:00

Signed-off-by: Luis R. Rodriguez 
Signed-off-by: John W. Linville

ath5k: use regulatory infrastructure

2009-04-22T20:54:37+00:00

Make ath5k select the ath module and add in the hooks to make the
eeprom regulatory hint and reg notifier take effect.

Changes to attach.c
Changes-licensed-under: ISC

Changes to base.c
Changes-licensed-under: 3-Clause-BSD

Signed-off-by: Bob Copeland 
Signed-off-by: John W. Linville

ath5k: reduce exported channel list

2009-04-22T20:54:35+00:00

Claiming every available 5 ghz channel has a couple of negative
side-effects: scanning takes a long time, and the channel list
overflows the available buffer space for netlink commands,
resulting in:

    $ iw phy phy0 info
    command failed: No buffer space available (-105)

This patch adds a modparam so people who want to see all the channels
can do so by passing all_channels=1.  By default users will see a
smaller list of channels.  This also halves scan time, from 10 seconds
down to less than 5 when using world regulatory.

Changes-licensed-under: 3-Clause-BSD

Signed-off-by: Bob Copeland 
Reported-by: Simon Farnsworth 
Tested-By: Simon Farnsworth 
Signed-off-by: John W. Linville

ath5k: fix scanning in AR2424

2009-04-22T20:54:29+00:00

AR5K_PHY_PLL_40MHZ_5413 should not be ORed with AR5K_PHY_MODE_RAD_RF5112
for 5 GHz channels.

The incorrect PLL value breaks scanning in the countries where 5 GHz
channels are allowed.

Signed-off-by: Pavel Roskin 
Acked-by: Nick Kossifidis 
Signed-off-by: John W. Linville

drivers/net: replace BUG() with BUG_ON() if possible

2009-04-13T22:44:36+00:00

Signed-off-by: Alexander Beregalov 
Signed-off-by: David S. Miller

dma-mapping: replace all DMA_32BIT_MASK macro with DMA_BIT_MASK(32)

2009-04-07T15:31:11+00:00

Replace all DMA_32BIT_MASK macro with DMA_BIT_MASK(32)

Signed-off-by: Yang Hongyang
Signed-off-by: Andrew Morton 
Signed-off-by: Linus Torvalds

ath5k: properly drop packets from ops->tx

2009-03-28T00:13:19+00:00

We shouldn't return NETDEV_TX_BUSY from the TX callback, especially
after we've mucked with the sk_buffs.  Drop the packets and return
NETDEV_TX_OK.

Changes-licensed-under: 3-Clause-BSD

Signed-off-by: Bob Copeland 
Signed-off-by: John W. Linville

ath5k: warn and correct rate for unknown hw rate indexes

2009-03-28T00:13:18+00:00

ath5k sets up a mapping table from the hardware rate index to
the rate index used by mac80211; however, we have seen some
received frames with incorrect rate indexes.  Such frames
normally get dropped with a warning in __ieee80211_rx(),
but it doesn't include enough information to track down the
error.

This patch adds a warning to hw_to_driver_rix for any lookups
that result in a rate index of -1, then returns a valid rate so
the frame can be processed.

Changes-licensed-under: 3-Clause-BSD

Signed-off-by: Bob Copeland 
Cc: stable@kernel.org
Signed-off-by: John W. Linville

ath5k: Support LED's on Acer Extensa 5620z

2009-03-28T00:13:10+00:00

Add vendor ID for Quanta Microsystems and update the led table with the reported device.

Reported-by: Scott Barnes 

Signed-off-by: Tulio Magno Quites Machado Filho 
Signed-off-by: John W. Linville

ath5k: Add tx power calibration support

2009-03-28T00:12:56+00:00

* Add tx power calibration support
* Add a few tx power limits
* Hardcode default power to 12.5dB
* Disable TPC for now

v2: Address Jiri's comments

Signed-off-by: Nick Kossifidis 
Signed-off-by: John W. Linville