linux.git/drivers/net/usb, branch v4.0-rc6

cx82310_eth: wait for firmware to become ready

2015-03-21T22:23:19+00:00

When the device is powered up, some (older) firmware versions fail to work
properly if we send commands before the boot is complete (everything is OK
when the device is hot-plugged). The firmware indicates its ready status by
putting the link up.
Newer firmwares delay the first command so they don't suffer from this problem.
They also report the link being always up.

Wait for firmware to become ready (link up) before sending any commands and/or
data.

This also allows lowering CMD_TIMEOUT value to a reasonable time.

Tested with 4.1.0.9 (old) and 4.1.0.30 (new) firmware versions.

Signed-off-by: Ondrej Zary 
Signed-off-by: David S. Miller

Revert "net: cx82310_eth: use common match macro"

2015-03-19T02:37:38+00:00

This reverts commit 11ad714b98f6d9ca0067568442afe3e70eb94845 because
it breaks cx82310_eth.

The custom USB_DEVICE_CLASS macro matches
bDeviceClass, bDeviceSubClass and bDeviceProtocol
but the common USB_DEVICE_AND_INTERFACE_INFO matches
bInterfaceClass, bInterfaceSubClass and bInterfaceProtocol instead, which are
not specified.

Signed-off-by: Ondrej Zary 
Signed-off-by: David S. Miller

Merge git://git.kernel.org/pub/scm/linux/kernel/git/davem/net

2015-03-03T23:30:07+00:00

Pull networking fixes from David Miller:

 1) If an IPVS tunnel is created with a mixed-family destination
    address, it cannot be removed.  Fix from Alexey Andriyanov.

 2) Fix module refcount underflow in netfilter's nft_compat, from Pablo
    Neira Ayuso.

 3) Generic statistics infrastructure can reference variables sitting on
    a released function stack, therefore use dynamic allocation always.
    Fix from Ignacy Gawędzki.

 4) skb_copy_bits() return value test is inverted in ip_check_defrag().

 5) Fix network namespace exit in openvswitch, we have to release all of
    the per-net vports.  From Pravin B Shelar.

 6) Fix signedness bug in CAIF's cfpkt_iterate(), from Dan Carpenter.

 7) Fix rhashtable grow/shrink behavior, only expand during inserts and
    shrink during deletes.  From Daniel Borkmann.

 8) Netdevice names with semicolons should never be allowed, because
    they serve as a separator.  From Matthew Thode.

 9) Use {,__}set_current_state() where appropriate, from Fabian
    Frederick.

10) Revert byte queue limits support in r8169 driver, it's causing
    regressions we can't figure out.

11) tcp_should_expand_sndbuf() erroneously uses tp->packets_out to
    measure packets in flight, properly use tcp_packets_in_flight()
    instead.  From Neal Cardwell.

12) Fix accidental removal of support for bluetooth in CSR based Intel
    wireless cards.  From Marcel Holtmann.

13) We accidently added a behavioral change between native and compat
    tasks, wrt testing the MSG_CMSG_COMPAT bit.  Just ignore it if the
    user happened to set it in a native binary as that was always the
    behavior we had.  From Catalin Marinas.

14) Check genlmsg_unicast() return valud in hwsim netlink tx frame
    handling, from Bob Copeland.

15) Fix stale ->radar_required setting in mac80211 that can prevent
    starting new scans, from Eliad Peller.

16) Fix memory leak in nl80211 monitor, from Johannes Berg.

17) Fix race in TX index handling in xen-netback, from David Vrabel.

18) Don't enable interrupts in amx-xgbe driver until all software et al.
    state is ready for the interrupt handler to run.  From Thomas
    Lendacky.

19) Add missing netlink_ns_capable() checks to rtnl_newlink(), from Eric
    W Biederman.

20) The amount of header space needed in macvtap was not calculated
    properly, fix it otherwise we splat past the beginning of the
    packet.  From Eric Dumazet.

21) Fix bcmgenet TCP TX perf regression, from Jaedon Shin.

22) Don't raw initialize or mod timers, use setup_timer() and
    mod_timer() instead.  From Vaishali Thakkar.

23) Fix software maintained statistics in bcmgenet and systemport
    drivers, from Florian Fainelli.

24) DMA descriptor updates in sh_eth need proper memory barriers, from
    Ben Hutchings.

25) Don't do UDP Fragmentation Offload on RAW sockets, from Michal
    Kubecek.

26) Openvswitch's non-masked set actions aren't constructed properly
    into netlink messages, fix from Joe Stringer.

* git://git.kernel.org/pub/scm/linux/kernel/git/davem/net: (116 commits)
  openvswitch: Fix serialization of non-masked set actions.
  gianfar: Reduce logging noise seen due to phy polling if link is down
  ibmveth: Add function to enable live MAC address changes
  net: bridge: add compile-time assert for cb struct size
  udp: only allow UFO for packets from SOCK_DGRAM sockets
  sh_eth: Really fix padding of short frames on TX
  Revert "sh_eth: Enable Rx descriptor word 0 shift for r8a7790"
  sh_eth: Fix RX recovery on R-Car in case of RX ring underrun
  sh_eth: Ensure proper ordering of descriptor active bit write/read
  net/mlx4_en: Disbale GRO for incoming loopback/selftest packets
  net/mlx4_core: Fix wrong mask and error flow for the update-qp command
  net: systemport: fix software maintained statistics
  net: bcmgenet: fix software maintained statistics
  rxrpc: don't multiply with HZ twice
  rxrpc: terminate retrans loop when sending of skb fails
  net/hsr: Fix NULL pointer dereference and refcnt bugs when deleting a HSR interface.
  net: pasemi: Use setup_timer and mod_timer
  net: stmmac: Use setup_timer and mod_timer
  net: 8390: axnet_cs: Use setup_timer and mod_timer
  net: 8390: pcnet_cs: Use setup_timer and mod_timer
  ...

net: asix: add support for the Sitecom LN-028 USB adapter

2015-02-27T22:12:20+00:00

Just another AX88178-based 10/100/1000 USB-to-Ethernet dongle. This one
shows up in lsusb as: "Sitecom Europe B.V. LN-028 Network USB 2.0 Adapter".

Signed-off-by: Luca Ceresoli 
Cc: Francois Romieu 
Cc: "David S. Miller" 
Cc: linux-usb@vger.kernel.org
Cc: linux-kernel@vger.kernel.org
Signed-off-by: David S. Miller

hso: replace current->state by __set_current_state()

2015-02-22T20:24:10+00:00

Use helper functions to access current->state.
Direct assignments are prone to races and therefore buggy.

Thanks to Peter Zijlstra for the exact definition of the problem.

Suggested-By: Peter Zijlstra 
Signed-off-by: Fabian Frederick 
Signed-off-by: David S. Miller

usb: plusb: Add support for National Instruments host-to-host cable

2015-02-20T20:12:48+00:00

The National Instruments USB Host-to-Host Cable is based on the Prolific
PL-25A1 chipset.  Add its VID/PID so the plusb driver will recognize it.

Signed-off-by: Ben Shelton 
Signed-off-by: David S. Miller

Merge branch 'kconfig' of git://git.kernel.org/pub/scm/linux/kernel/git/mmarek/kbuild

2015-02-19T18:36:45+00:00

Pull kconfig updates from Michal Marek:
 "Yann E Morin was supposed to take over kconfig maintainership, but
  this hasn't happened.  So I'm sending a few kconfig patches that I
  collected:

   - Fix for missing va_end in kconfig
   - merge_config.sh displays used if given too few arguments
   - s/boolean/bool/ in Kconfig files for consistency, with the plan to
     only support bool in the future"

* 'kconfig' of git://git.kernel.org/pub/scm/linux/kernel/git/mmarek/kbuild:
  kconfig: use va_end to match corresponding va_start
  merge_config.sh: Display usage if given too few arguments
  kconfig: use bool instead of boolean for type definition attributes

r8152: restore hw settings

2015-02-15T04:15:45+00:00

There is a capability which let the hw could change the settings
automatically when the power change to ON. However, the USB reset
would reset the settings to the hw default, so the driver has to
restore the relative settings. Otherwise, it would influence the
functions of the hw, and the compatibility for the USB hub and
USB host controller.

The relative settings are as following.
 - set the power down scale to 96.
 - enable the power saving function of USB 2.0.
 - disable the ALDPS of ECM mode.
 - set burst mode depending on the burst size.
 - enable the flow control of endpoint full.
 - set fifo empty boundary to 32448 bytes.
 - enable the function of exiting LPM when Rx OK occurs.
 - set the connect timer to 1.

Signed-off-by: Hayes Wang 
Signed-off-by: David S. Miller

hso: fix rx parsing logic when skb allocation fails

2015-02-13T15:17:05+00:00

If skb allocation fails once the IP header has been received, the rx state is
being set to WAIT_SYNC. The logic, though, shouldn't directly return, as the
buffer may contain a full packet, and therefore the WAIT_SYNC state needs to be
processed (resetting state to WAIT_IP, clearing rx_buf_size and re-initializing
rx_buf_missing).

So, just let the while loop continue so that in the next iteration the WAIT_SYNC
state cleanly stops the loop. The WAIT_SYNC processing will be done just after
that, only if the end of packet is flagged.

Signed-off-by: Aleksander Morgado 
Signed-off-by: David S. Miller

r8152: use BIT macro

2015-02-08T06:46:25+00:00

Use BIT macro to replace (1 << bits).

Signed-off-by: Hayes Wang 
Signed-off-by: David S. Miller