linux.git/drivers/net/sfc/ethtool.c, branch v2.6.32

netdev: drivers should make ethtool_ops const

2009-09-02T08:03:33+00:00

No need to put ethtool_ops in data, they should be const.

Signed-off-by: Stephen Hemminger 
Signed-off-by: David S. Miller

sfc: Use generic MDIO flow control auto-negotiation functions

2009-04-30T00:32:37+00:00

Signed-off-by: Ben Hutchings 
Signed-off-by: David S. Miller

sfc: Use generic MDIO functions and definitions

2009-04-30T00:32:30+00:00

Make use of the newly-added generic MDIO clause 45 support and remove
redundant definitions.

Add an 'efx_' prefix to the remaining driver-specific MDIO functions
and remove arguments which are redundant with efx->mdio.prtad.

Signed-off-by: Ben Hutchings 
Signed-off-by: David S. Miller

sfc: Implement adaptive IRQ moderation

2009-03-22T02:06:58+00:00

Calculate a score for each 1000 IRQs:
- TX completions are worth 1 point
- RX completions are worth 4 if merged using LRO or 2 otherwise

Reduce moderation if the score is less than 10000, down to a minimum
of 5 us.  Increase moderation if the score is more than 20000, up to
the specified maximum.

Signed-off-by: Ben Hutchings 
Signed-off-by: David S. Miller

sfc: Fix efx_ethtool_nway_result() to use clause 45 MDIO registers

2009-03-05T01:40:20+00:00

Signed-off-by: Ben Hutchings 
Signed-off-by: David S. Miller

sfc: SFX7101/SFT9001: Fix AN advertisements

2009-01-30T22:06:32+00:00

All 10Xpress PHYs require autonegotiation all the time; enforce this
in the set_settings() method and do not treat it as a workaround.

Remove claimed support for 100M HD mode since it is not supported by
current firmware.

Do not set speed override bits when AN is enabled, and do not use
register 1.49192 for AN configuration as it can override what we set
elsewhere.

Always set the AN selector bits to 1 (802.3).

Fix confusion between Next Page and Extended Next Page.

Signed-off-by: Ben Hutchings 
Signed-off-by: David S. Miller

sfc: Add support for multiple PHY self-tests

2008-12-26T21:47:25+00:00

Signed-off-by: Ben Hutchings 
Signed-off-by: David S. Miller

sfc: Merge top-level functions for self-tests

2008-12-26T21:47:04+00:00

Pass in ethtool test flags to determine which tests to run.

Signed-off-by: Ben Hutchings 
Signed-off-by: David S. Miller

sfc: Use mutex_lock_interruptible() for ethtool EEPROM access

2008-12-13T06:06:24+00:00

ethtool must contend with the MTD driver for the SPI bus lock, which
may carry out long operations such as flash erase.  Allow it to be
interrupted while waiting.

Signed-off-by: Ben Hutchings 
Signed-off-by: David S. Miller

sfc: Specify a meaningful component for loopback RX-side and PHY tests

2008-12-13T06:05:48+00:00

Our ethtool self-test result names each begin with a component name.  For
some results this is "port0", which is not very meaningful.  Change that
to "rx" or "phy" as appropriate.

Signed-off-by: Ben Hutchings 
Signed-off-by: David S. Miller