linux.git/drivers/net/phy, branch v5.9-rc7

net: phy: Do not warn in phy_stop() on PHY_DOWN

2020-09-17T23:55:35+00:00

When phy_is_started() was added to catch incorrect PHY states,
phy_stop() would not be qualified against PHY_DOWN. It is possible to
reach that state when the PHY driver has been unbound and the network
device is then brought down.

Fixes: 2b3e88ea6528 ("net: phy: improve phy state checking")
Signed-off-by: Florian Fainelli 
Reviewed-by: Andrew Lunn 
Signed-off-by: David S. Miller

net: phy: Avoid NPD upon phy_detach() when driver is unbound

2020-09-17T23:55:35+00:00

If we have unbound the PHY driver prior to calling phy_detach() (often
via phy_disconnect()) then we can cause a NULL pointer de-reference
accessing the driver owner member. The steps to reproduce are:

echo unimac-mdio-0:01 > /sys/class/net/eth0/phydev/driver/unbind
ip link set eth0 down

Fixes: cafe8df8b9bc ("net: phy: Fix lack of reference count on PHY driver")
Signed-off-by: Florian Fainelli 
Reviewed-by: Andrew Lunn 
Signed-off-by: David S. Miller

net: phy: call phy_disable_interrupts() in phy_attach_direct() instead

2020-09-10T19:57:08+00:00

Since the micrel phy driver calls phy_init_hw() as a workaround,
the commit 9886a4dbd2aa ("net: phy: call phy_disable_interrupts()
in phy_init_hw()") disables the interrupt unexpectedly. So,
call phy_disable_interrupts() in phy_attach_direct() instead.
Otherwise, the phy cannot link up after the ethernet cable was
disconnected.

Note that other drivers (like at803x.c) also calls phy_init_hw().
So, perhaps, the driver caused a similar issue too.

Fixes: 9886a4dbd2aa ("net: phy: call phy_disable_interrupts() in phy_init_hw()")
Signed-off-by: Yoshihiro Shimoda 
Signed-off-by: David S. Miller

Merge git://git.kernel.org/pub/scm/linux/kernel/git/netdev/net

2020-09-04T01:50:48+00:00

Pull networking fixes from David Miller:

 1) Use netif_rx_ni() when necessary in batman-adv stack, from Jussi
    Kivilinna.

 2) Fix loss of RTT samples in rxrpc, from David Howells.

 3) Memory leak in hns_nic_dev_probe(), from Dignhao Liu.

 4) ravb module cannot be unloaded, fix from Yuusuke Ashizuka.

 5) We disable BH for too lokng in sctp_get_port_local(), add a
    cond_resched() here as well, from Xin Long.

 6) Fix memory leak in st95hf_in_send_cmd, from Dinghao Liu.

 7) Out of bound access in bpf_raw_tp_link_fill_link_info(), from
    Yonghong Song.

 8) Missing of_node_put() in mt7530 DSA driver, from Sumera
    Priyadarsini.

 9) Fix crash in bnxt_fw_reset_task(), from Michael Chan.

10) Fix geneve tunnel checksumming bug in hns3, from Yi Li.

11) Memory leak in rxkad_verify_response, from Dinghao Liu.

12) In tipc, don't use smp_processor_id() in preemptible context. From
    Tuong Lien.

13) Fix signedness issue in mlx4 memory allocation, from Shung-Hsi Yu.

14) Missing clk_disable_prepare() in gemini driver, from Dan Carpenter.

15) Fix ABI mismatch between driver and firmware in nfp, from Louis
    Peens.

* git://git.kernel.org/pub/scm/linux/kernel/git/netdev/net: (110 commits)
  net/smc: fix sock refcounting in case of termination
  net/smc: reset sndbuf_desc if freed
  net/smc: set rx_off for SMCR explicitly
  net/smc: fix toleration of fake add_link messages
  tg3: Fix soft lockup when tg3_reset_task() fails.
  doc: net: dsa: Fix typo in config code sample
  net: dp83867: Fix WoL SecureOn password
  nfp: flower: fix ABI mismatch between driver and firmware
  tipc: fix shutdown() of connectionless socket
  ipv6: Fix sysctl max for fib_multipath_hash_policy
  drivers/net/wan/hdlc: Change the default of hard_header_len to 0
  net: gemini: Fix another missing clk_disable_unprepare() in probe
  net: bcmgenet: fix mask check in bcmgenet_validate_flow()
  amd-xgbe: Add support for new port mode
  net: usb: dm9601: Add USB ID of Keenetic Plus DSL
  vhost: fix typo in error message
  net: ethernet: mlx4: Fix memory allocation in mlx4_buddy_init()
  pktgen: fix error message with wrong function name
  net: ethernet: ti: am65-cpsw: fix rmii 100Mbit link mode
  cxgb4: fix thermal zone device registration
  ...

net: dp83867: Fix WoL SecureOn password

2020-09-02T23:04:59+00:00

Fix the registers being written to as the values were being over written
when writing the same registers.

Fixes: caabee5b53f5 ("net: phy: dp83867: support Wake on LAN")
Signed-off-by: Dan Murphy 
Reviewed-by: Andrew Lunn 
Reviewed-by: Florian Fainelli 
Signed-off-by: David S. Miller

net: dp83869: Fix RGMII internal delay configuration

2020-08-26T14:13:28+00:00

The RGMII control register at 0x32 indicates the states for the bits
RGMII_TX_CLK_DELAY and RGMII_RX_CLK_DELAY as follows:

  RGMII Transmit/Receive Clock Delay
    0x0 = RGMII transmit clock is shifted with respect to transmit/receive data.
    0x1 = RGMII transmit clock is aligned with respect to transmit/receive data.

This commit fixes the inversed behavior of these bits

Fixes: 736b25afe284 ("net: dp83869: Add RGMII internal delay configuration")
Signed-off-by: Daniel Gorsulowski 
Acked-by: Dan Murphy 
Signed-off-by: David S. Miller

treewide: Use fallthrough pseudo-keyword

2020-08-23T22:36:59+00:00

Replace the existing /* fall through */ comments and its variants with
the new pseudo-keyword macro fallthrough[1]. Also, remove unnecessary
fall-through markings when it is the case.

[1] https://www.kernel.org/doc/html/v5.7/process/deprecated.html?highlight=fallthrough#implicit-switch-case-fall-through

Signed-off-by: Gustavo A. R. Silva

net: phy: mscc: Fix a couple of spelling mistakes "spcified" -> "specified"

2020-08-20T18:10:12+00:00

There are a couple of spelling mistakes in comment text. Fix these.

Signed-off-by: Kaige Li 
Signed-off-by: David S. Miller

net: phy: marvell10g: fix null pointer dereference

2020-08-11T22:42:23+00:00

Commit c3e302edca24 ("net: phy: marvell10g: fix temperature sensor on 2110")
added a check for PHY ID via phydev->drv->phy_id in a function which is
called by devres at a time when phydev->drv is already set to null by
phy_remove function.

This null pointer dereference can be triggered via SFP subsystem with a
SFP module containing this Marvell PHY. When the SFP interface is put
down, the SFP subsystem removes the PHY.

Fixes: c3e302edca24 ("net: phy: marvell10g: fix temperature sensor on 2110")
Signed-off-by: Marek Behún 
Cc: Maxime Chevallier 
Cc: Andrew Lunn 
Cc: Baruch Siach 
Cc: Russell King 
Signed-off-by: David S. Miller

net: phy: fix memory leak in device-create error path

2020-08-08T21:11:42+00:00

A recent commit introduced a late error path in phy_device_create()
which fails to release the device name allocated by dev_set_name().

Fixes: 13d0ab6750b2 ("net: phy: check return code when requesting PHY driver module")
Cc: Heiner Kallweit 
Signed-off-by: Johan Hovold 
Signed-off-by: David S. Miller