* 'for-linus' of git://git.kernel.org/pub/scm/linux/kernel/git/roland/infiniband:
  IB: Fix information leak in marshalling code
  IB/pack: Remove some unused code added by the IBoE patches
  IB/mlx4: Fix IBoE link state
  IB/mlx4: Fix IBoE reported link rate
  mlx4_core: Workaround firmware bug in query dev cap
  IB/mlx4: Fix memory ordering of VLAN insertion control bits
  MAINTAINERS: Update NetEffect entry

ConnectX firmware is supposed to report the number blue flame
registers per page as log2 of the value.  However, due to a firmware
bug, it reports actual number.  This patch works around this by
checking if the number of registers calculated fits within a page.  If
it does not, we use 8 registers per page.

Signed-off-by: Eli Cohen <eli@mellanox.co.il>
Signed-off-by: Roland Dreier <rolandd@cisco.com>

* git://git.kernel.org/pub/scm/linux/kernel/git/davem/net-2.6: (108 commits)
  ehea: Fixing statistics
  bonding: Fix lockdep warning after bond_vlan_rx_register()
  tunnels: Fix tunnels change rcu protection
  caif-u5500: Build config for CAIF shared mem driver
  caif-u5500: CAIF shared memory mailbox interface
  caif-u5500: CAIF shared memory transport protocol
  caif-u5500: Adding shared memory include
  drivers/isdn: delete double assignment
  drivers/net/typhoon.c: delete double assignment
  drivers/net/sb1000.c: delete double assignment
  qlcnic: define valid vlan id range
  qlcnic: reduce rx ring size
  qlcnic: fix mac learning
  ehea: fix use after free
  inetpeer: __rcu annotations
  fib_rules: __rcu annotates ctarget
  tunnels: add __rcu annotations
  net: add __rcu annotations to protocol
  ipv4: add __rcu annotations to routes.c
  qlge: bugfix: Restoring the vlan setting.
  ...

* 'for-linus' of git://git.kernel.org/pub/scm/linux/kernel/git/roland/infiniband: (63 commits)
  IB/qib: clean up properly if pci_set_consistent_dma_mask() fails
  IB/qib: Allow driver to load if PCIe AER fails
  IB/qib: Fix uninitialized pointer if CONFIG_PCI_MSI not set
  IB/qib: Fix extra log level in qib_early_err()
  RDMA/cxgb4: Remove unnecessary KERN_<level> use
  RDMA/cxgb3: Remove unnecessary KERN_<level> use
  IB/core: Add link layer type information to sysfs
  IB/mlx4: Add VLAN support for IBoE
  IB/core: Add VLAN support for IBoE
  IB/mlx4: Add support for IBoE
  mlx4_en: Change multicast promiscuous mode to support IBoE
  mlx4_core: Update data structures and constants for IBoE
  mlx4_core: Allow protocol drivers to find corresponding interfaces
  IB/uverbs: Return link layer type to userspace for query port operation
  IB/srp: Sync buffer before posting send
  IB/srp: Use list_first_entry()
  IB/srp: Reduce number of BUSY conditions
  IB/srp: Eliminate two forward declarations
  IB/mlx4: Signal node desc changes to SM by using FW to generate trap 144
  IB: Replace EXTRA_CFLAGS with ccflags-y
  ...

When searching for a free entry in either mlx4_register_vlan() or
mlx4_register_mac(), and there is no free entry, the loop terminates without
updating the local variable free thus causing out of array bounds access. Fix
this by adding a proper check outside the loop.

Signed-off-by: Eli Cohen <eli@mellanox.co.il>
Signed-off-by: David S. Miller <davem@davemloft.net>

This patch allows IBoE traffic to be encapsulated in 802.1Q tagged
VLAN frames.  The VLAN tag is encoded in the GID and derived from it
by a simple computation.

The netdev notifier callback is modified to catch VLAN device
addition/removal and the port's GID table is updated to reflect the
change, so that for each netdevice there is an entry in the GID table.
When the port's GID table is exhausted, GID entries will not be added.
Only children of the main interfaces can add to the GID table; if a
VLAN interface is added on another VLAN interface (e.g. "vconfig add
eth2.6 8"), then that interfaces will not add an entry to the GID
table.

Signed-off-by: Eli Cohen <eli@mellanox.co.il>
Signed-off-by: Roland Dreier <rolandd@cisco.com>

Change multicast promiscuous mode to pass packets through the multicast group distribution table
before sending packets that miss to the default multicast QP.

Signed-off-by: Eli Cohen <eli@mellanox.co.il>
Signed-off-by: Roland Dreier <rolandd@cisco.com>

Add fields to hardware data structures and add new constants required for IBoE
support.

Signed-off-by: Eli Cohen <eli@mellanox.co.il>
Signed-off-by: Roland Dreier <rolandd@cisco.com>

Add a mechanism for mlx4 protocol drivers to get a pointer to other
drivers's device objects.  For this, an exported function,
mlx4_get_protocol_dev() is added, which allows a driver to get some
other driver's device based on the protocol that the driver
implements.  Two protocols are added: MLX4_PROTOCOL_IB and
MLX4_PROTOCOL_EN.

This will be used in mlx4 IBoE support so that mlx4_ib can find the
corresponding mlx4_en netdev.

Signed-off-by: Eli Cohen <eli@mellanox.co.il>

[ Clean up and rename a few things.  - Roland ]

Signed-off-by: Roland Dreier <rolandd@cisco.com>