linux.git/drivers/net/ethernet/stmicro, branch v4.18

net: stmmac: Fix WoL for PCI-based setups

2018-08-01T16:35:42+00:00

WoL won't work in PCI-based setups because we are not saving the PCI EP
state before entering suspend state and not allowing D3 wake.

Fix this by using a wrapper around stmmac_{suspend/resume} which
correctly sets the PCI EP state.

Signed-off-by: Jose Abreu 
Cc: David S. Miller 
Cc: Joao Pinto 
Cc: Giuseppe Cavallaro 
Cc: Alexandre Torgue 
Signed-off-by: David S. Miller

NET: stmmac: align DMA stuff to largest cache line length

2018-07-29T19:33:30+00:00

As for today STMMAC_ALIGN macro (which is used to align DMA stuff)
relies on L1 line length (L1_CACHE_BYTES).
This isn't correct in case of system with several cache levels
which might have L1 cache line length smaller than L2 line. This
can lead to sharing one cache line between DMA buffer and other
data, so we can lose this data while invalidate DMA buffer before
DMA transaction.

Fix that by using SMP_CACHE_BYTES instead of L1_CACHE_BYTES for
aligning.

Signed-off-by: Eugeniy Paltsev 
Signed-off-by: David S. Miller

net: ethernet: stmmac: fix documentation warning

2018-07-16T20:42:44+00:00

This patch remove the following documentation warning
drivers/net/ethernet/stmicro/stmmac/stmmac_platform.c:103: warning: Excess function parameter 'priv' description in 'stmmac_axi_setup'
It was introduced in commit afea03656add7 ("stmmac: rework DMA bus setting and introduce new platform AXI structure")

Signed-off-by: Corentin Labbe 
Signed-off-by: David S. Miller

net: stmmac: dwmac-sun8i: fix typo descrive => describe

2018-07-16T20:42:21+00:00

This patch fix a typo in the word Describe
Signed-off-by: Corentin Labbe 
Signed-off-by: David S. Miller

net: stmmac: Set DMA buffer size in HW

2018-06-28T13:24:25+00:00

This is clearly a bug.

We need to set the DMA buffer size in the HW otherwise corruption can
occur when receiving packets.

This is probably not occuring because of small MTU values and because HW
has a default value internally (which currently is bigger than default
buffer size).

Signed-off-by: Jose Abreu 
Cc: David S. Miller 
Cc: Joao Pinto 
Cc: Vitor Soares 
Cc: Giuseppe Cavallaro 
Cc: Alexandre Torgue 
Signed-off-by: David S. Miller

stmmac: fix DMA channel hang in half-duplex mode

2018-06-20T05:35:20+00:00

HW does not support Half-duplex mode in multi-queue
scenario. Fix it by not advertising the Half-Duplex
mode if multi-queue enabled.

Signed-off-by: Bhadram Varka 
Signed-off-by: David S. Miller

net: stmmac: socfpga: add additional ocp reset line for Stratix10

2018-06-20T05:34:26+00:00

The Stratix10 platform has an additional reset line, OCP(Open Core Protocol),
that also needs to get deasserted for the stmmac ethernet controller to work.
Thus we need to update the Kconfig to include ARCH_STRATIX10 in order to build
dwmac-socfpga.

Also, remove the redundant check for the reset controller pointer. The
reset driver already checks for the pointer and returns 0 if the pointer
is NULL.

Signed-off-by: Dinh Nguyen 
Signed-off-by: David S. Miller

Merge git://git.kernel.org/pub/scm/linux/kernel/git/davem/net

2018-06-15T22:39:34+00:00

Pull networking fixes from David Miller:

 1) Various netfilter fixlets from Pablo and the netfilter team.

 2) Fix regression in IPVS caused by lack of PMTU exceptions on local
    routes in ipv6, from Julian Anastasov.

 3) Check pskb_trim_rcsum for failure in DSA, from Zhouyang Jia.

 4) Don't crash on poll in TLS, from Daniel Borkmann.

 5) Revert SO_REUSE{ADDR,PORT} change, it regresses various things
    including Avahi mDNS. From Bart Van Assche.

 6) Missing of_node_put in qcom/emac driver, from Yue Haibing.

 7) We lack checking of the TCP checking in one special case during SYN
    receive, from Frank van der Linden.

 8) Fix module init error paths of mac80211 hwsim, from Johannes Berg.

 9) Handle 802.1ad properly in stmmac driver, from Elad Nachman.

10) Must grab HW caps before doing quirk checks in stmmac driver, from
    Jose Abreu.

* git://git.kernel.org/pub/scm/linux/kernel/git/davem/net: (81 commits)
  net: stmmac: Run HWIF Quirks after getting HW caps
  neighbour: skip NTF_EXT_LEARNED entries during forced gc
  net: cxgb3: add error handling for sysfs_create_group
  tls: fix waitall behavior in tls_sw_recvmsg
  tls: fix use-after-free in tls_push_record
  l2tp: filter out non-PPP sessions in pppol2tp_tunnel_ioctl()
  l2tp: reject creation of non-PPP sessions on L2TPv2 tunnels
  mlxsw: spectrum_switchdev: Fix port_vlan refcounting
  mlxsw: spectrum_router: Align with new route replace logic
  mlxsw: spectrum_router: Allow appending to dev-only routes
  ipv6: Only emit append events for appended routes
  stmmac: added support for 802.1ad vlan stripping
  cfg80211: fix rcu in cfg80211_unregister_wdev
  mac80211: Move up init of TXQs
  mac80211_hwsim: fix module init error paths
  cfg80211: initialize sinfo in cfg80211_get_station
  nl80211: fix some kernel doc tag mistakes
  hv_netvsc: Fix the variable sizes in ipsecv2 and rsc offload
  rds: avoid unenecessary cong_update in loop transport
  l2tp: clean up stale tunnel or session in pppol2tp_connect's error path
  ...

net: stmmac: Run HWIF Quirks after getting HW caps

2018-06-15T16:38:52+00:00

Currently we were running HWIF quirks before getting HW capabilities.
This is not right because some HWIF callbacks depend on HW caps.

Lets save the quirks callback and use it in a later stage.

This fixes Altera socfpga.

Signed-off-by: Jose Abreu 
Fixes: 5f0456b43140 ("net: stmmac: Implement logic to automatically select HW Interface")
Reported-by: Dinh Nguyen 
Cc: David S. Miller 
Cc: Joao Pinto 
Cc: Vitor Soares 
Cc: Giuseppe Cavallaro 
Cc: Alexandre Torgue 
Cc: Dinh Nguyen 
Signed-off-by: David S. Miller

stmmac: added support for 802.1ad vlan stripping

2018-06-15T16:04:38+00:00

stmmac reception handler calls stmmac_rx_vlan() to strip the vlan before
calling napi_gro_receive().

The function assumes VLAN tagged frames are always tagged with
802.1Q protocol, and assigns ETH_P_8021Q to the skb by hard-coding
the parameter on call to __vlan_hwaccel_put_tag() .

This causes packets not to be passed to the VLAN slave if it was created
with 802.1AD protocol
(ip link add link eth0 eth0.100 type vlan proto 802.1ad id 100).

This fix passes the protocol from the VLAN header into
__vlan_hwaccel_put_tag() instead of using the hard-coded value of
ETH_P_8021Q.

NETIF_F_HW_VLAN_STAG_RX check was added and the strip action is now
dependent on the correct combination of features and the detected vlan tag.

NETIF_F_HW_VLAN_STAG_RX feature was added to be in line with the driver
actual abilities.

Signed-off-by: Elad Nachman 
Reviewed-by: Toshiaki Makita 
Signed-off-by: David S. Miller