linux.git/drivers/net/ethernet/amd, branch v4.0

net: ethernet: pcnet32: Setup the SRAM and NOUFLO on Am79C97{3, 5}

2015-03-20T16:56:40+00:00

On a MIPS Malta board, tons of fifo underflow errors have been observed
when using u-boot as bootloader instead of YAMON. The reason for that
is that YAMON used to set the pcnet device to SRAM mode but u-boot does
not. As a result, the default Tx threshold (64 bytes) is now too small to
keep the fifo relatively used and it can result to Tx fifo underflow errors.
As a result of which, it's best to setup the SRAM on supported controllers
so we can always use the NOUFLO bit.

Cc: 
Cc: 
Cc: 
Cc: Don Fry 
Signed-off-by: Markos Chandras 
Signed-off-by: David S. Miller

amd-xgbe: Request IRQs only after driver is fully setup

2015-02-27T22:13:02+00:00

It is possible that the hardware may not have been properly shutdown
before this driver gets control, through use by firmware, for example.
Until the driver is loaded, interrupts associated with the hardware
could go pending. When the IRQs are requested napi support has not
been initialized yet, but the ISR will get control and schedule napi
processing resulting in a kernel panic because the poll routine has not
been set.

Adjust the code so that the driver is fully ready to handle and process
interrupts as soon as the IRQs are requested. This involves requesting
and freeing IRQs during start and stop processing and ordering the napi
add and delete calls appropriately.

Also adjust the powerup and powerdown routines to match the start and
stop routines in regards to the ordering of tasks, including napi
related calls.

Signed-off-by: Tom Lendacky 
Signed-off-by: David S. Miller

Merge git://git.kernel.org/pub/scm/linux/kernel/git/davem/net-next

2015-02-11T04:01:30+00:00

Pull networking updates from David Miller:

 1) More iov_iter conversion work from Al Viro.

    [ The "crypto: switch af_alg_make_sg() to iov_iter" commit was
      wrong, and this pull actually adds an extra commit on top of the
      branch I'm pulling to fix that up, so that the pre-merge state is
      ok.   - Linus ]

 2) Various optimizations to the ipv4 forwarding information base trie
    lookup implementation.  From Alexander Duyck.

 3) Remove sock_iocb altogether, from CHristoph Hellwig.

 4) Allow congestion control algorithm selection via routing metrics.
    From Daniel Borkmann.

 5) Make ipv4 uncached route list per-cpu, from Eric Dumazet.

 6) Handle rfs hash collisions more gracefully, also from Eric Dumazet.

 7) Add xmit_more support to r8169, e1000, and e1000e drivers.  From
    Florian Westphal.

 8) Transparent Ethernet Bridging support for GRO, from Jesse Gross.

 9) Add BPF packet actions to packet scheduler, from Jiri Pirko.

10) Add support for uniqu flow IDs to openvswitch, from Joe Stringer.

11) New NetCP ethernet driver, from Muralidharan Karicheri and Wingman
    Kwok.

12) More sanely handle out-of-window dupacks, which can result in
    serious ACK storms.  From Neal Cardwell.

13) Various rhashtable bug fixes and enhancements, from Herbert Xu,
    Patrick McHardy, and Thomas Graf.

14) Support xmit_more in be2net, from Sathya Perla.

15) Group Policy extensions for vxlan, from Thomas Graf.

16) Remove Checksum Offload support for vxlan, from Tom Herbert.

17) Like ipv4, support lockless transmit over ipv6 UDP sockets.  From
    Vlad Yasevich.

* git://git.kernel.org/pub/scm/linux/kernel/git/davem/net-next: (1494+1 commits)
  crypto: fix af_alg_make_sg() conversion to iov_iter
  ipv4: Namespecify TCP PMTU mechanism
  i40e: Fix for stats init function call in Rx setup
  tcp: don't include Fast Open option in SYN-ACK on pure SYN-data
  openvswitch: Only set TUNNEL_VXLAN_OPT if VXLAN-GBP metadata is set
  ipv6: Make __ipv6_select_ident static
  ipv6: Fix fragment id assignment on LE arches.
  bridge: Fix inability to add non-vlan fdb entry
  net: Mellanox: Delete unnecessary checks before the function call "vunmap"
  cxgb4: Add support in cxgb4 to get expansion rom version via ethtool
  ethtool: rename reserved1 memeber in ethtool_drvinfo for expansion ROM version
  net: dsa: Remove redundant phy_attach()
  IB/mlx4: Reset flow support for IB kernel ULPs
  IB/mlx4: Always use the correct port for mirrored multicast attachments
  net/bonding: Fix potential bad memory access during bonding events
  tipc: remove tipc_snprintf
  tipc: nl compat add noop and remove legacy nl framework
  tipc: convert legacy nl stats show to nl compat
  tipc: convert legacy nl net id get to nl compat
  tipc: convert legacy nl net id set to nl compat
  ...

Merge branch 'for-linus' of git://git.kernel.org/pub/scm/linux/kernel/git/geert/linux-m68k

2015-02-10T21:27:24+00:00

Pull m68k updates from Geert Uytterhoeven:
 "Summary:

  - switch to asm-generic/futex.h

  - various cleanups

  - defconfig updates"

* 'for-linus' of git://git.kernel.org/pub/scm/linux/kernel/git/geert/linux-m68k:
  m68k/defconfig: Enable Ethernet bridging
  m68k/defconfig: Enable Atari EtherNAT and EtherNEC Ethernet support
  m68k/defconfig: Enable automounting of devtmpfs at /dev
  m68k/defconfig: Enable early printk support
  m68k/defconfig: Enable test modules
  m68k/defconfig: Refresh defconfigs for v3.16-rc1--v3.19-rc2
  m68k/atari: Remove obsolete IRQ_TYPE_*
  sound: dmasound_atari: Remove obsolete IRQ_TYPE_SLOW
  video: atafb: Remove obsolete IRQ_TYPE_PRIO
  parport: parport_atari: Remove obsolete IRQ_TYPE_SLOW
  net: atarilance: Remove obsolete IRQ_TYPE_PRIO
  m68k/atari: Remove obsolete keyboard_tasklet scheduling
  m68k/mac: Fix scsi_type for Mac LC and similar models
  m68k: Switch to asm-generic/futex.h
  m68k/mvme147: config.c - Remove unused functions
  m68k/atari: atakeyb.c - Remove some unused functions
  m68k/mvme16x: rtc - Don't use module_init in non-modular code

Merge git://git.kernel.org/pub/scm/linux/kernel/git/davem/net

2015-02-09T22:35:57+00:00

Signed-off-by: David S. Miller

amd-xgbe: Check per channel DMA interrupt use in main ISR

2015-02-08T06:44:42+00:00

When using per channel DMA interrupts the transmit interrupt (TI) and the
receive interrupt (RI) are masked off so as to not generate an interrupt
to the main ISR. However, should another interrupt fire for the DMA channel
that is handled by the main ISR the TI/RI bits can still be set. This
will cause the wrong and uninitialized napi structure to be used causing a
panic. Add a check to be sure per channel DMA interrupts are not enabled
before acting on those bit flags.

Signed-off-by: Tom Lendacky 
Signed-off-by: David S. Miller

Merge git://git.kernel.org/pub/scm/linux/kernel/git/davem/net

2015-02-05T22:33:28+00:00

Conflicts:
	drivers/net/vxlan.c
	drivers/vhost/net.c
	include/linux/if_vlan.h
	net/core/dev.c

The net/core/dev.c conflict was the overlap of one commit marking an
existing function static whilst another was adding a new function.

In the include/linux/if_vlan.h case, the type used for a local
variable was changed in 'net', whereas the function got rewritten
to fix a stacked vlan bug in 'net-next'.

In drivers/vhost/net.c, Al Viro's iov_iter conversions in 'net-next'
overlapped with an endainness fix for VHOST 1.0 in 'net'.

In drivers/net/vxlan.c, vxlan_find_vni() added a 'flags' parameter
in 'net-next' whereas in 'net' there was a bug fix to pass in the
correct network namespace pointer in calls to this function.

Signed-off-by: David S. Miller

amd-xgbe: Set RSS enablement based on hardware features

2015-02-05T04:31:51+00:00

The RSS support requires enablement based on the features reported by
the hardware. The setting of this flag is missing. Add support to
set the RSS enablement flag based on the reported hardware features.

Signed-off-by: Tom Lendacky 
Signed-off-by: David S. Miller

amd-xgbe: Adjust for zero-based traffic class count

2015-02-05T04:28:14+00:00

The number of traffic classes reported by the hardware is zero-based
so increment the value returned to get an actual count.

Signed-off-by: Tom Lendacky 
Signed-off-by: David S. Miller

net: am2150: fix nmclan_cs.c shared interrupt handling

2015-01-29T23:08:21+00:00

A recent patch tried to work around a valid warning for the use of a
deprecated interface by blindly changing from the old
pcmcia_request_exclusive_irq() interface to pcmcia_request_irq().

This driver has an interrupt handler that is not currently aware
of shared interrupts, but can be easily converted to be.
At the moment, the driver reads the interrupt status register
repeatedly until it contains only zeroes in the interesting bits,
and handles each bit individually.

This patch adds the missing part of returning IRQ_NONE in case none
of the bits are set to start with, so we can move on to the next
interrupt source.

Signed-off-by: Arnd Bergmann 
Fixes: 5f5316fcd08ef7 ("am2150: Update nmclan_cs.c to use update PCMCIA API")
Signed-off-by: David S. Miller