This moves the CMDLINE partition parser down into the
parser subdirectory. No functional change.

Signed-off-by: Linus Walleij <linus.walleij@linaro.org>
Signed-off-by: Richard Weinberger <richard@nod.at>

This moves the OF/device tree partition parser down into the
parser subdirectory. No functional change.

Signed-off-by: Linus Walleij <linus.walleij@linaro.org>
Signed-off-by: Richard Weinberger <richard@nod.at>

This moves the BCM63xx partition parser down into the
parser subdirectory. No functional change.

Signed-off-by: Linus Walleij <linus.walleij@linaro.org>
Signed-off-by: Richard Weinberger <richard@nod.at>

This moves the BCM47xx partition parser down into the
parser subdirectory. No functional change.

Signed-off-by: Linus Walleij <linus.walleij@linaro.org>
Signed-off-by: Richard Weinberger <richard@nod.at>

This moves the TI AR7 partition parser down into the
parser subdirectory. No functional change.

Signed-off-by: Linus Walleij <linus.walleij@linaro.org>
Signed-off-by: Richard Weinberger <richard@nod.at>

Cypress' HyperBus is Low Signal Count, High Performance Double Data Rate
Bus interface between a host system master and one or more slave
interfaces. HyperBus is used to connect microprocessor, microcontroller,
or ASIC devices with random access NOR flash memory (called HyperFlash)
or self refresh DRAM (called HyperRAM).

Its a 8-bit data bus (DQ[7:0]) with  Read-Write Data Strobe (RWDS)
signal and either Single-ended clock(3.0V parts) or Differential clock
(1.8V parts). It uses ChipSelect lines to select b/w multiple slaves.
At bus level, it follows a separate protocol described in HyperBus
specification[1].

HyperFlash follows CFI AMD/Fujitsu Extended Command Set (0x0002) similar
to that of existing parallel NORs. Since HyperBus is x8 DDR bus,
its equivalent to x16 parallel NOR flash with respect to bits per clock
cycle. But HyperBus operates at >166MHz frequencies.
HyperRAM provides direct random read/write access to flash memory
array.

But, HyperBus memory controllers seem to abstract implementation details
and expose a simple MMIO interface to access connected flash.

Add support for registering HyperFlash devices with MTD framework. MTD
maps framework along with CFI chip support framework are used to support
communicating with flash.

Framework is modelled along the lines of spi-nor framework. HyperBus
memory controller (HBMC) drivers calls hyperbus_register_device() to
register a single HyperFlash device. HyperFlash core parses MMIO access
information from DT, sets up the map_info struct, probes CFI flash and
registers it with MTD framework.

Some HBMC masters need calibration/training sequence[3] to be carried
out, in order for DLL inside the controller to lock, by reading a known
string/pattern. This is done by repeatedly reading CFI Query
Identification String. Calibration needs to be done before trying to detect
flash as part of CFI flash probe.

HyperRAM is not supported at the moment.

HyperBus specification can be found at[1]
HyperFlash datasheet can be found at[2]

[1] https://www.cypress.com/file/213356/download
[2] https://www.cypress.com/file/213346/download
[3] http://www.ti.com/lit/ug/spruid7b/spruid7b.pdf
    Table 12-5741. HyperFlash Access Sequence

Signed-off-by: Vignesh Raghavendra <vigneshr@ti.com>
Signed-off-by: Miquel Raynal <miquel.raynal@bootlin.com>

This moves the AFS (ARM Firmware Suite) partition parser
for NOR flash down into the parsers subdirectory.

Signed-off-by: Linus Walleij <linus.walleij@linaro.org>
Signed-off-by: Richard Weinberger <richard@nod.at>

Move the bcm963xx Image Tag parsing into its own partition parser. This
Allows reusing the parser with different full flash parsers.

While moving it, rename it to bcm963* to better reflect it isn't chip,
but reference implementation specific.

Reviewed-by: Rob Herring <robh@kernel.org>
Signed-off-by: Jonas Gorski <jonas.gorski@gmail.com>
Reviewed-by: Florian Fainelli <f.fainelli@gmail.com>
Signed-off-by: Richard Weinberger <richard@nod.at>

The software Hamming ECC correction implementation is referred as
MTD_NAND_ECC which is too generic. Rename it
MTD_NAND_ECC_SW_HAMMING. Also rename MTD_NAND_ECC_SMC which is an
SMC quirk in the Hamming implementation as
MTD_NAND_ECC_SW_HAMMING_SMC.

Signed-off-by: Miquel Raynal <miquel.raynal@bootlin.com>

Pull char/misc driver updates from Greg KH:
 "Here is the big set of char and misc driver patches for 4.21-rc1.

  Lots of different types of driver things in here, as this tree seems
  to be the "collection of various driver subsystems not big enough to
  have their own git tree" lately.

  Anyway, some highlights of the changes in here:

   - binderfs: is it a rule that all driver subsystems will eventually
     grow to have their own filesystem? Binder now has one to handle the
     use of it in containerized systems.

     This was discussed at the Plumbers conference a few months ago and
     knocked into mergable shape very fast by Christian Brauner. Who
     also has signed up to be another binder maintainer, showing a
     distinct lack of good judgement :)

   - binder updates and fixes

   - mei driver updates

   - fpga driver updates and additions

   - thunderbolt driver updates

   - soundwire driver updates

   - extcon driver updates

   - nvmem driver updates

   - hyper-v driver updates

   - coresight driver updates

   - pvpanic driver additions and reworking for more device support

   - lp driver updates. Yes really, it's _finally_ moved to the proper
     parallal port driver model, something I never thought I would see
     happen. Good stuff.

   - other tiny driver updates and fixes.

  All of these have been in linux-next for a while with no reported
  issues"

* tag 'char-misc-4.21-rc1' of git://git.kernel.org/pub/scm/linux/kernel/git/gregkh/char-misc: (116 commits)
  MAINTAINERS: add another Android binder maintainer
  intel_th: msu: Fix an off-by-one in attribute store
  stm class: Add a reference to the SyS-T document
  stm class: Fix a module refcount leak in policy creation error path
  char: lp: use new parport device model
  char: lp: properly count the lp devices
  char: lp: use first unused lp number while registering
  char: lp: detach the device when parallel port is removed
  char: lp: introduce list to save port number
  bus: qcom: remove duplicated include from qcom-ebi2.c
  VMCI: Use memdup_user() rather than duplicating its implementation
  char/rtc: Use of_node_name_eq for node name comparisons
  misc: mic: fix a DMA pool free failure
  ptp: fix an IS_ERR() vs NULL check
  genwqe: Fix size check
  binder: implement binderfs
  binder: fix use-after-free due to ksys_close() during fdget()
  bus: fsl-mc: remove duplicated include files
  bus: fsl-mc: explicitly define the fsl_mc_command endianness
  misc: ti-st: make array read_ver_cmd static, shrinks object size
  ...