linux.git/drivers/mmc/card, branch v3.10

block_device_operations->release() should return void

2013-05-07T06:16:21+00:00

The value passed is 0 in all but "it can never happen" cases (and those
only in a couple of drivers) *and* it would've been lost on the way
out anyway, even if something tried to pass something meaningful.
Just don't bother.

Signed-off-by: Al Viro

Merge tag 'mmc-updates-for-3.10-rc1' of git://git.kernel.org/pub/scm/linux/kernel/git/cjb/mmc

2013-05-04T20:45:17+00:00

Pull MMC update from Chris Ball:
 "MMC highlights for 3.10:

  Core:
   - Introduce MMC_CAP2_NO_PRESCAN_POWERUP to allow skipping
     mmc_power_up() at boot/initialization time if it's already
     happened, for performance (faster boot time) reasons.
   - Fix a bit width test failure that resulted in old eMMC cards being
     put into 1-bit mode when 4-bit mode was available.
   - Expose fwrev/hwrev for MMCv4 parts.
   - Improve card removal logic in the case where the card's removed
     slowly; we were missing card removal events if the card retained
     contact with the slot pads for long enough to reply to a CMD13
     while being removed.

  Drivers:
   - davinci_mmc: Support using PIO instead of DMA.
   - dw_mmc: Add support for Exynos4412.
   - mxcmmc: DT support, use slot-gpio API.
   - mxs-mmc: Add broken-cd/cd-inverted/non-removable DT property
     support.
   - sdhci-sirf: New sdhci-pltfm driver for CSR SiRF SoCs:
       SiRFprimaII: unicore ARM Cortex-A9
       SiRFatlas6: unicore ARM Cortex-A9
       SiRFmarco: dual core ARM Cortex-A9 SMP
   - sdhci-tegra: Add support for Tegra114 platforms, use
     mmc_of_parse()"

* tag 'mmc-updates-for-3.10-rc1' of git://git.kernel.org/pub/scm/linux/kernel/git/cjb/mmc: (66 commits)
  mmc: sdhci-tegra: fix MODULE_DEVICE_TABLE
  mmc: core: fix init controller performance regression, updated patch
  mmc: mxcmmc: enable DMA support on mpc512x
  mmc: mxcmmc: constify mxcmci_devtype
  mmc: mxcmmc: use slot-gpio API for write-protect detection
  mmc: mxcmmc: add mpc512x SDHC support
  mmc: mxcmmc: fix race conditions for host->req and host->data access
  mmc: mxcmmc: DT support
  mmc: dw_mmc: let device core setup the default pin configuration
  mmc: mxs-mmc: add broken-cd property
  mmc: mxs-mmc: add non-removable property
  mmc: mxs-mmc: add cd-inverted property
  mmc: core: call pm_runtime_put_noidle in pm_runtime_get_sync failed case
  mmc: mxcmmc: Fix bug when card is present during boot
  mmc: core: fix performance regression initializing MMC host controllers
  Revert "mmc: core: wait while adding MMC host to ensure root mounts successfully"
  mmc: atmel-mci: pio hang on block errors
  mmc: core: Fix bit width test failing on old eMMC cards
  mmc: dw_mmc: Use pr_info instead of printk
  mmc: dw_mmc: Check return value of regulator_enable
  ...

mmc: block: fix the host's claim-release in special request

2013-03-22T17:29:36+00:00

For normal request mmc_blk_issue_rq is called twice with asynchronous
transfer(cur and prev). Host's claim and release can be done in each
mmc_blk_issue_rq. However, Special request is currently excluded in
asynchronous transfer. After special request is finished, if there is
no new request, mmc_release_host won't be called in mmc_blk_issue_rq.
The problem is founded during mmc_suspend.

[] (__schedule+0x0/0x78c) from [] (schedule+0x38/0x78)
[] (schedule+0x0/0x78) from [] (__mmc_claim_host+0xac/0x1b4)
[] (__mmc_claim_host+0x0/0x1b4) from [] (mmc_suspend+0x28/0x9c)
[] (mmc_suspend+0x0/0x9c) from [] (mmc_suspend_host+0xb4/0x194)
...

Reported-by: Johan Rudholm 
Signed-off-by: Seungwon Jeon 
Tested-by: Johan Rudholm 
Signed-off-by: Chris Ball

TTY: add tty_port_tty_hangup helper

2013-03-18T23:24:29+00:00

It allows for cleaning up on a considerable amount of places. They did
port_get, hangup, kref_put. Now the only thing needed is to call
tty_port_tty_hangup which does exactly that. And they can also decide
whether to consider CLOCAL or completely ignore that.

Signed-off-by: Jiri Slaby 
Signed-off-by: Greg Kroah-Hartman

Merge tag 'mmc-updates-for-3.9-rc1' of git://git.kernel.org/pub/scm/linux/kernel/git/cjb/mmc

2013-02-26T17:31:09+00:00

Pull MMC update from Chris Ball:
"MMC highlights for 3.9:

Core:
- Support for packed commands in eMMC 4.5. (This requires a host
capability to be turned on. It increases write throughput by 20%+,
but may also increase average write latency; more testing needed.)
- Add DT bindings for capability flags.
- Add mmc_of_parse() for shared DT parsing between drivers.

Drivers:
- android-goldfish: New MMC driver for the Android Goldfish emulator.
- mvsdio: Add DT bindings, pinctrl, use slot-gpio for card detection.
- omap_hsmmc: Fix boot hangs with RPMB partitions.
- sdhci-bcm2835: New driver for controller used by Raspberry Pi.
- sdhci-esdhc-imx: Add 8-bit data, auto CMD23 support, use slot-gpio.
- sh_mmcif: Add support for eMMC DDR, bundled MMCIF IRQs.
- tmio_mmc: Add DT bindings, support for vccq regulator"

* tag 'mmc-updates-for-3.9-rc1' of git://git.kernel.org/pub/scm/linux/kernel/git/cjb/mmc: (92 commits)
mmc: tegra: assume CONFIG_OF, remove platform data
mmc: add DT bindings for more MMC capability flags
mmc: tmio: add support for the VccQ regulator
mmc: tmio: remove unused and deprecated symbols
mmc: sh_mobile_sdhi: use managed resource allocations
mmc: sh_mobile_sdhi: remove unused .pdata field
mmc: tmio-mmc: parse device-tree bindings
mmc: tmio-mmc: define device-tree bindings
mmc: sh_mmcif: use mmc_of_parse() to parse standard MMC DT bindings
mmc: (cosmetic) remove "extern" from function declarations
mmc: provide a standard MMC device-tree binding parser centrally
mmc: detailed definition of CD and WP MMC line polarities in DT
mmc: sdhi, tmio: only check flags in tmio-mmc driver proper
mmc: sdhci: Fix parameter of sdhci_do_start_signal_voltage_switch()
mmc: sdhci: check voltage range only on regulators aware of voltage value
mmc: bcm2835: set SDHCI_QUIRK_DATA_TIMEOUT_USES_SDCLK
mmc: support packed write command for eMMC4.5 devices
mmc: add packed command feature of eMMC4.5
mmc: rtsx: remove driving adjustment
mmc: use regulator_can_change_voltage() instead of regulator_count_voltages
...

mmc: support packed write command for eMMC4.5 devices

2013-02-24T19:37:16+00:00

This patch supports packed write command of eMMC4.5 devices.  Several
writes can be grouped in packed command and all data of the individual
commands can be sent in a single transfer on the bus. Large amounts of
data in one transfer rather than several data of small size are
effective for eMMC write internally.  As a result, packed command help
write throughput be improved.  The following tables show the results
of packed write.

Type A:
test     none |  packed
iozone   25.8 |  31
tiotest  27.6 |  31.2
lmdd     31.2 |  35.4

Type B:
test     none |  packed
iozone   44.1 |  51.1
tiotest  47.9 |  52.5
lmdd     51.6 |  59.2

Type C:
test     none |  packed
iozone   19.5 |  32
tiotest  19.9 |  34.5
lmdd     22.8 |  40.7

Signed-off-by: Seungwon Jeon 
Reviewed-by: Maya Erez 
Reviewed-by: Namjae Jeon 
Signed-off-by: Chris Ball

mmc: block: don't start new request when the card is removed

2013-02-24T19:37:12+00:00

It's not necessary to start a new request while error handling if
the card was removed.

Signed-off-by: Seungwon Jeon 
Acked-by: Jaehoon Chung 
Tested-by: Konstantin Dorfman 
Signed-off-by: Chris Ball

mmc: fix async request mechanism for sequential read scenarios

2013-02-11T18:28:49+00:00

When current request is running on the bus and if next request fetched
by mmcqd is NULL, mmc context (mmcqd thread) gets blocked until the
current request completes. This means that if new request comes in while
the mmcqd thread is blocked, this new request can not be prepared in
parallel to current ongoing request. This may result in delaying the new
request execution and increase it's latency.

This change allows to wake up the MMC thread on new request arrival.
Now once the MMC thread is woken up, a new request can be fetched and
prepared in parallel to the current running request which means this new
request can be started immediately after the current running request
completes.

With this change read throughput is improved by 16%.

Signed-off-by: Konstantin Dorfman 
Reviewed-by: Seungwon Jeon 
Signed-off-by: Chris Ball

mmc: queue: exclude asynchronous transfer for special request

2013-02-11T18:28:48+00:00

Unlike normal r/w request, special requests(discard, flush)
is finished with a one-time issue_fn. Request change to
mqrq_prev makes unnecessary call.

Signed-off-by: Seungwon Jeon 
Reviewed-by: Konstantin Dorfman 
Signed-off-by: Chris Ball

tty: Added a CONFIG_TTY option to allow removal of TTY

2013-01-19T00:15:27+00:00

The option allows you to remove TTY and compile without errors. This
saves space on systems that won't support TTY interfaces anyway.
bloat-o-meter output is below.

The bulk of this patch consists of Kconfig changes adding "depends on
TTY" to various serial devices and similar drivers that require the TTY
layer.  Ideally, these dependencies would occur on a common intermediate
symbol such as SERIO, but most drivers "select SERIO" rather than
"depends on SERIO", and "select" does not respect dependencies.

bloat-o-meter output comparing our previous minimal to new minimal by
removing TTY.  The list is filtered to not show removed entries with awk
'$3 != "-"' as the list was very long.

add/remove: 0/226 grow/shrink: 2/14 up/down: 6/-35356 (-35350)
function                                     old     new   delta
chr_dev_init                                 166     170      +4
allow_signal                                  80      82      +2
static.__warned                              143     142      -1
disallow_signal                               63      62      -1
__set_special_pids                            95      94      -1
unregister_console                           126     121      -5
start_kernel                                 546     541      -5
register_console                             593     588      -5
copy_from_user                                45      40      -5
sys_setsid                                   128     120      -8
sys_vhangup                                   32      19     -13
do_exit                                     1543    1526     -17
bitmap_zero                                   60      40     -20
arch_local_irq_save                          137     117     -20
release_task                                 674     652     -22
static.spin_unlock_irqrestore                308     260     -48

Signed-off-by: Joe Millenbach 
Reviewed-by: Jamey Sharp 
Reviewed-by: Josh Triplett 
Signed-off-by: Greg Kroah-Hartman