* 'for-linus' of git://git.kernel.org/pub/scm/linux/kernel/git/roland/infiniband: (45 commits)
  RDMA/cxgb3: Fix error paths in post_send and post_recv
  RDMA/nes: Fix stale ARP issue
  RDMA/nes: FIN during MPA startup causes timeout
  RDMA/nes: Free kmap() resources
  RDMA/nes: Check for zero STag
  RDMA/nes: Fix Xansation test crash on cm_node ref_count
  RDMA/nes: Abnormal listener exit causes loopback node crash
  RDMA/nes: Fix crash in nes_accept()
  RDMA/nes: Resource not freed for REJECTed connections
  RDMA/nes: MPA request/response error checking
  RDMA/nes: Fix query of ORD values
  RDMA/nes: Fix MAX_CM_BUFFER define
  RDMA/nes: Pass correct size to ioremap_nocache()
  RDMA/nes: Update copyright and branding string
  RDMA/nes: Add max_cqe check to nes_create_cq()
  RDMA/nes: Clean up struct nes_qp
  RDMA/nes: Implement IB_SIGNAL_ALL_WR as an iWARP extension
  RDMA/nes: Add additional SFP+ PHY uC status check and PHY reset
  RDMA/nes: Correct fast memory registration implementation
  IB/ehca: Fix error paths in post_send and post_recv
  ...

* 'for-linus' of git://git.kernel.org/pub/scm/linux/kernel/git/jikos/trivial: (42 commits)
  tree-wide: fix misspelling of "definition" in comments
  reiserfs: fix misspelling of "journaled"
  doc: Fix a typo in slub.txt.
  inotify: remove superfluous return code check
  hdlc: spelling fix in find_pvc() comment
  doc: fix regulator docs cut-and-pasteism
  mtd: Fix comment in Kconfig
  doc: Fix IRQ chip docs
  tree-wide: fix assorted typos all over the place
  drivers/ata/libata-sff.c: comment spelling fixes
  fix typos/grammos in Documentation/edac.txt
  sysctl: add missing comments
  fs/debugfs/inode.c: fix comment typos
  sgivwfb: Make use of ARRAY_SIZE.
  sky2: fix sky2_link_down copy/paste comment error
  tree-wide: fix typos "couter" -> "counter"
  tree-wide: fix typos "offest" -> "offset"
  fix kerneldoc for set_irq_msi()
  spidev: fix double "of of" in comment
  comment typo fix: sybsystem -> subsystem
  ...

When iser enabled lu reset support it did not set the
bit to allow userspace to get/set the timeout. This
sets the tgt and lu reset timeout bits.

Signed-off-by: Mike Christie <michaelc@cs.wisc.edu>
Signed-off-by: James Bottomley <James.Bottomley@suse.de>

fix some typos and punctuation in comments

Signed-off-by: Thadeu Lima de Souza Cascardo <cascardo@holoscopio.com>
Signed-off-by: Jiri Kosina <jkosina@suse.cz>

After dma-mapping an SG list provided by the SCSI midlayer, iser has
to make sure the mapped SG is "aligned for RDMA" in the sense that its
possible to produce one mapping in the HCA IOMMU which represents the
whole SG. Next, the mapped SG is formatted for registration with the HCA.

This patch re-writes the logic that does the above, to make it clearer
and simpler. It also fixes a bug in the being aligned for RDMA checks,
where a "start" check wasn't done but rather only "end" check.

Signed-off-by: Alexander Nezhinsky <alexandern@voltaire.com>
Signed-off-by: Or Gerlitz <ogerlitz@voltaire.com>
Signed-off-by: Roland Dreier <rolandd@cisco.com>

This patch contains changes that allow iscsi_session_setup
to allocate private space for LLD's

Signed-off-by: Jayamohan Kallickal <jayamohank@serverengines.com>
Acked-by: Mike Christie <michaelc@cs.wisc.edu>
Signed-off-by: James Bottomley <James.Bottomley@suse.de>

If a task did not complete normally due to a TMF, libiscsi will
now complete the task with the state ISCSI_TASK_ABRT_TMF. Drivers
like bnx2i that need to free resources if a command did not complete normally
can then check the task state. If a driver does not need to send
a special command if we have dropped the session then they can check
for ISCSI_TASK_ABRT_SESS_RECOV.

Signed-off-by: Mike Christie <michaelc@cs.wisc.edu>
Signed-off-by: James Bottomley <James.Bottomley@HansenPartnership.com>

When we create the tcp/ip connection by calling ep_connect, we currently
just go by the routing table info.

I think there are two problems with this.

1. Some drivers do not have access to a routing table. Some drivers like
qla4xxx do not even know about other ports.

2. If you have two initiator ports on the same subnet, the user may have
set things up so that session1 was supposed to be run through port1. and
session2 was supposed to be run through port2. It looks like we could
end with both sessions going through one of the ports.

Fixes for cxgb3i from Karen Xie.

Signed-off-by: Mike Christie <michaelc@cs.wisc.edu>
Signed-off-by: James Bottomley <James.Bottomley@HansenPartnership.com>

Set target can queue limit to the number of preallocated
session tasks we have.

This along with the cxgb3i can_queue patch will fix a throughput
problem where it could only queue one LU worth of data at a time.

Signed-off-by: Mike Christie <michaelc@cs.wisc.edu>
Signed-off-by: James Bottomley <James.Bottomley@HansenPartnership.com>

* git://git.kernel.org/pub/scm/linux/kernel/git/jejb/scsi-misc-2.6: (119 commits)
  [SCSI] scsi_dh_rdac: Retry for NOT_READY check condition
  [SCSI] mpt2sas: make global symbols unique
  [SCSI] sd: Make revalidate less chatty
  [SCSI] sd: Try READ CAPACITY 16 first for SBC-2 devices
  [SCSI] sd: Refactor sd_read_capacity()
  [SCSI] mpt2sas v00.100.11.15
  [SCSI] mpt2sas: add MPT2SAS_MINOR(221) to miscdevice.h
  [SCSI] ch: Add scsi type modalias
  [SCSI] 3w-9xxx: add power management support
  [SCSI] bsg: add linux/types.h include to bsg.h
  [SCSI] cxgb3i: fix function descriptions
  [SCSI] libiscsi: fix possbile null ptr session command cleanup
  [SCSI] iscsi class: remove host no argument from session creation callout
  [SCSI] libiscsi: pass session failure a session struct
  [SCSI] iscsi lib: remove qdepth param from iscsi host allocation
  [SCSI] iscsi lib: have lib create work queue for transmitting IO
  [SCSI] iscsi class: fix lock dep warning on logout
  [SCSI] libiscsi: don't cap queue depth in iscsi modules
  [SCSI] iscsi_tcp: replace scsi_debug/tcp_debug logging with iscsi conn logging
  [SCSI] libiscsi_tcp: replace tcp_debug/scsi_debug logging with session/conn logging
  ...