If something goes wrong (such as the SCL being stuck low) then we need
to reset the PCA chip. The issue with this is that on reset we lose all
config settings and the chip ends up in a disabled state which results
in a lock up/high CPU usage. We need to re-apply any configuration that
had previously been set and re-enable the chip.

Signed-off-by: Evan Nimmo <evan.nimmo@alliedtelesis.co.nz>
Reviewed-by: Chris Packham <chris.packham@alliedtelesis.co.nz>
Reviewed-by: Andy Shevchenko <andriy.shevchenko@linux.intel.com>
Signed-off-by: Wolfram Sang <wsa@kernel.org>

timeout_usec value calculation was wrong, the calculated value
was in msec instead of usec.

Fixes: 56a1485b102e ("i2c: npcm7xx: Add Nuvoton NPCM I2C controller driver")
Signed-off-by: Tali Perry <tali.perry1@gmail.com>
Reviewed-by: Avi Fishman <avifishman70@gmail.com>
Reviewed-by: Joel Stanley <joel@jms.id.au>
Reviewed-by: Alex Qiu <xqiu@google.com>
Signed-off-by: Wolfram Sang <wsa@kernel.org>

Pull i2c fixes from Wolfram Sang:
 "A core fix for ACPI matching and two driver bugfixes"

* 'i2c/for-current' of git://git.kernel.org/pub/scm/linux/kernel/git/wsa/linux:
  i2c: iproc: Fix shifting 31 bits
  i2c: rcar: in slave mode, clear NACK earlier
  i2c: acpi: Remove dead code, i.e. i2c_acpi_match_device()
  i2c: core: Don't fail PRP0001 enumeration when no ID table exist

Fix undefined behaviour in the iProc I2C driver by using 'BIT' marcro.

Reported-by: Wolfram Sang <wsa@kernel.org>
Signed-off-by: Ray Jui <ray.jui@broadcom.com>
Acked-by: Florian Fainelli <f.fainelli@gmail.com>
[wsa: in commit msg, don't say 'checkpatch' but name the issue]
Signed-off-by: Wolfram Sang <wsa@kernel.org>

Currently, a NACK in slave mode is set/cleared when SCL is held low by
the IP core right before the bit is about to be pushed out. This is too
late for clearing and then a NACK from the previous byte is still used
for the current one. Now, let's clear the NACK right after we detected
the STOP condition following the NACK.

Fixes: de20d1857dd6 ("i2c: rcar: add slave support")
Signed-off-by: Wolfram Sang <wsa+renesas@sang-engineering.com>
Signed-off-by: Wolfram Sang <wsa@kernel.org>

We have no users of i2c_acpi_match_device() anymore and seems
will not have them in the future, thus remove dead code.

Signed-off-by: Andy Shevchenko <andriy.shevchenko@linux.intel.com>
Reviewed-by: Mika Westerberg <mika.westerberg@linux.intel.com>
Signed-off-by: Wolfram Sang <wsa@kernel.org>

When commit c64ffff7a9d1 ("i2c: core: Allow empty id_table in ACPI case
as well") fixed the enumeration of I²C devices on ACPI enabled platforms
when driver has no ID table, it missed the PRP0001 support.

i2c_device_match() and i2c_acpi_match_device() differently match
driver against given device. Use acpi_driver_match_device(), that is used
in the former, in i2c_device_probe() and don't fail PRP0001 enumeration
when no ID table exist.

Fixes: c64ffff7a9d1 ("i2c: core: Allow empty id_table in ACPI case as well")
BugLink: https://stackoverflow.com/q/63519678/2511795
Signed-off-by: Andy Shevchenko <andriy.shevchenko@linux.intel.com>
Reviewed-by: Mika Westerberg <mika.westerberg@linux.intel.com>
Signed-off-by: Wolfram Sang <wsa@kernel.org>

Replace the existing /* fall through */ comments and its variants with
the new pseudo-keyword macro fallthrough[1]. Also, remove unnecessary
fall-through markings when it is the case.

[1] https://www.kernel.org/doc/html/v5.7/process/deprecated.html?highlight=fallthrough#implicit-switch-case-fall-through

Signed-off-by: Gustavo A. R. Silva <gustavoars@kernel.org>

Pull more ACPI updates from Rafael Wysocki:
 "Add new hardware support to the ACPI driver for AMD SoCs, the x86 clk
  driver and the Designware i2c driver (changes from Akshu Agrawal and
  Pu Wen)"

* tag 'acpi-5.9-rc1-2' of git://git.kernel.org/pub/scm/linux/kernel/git/rafael/linux-pm:
  clk: x86: Support RV architecture
  ACPI: APD: Add a fmw property is_raven
  clk: x86: Change name from ST to FCH
  ACPI: APD: Change name from ST to FCH
  i2c: designware: Add device HID for Hygon I2C controller

Pull i2c updates from Wolfram Sang:

 - bus recovery can now be given a pinctrl handle and the I2C core will
   do all the steps to switch to/from GPIO which can save quite some
   boilerplate code from drivers

 - "fallthrough" conversion

 - driver updates, mostly ID additions

* 'i2c/for-5.9' of git://git.kernel.org/pub/scm/linux/kernel/git/wsa/linux: (32 commits)
  i2c: iproc: fix race between client unreg and isr
  i2c: eg20t: use generic power management
  i2c: eg20t: Drop PCI wakeup calls from .suspend/.resume
  i2c: mediatek: Fix i2c_spec_values description
  i2c: mediatek: Add i2c compatible for MediaTek MT8192
  dt-bindings: i2c: update bindings for MT8192 SoC
  i2c: mediatek: Add access to more than 8GB dram in i2c driver
  i2c: mediatek: Add apdma sync in i2c driver
  i2c: i801: Add support for Intel Tiger Lake PCH-H
  i2c: i801: Add support for Intel Emmitsburg PCH
  i2c: bcm2835: Replace HTTP links with HTTPS ones
  Documentation: i2c: dev: 'block process call' is supported
  i2c: at91: Move to generic GPIO bus recovery
  i2c: core: treat EPROBE_DEFER when acquiring SCL/SDA GPIOs
  i2c: core: add generic I2C GPIO recovery
  dt-bindings: i2c: add generic properties for GPIO bus recovery
  i2c: rcar: avoid race when unregistering slave
  i2c: tegra: Avoid tegra_i2c_init_dma() for Tegra210 vi i2c
  i2c: tegra: Fix runtime resume to re-init VI I2C
  i2c: tegra: Fix the error path in tegra_i2c_runtime_resume
  ...