Arm FF-A fix for v6.9

A single fix to address the incorrect check of VM ID count for the
global notification in the response received for FFA_NOTIFICATION_INFO_GET()
in the schedule receiver interrupt handler.

* tag 'ffa-fix-6.9' of git://git.kernel.org/pub/scm/linux/kernel/git/sudeep.holla/linux:
  firmware: arm_ffa: Fix the partition ID check in ffa_notification_info_get()

Link: https://lore.kernel.org/r/20240404140339.450509-1-sudeep.holla@arm.com
Signed-off-by: Arnd Bergmann <arnd@arndb.de>

Arm SCMI fixes for v6.9

Couple of fixes to address wrong fastchannel initialization in powercap
protocol and disable seeking support for SCMI raw debugfs entries.

* tag 'scmi-fixes-6.9' of git://git.kernel.org/pub/scm/linux/kernel/git/sudeep.holla/linux:
  firmware: arm_scmi: Make raw debugfs entries non-seekable
  firmware: arm_scmi: Fix wrong fastchannel initialization

Link: https://lore.kernel.org/r/20240404140306.450330-1-sudeep.holla@arm.com
Signed-off-by: Arnd Bergmann <arnd@arndb.de>

Commit

  8117961d98fb2 ("x86/efi: Disregard setup header of loaded image")

dropped the memcopy of the image's setup header into the boot_params
struct provided to the core kernel, on the basis that EFI boot does not
need it and should rely only on a single protocol to interface with the
boot chain. It is also a prerequisite for being able to increase the
section alignment to 4k, which is needed to enable memory protections
when running in the boot services.

So only the setup_header fields that matter to the core kernel are
populated explicitly, and everything else is ignored. One thing was
overlooked, though: the initrd_addr_max field in the setup_header is not
used by the core kernel, but it is used by the EFI stub itself when it
loads the initrd, where its default value of INT_MAX is used as the soft
limit for memory allocation.

This means that, in the old situation, the initrd was virtually always
loaded in the lower 2G of memory, but now, due to initrd_addr_max being
0x0, the initrd may end up anywhere in memory. This should not be an
issue principle, as most systems can deal with this fine. However, it
does appear to tickle some problems in older UEFI implementations, where
the memory ends up being corrupted, resulting in errors when unpacking
the initramfs.

So set the initrd_addr_max field to INT_MAX like it was before.

Fixes: 8117961d98fb2 ("x86/efi: Disregard setup header of loaded image")
Reported-by: Radek Podgorny <radek@podgorny.cz>
Closes: https://lore.kernel.org/all/a99a831a-8ad5-4cb0-bff9-be637311f771@podgorny.cz
Signed-off-by: Ard Biesheuvel <ardb@kernel.org>

Avoid a type mismatch warning in max() by switching to max_t() and
providing the type explicitly.

Fixes: 3cb4a4827596abc82e ("efi/libstub: fix efi_random_alloc() ...")
Signed-off-by: Ard Biesheuvel <ardb@kernel.org>

SCMI raw debugfs entries are used to inject and snoop messages out of the
SCMI core and, as such, the underlying virtual files have no reason to
support seeking.

Modify the related file_operations descriptors to be non-seekable.

Fixes: 3c3d818a9317 ("firmware: arm_scmi: Add core raw transmission support")
Signed-off-by: Cristian Marussi <cristian.marussi@arm.com>
Link: https://lore.kernel.org/r/20240315140324.231830-1-cristian.marussi@arm.com
Signed-off-by: Sudeep Holla <sudeep.holla@arm.com>

Fastchannels are initialized with an incorrect index(POWERCAP_PAI_GET) in:
commit 2441caa84aac ("firmware: arm_scmi: Populate fast channel rate_limit")

Fix this and provide a correct index(POWERCAP_FC_PAI)

Fixes: 2441caa84aac ("firmware: arm_scmi: Populate fast channel rate_limit")
Reported-by: kernel test robot <lkp@intel.com>
Reported-by: Dan Carpenter <dan.carpenter@linaro.org>
Closes: https://lore.kernel.org/r/202403100744.7Op3PI8L-lkp@intel.com/
Signed-off-by: Pierre Gondois <pierre.gondois@arm.com>
Link: https://lore.kernel.org/r/20240311090413.1710725-1-pierre.gondois@arm.com
Signed-off-by: Sudeep Holla <sudeep.holla@arm.com>

FFA_NOTIFICATION_INFO_GET retrieves information about pending
notifications. Notifications can be either global or per VCPU. Global
notifications are reported with the partition ID only in the list of
endpoints with pending notifications. ffa_notification_info_get()
incorrectly expect no ID at all for global notifications. Fix this by
checking for ID = 1 instead of ID = 0.

Fixes: 3522be48d82b ("firmware: arm_ffa: Implement the NOTIFICATION_INFO_GET interface")
Signed-off-by: Jens Wiklander <jens.wiklander@linaro.org>
Reviewed-by: Lorenzo Pieralisi <lpieralisi@kernel.org>
Link: https://lore.kernel.org/r/20240311110700.2367142-1-jens.wiklander@linaro.org
Signed-off-by: Sudeep Holla <sudeep.holla@arm.com>

Pull EFI fixes from Ard Biesheuvel:

 - Fix logic that is supposed to prevent placement of the kernel image
   below LOAD_PHYSICAL_ADDR

 - Use the firmware stack in the EFI stub when running in mixed mode

 - Clear BSS only once when using mixed mode

 - Check efi.get_variable() function pointer for NULL before trying to
   call it

* tag 'efi-fixes-for-v6.9-2' of git://git.kernel.org/pub/scm/linux/kernel/git/efi/efi:
  efi: fix panic in kdump kernel
  x86/efistub: Don't clear BSS twice in mixed mode
  x86/efistub: Call mixed mode boot services on the firmware's stack
  efi/libstub: fix efi_random_alloc() to allocate memory at alloc_min or higher address

Check if get_next_variable() is actually valid pointer before
calling it. In kdump kernel this method is set to NULL that causes
panic during the kexec-ed kernel boot.

Tested with QEMU and OVMF firmware.

Fixes: bad267f9e18f ("efi: verify that variable services are supported")
Signed-off-by: Oleksandr Tymoshenko <ovt@google.com>
Signed-off-by: Ard Biesheuvel <ardb@kernel.org>

Clearing BSS should only be done once, at the very beginning.
efi_pe_entry() is the entrypoint from the firmware, which may not clear
BSS and so it is done explicitly. However, efi_pe_entry() is also used
as an entrypoint by the mixed mode startup code, in which case BSS will
already have been cleared, and doing it again at this point will corrupt
global variables holding the firmware's GDT/IDT and segment selectors.

So make the memset() conditional on whether the EFI stub is running in
native mode.

Fixes: b3810c5a2cc4a666 ("x86/efistub: Clear decompressor BSS in native EFI entrypoint")
Signed-off-by: Ard Biesheuvel <ardb@kernel.org>