Pull DMA mask updates from Russell King:
 "This series cleans up the handling of DMA masks in a lot of drivers,
  fixing some bugs as we go.

  Some of the more serious errors include:
   - drivers which only set their coherent DMA mask if the attempt to
     set the streaming mask fails.
   - drivers which test for a NULL dma mask pointer, and then set the
     dma mask pointer to a location in their module .data section -
     which will cause problems if the module is reloaded.

  To counter these, I have introduced two helper functions:
   - dma_set_mask_and_coherent() takes care of setting both the
     streaming and coherent masks at the same time, with the correct
     error handling as specified by the API.
   - dma_coerce_mask_and_coherent() which resolves the problem of
     drivers forcefully setting DMA masks.  This is more a marker for
     future work to further clean these locations up - the code which
     creates the devices really should be initialising these, but to fix
     that in one go along with this change could potentially be very
     disruptive.

  The last thing this series does is prise away some of Linux's addition
  to "DMA addresses are physical addresses and RAM always starts at
  zero".  We have ARM LPAE systems where all system memory is above 4GB
  physical, hence having DMA masks interpreted by (eg) the block layers
  as describing physical addresses in the range 0..DMAMASK fails on
  these platforms.  Santosh Shilimkar addresses this in this series; the
  patches were copied to the appropriate people multiple times but were
  ignored.

  Fixing this also gets rid of some ARM weirdness in the setup of the
  max*pfn variables, and brings ARM into line with every other Linux
  architecture as far as those go"

* 'for-linus-dma-masks' of git://git.linaro.org/people/rmk/linux-arm: (52 commits)
  ARM: 7805/1: mm: change max*pfn to include the physical offset of memory
  ARM: 7797/1: mmc: Use dma_max_pfn(dev) helper for bounce_limit calculations
  ARM: 7796/1: scsi: Use dma_max_pfn(dev) helper for bounce_limit calculations
  ARM: 7795/1: mm: dma-mapping: Add dma_max_pfn(dev) helper function
  ARM: 7794/1: block: Rename parameter dma_mask to max_addr for blk_queue_bounce_limit()
  ARM: DMA-API: better handing of DMA masks for coherent allocations
  ARM: 7857/1: dma: imx-sdma: setup dma mask
  DMA-API: firmware/google/gsmi.c: avoid direct access to DMA masks
  DMA-API: dcdbas: update DMA mask handing
  DMA-API: dma: edma.c: no need to explicitly initialize DMA masks
  DMA-API: usb: musb: use platform_device_register_full() to avoid directly messing with dma masks
  DMA-API: crypto: remove last references to 'static struct device *dev'
  DMA-API: crypto: fix ixp4xx crypto platform device support
  DMA-API: others: use dma_set_coherent_mask()
  DMA-API: staging: use dma_set_coherent_mask()
  DMA-API: usb: use new dma_coerce_mask_and_coherent()
  DMA-API: usb: use dma_set_coherent_mask()
  DMA-API: parport: parport_pc.c: use dma_coerce_mask_and_coherent()
  DMA-API: net: octeon: use dma_coerce_mask_and_coherent()
  DMA-API: net: nxp/lpc_eth: use dma_coerce_mask_and_coherent()
  ...

Pull x86 RAS changes from Ingo Molnar:
 "The biggest change adds support for Intel 'CPER' (UEFI Common Platform
  Error Record) error logging, which builds upon an enhanced error
  logging mechanism available on Xeon processors.

  Full description is here:

    http://www.intel.com/content/www/us/en/architecture-and-technology/enhanced-mca-logging-xeon-paper.html

  This change provides a module (and support code) to check for an
  extended error log and prints extra details about the error on the
  console"

* 'x86-mce-for-linus' of git://git.kernel.org/pub/scm/linux/kernel/git/tip/tip:
  ACPI, x86: Fix extended error log driver to depend on CONFIG_X86_LOCAL_APIC
  dmi: Avoid unaligned memory access in save_mem_devices()
  Move cper.c from drivers/acpi/apei to drivers/firmware/efi
  EDAC, GHES: Update ghes error record info
  ACPI, APEI, CPER: Cleanup CPER memory error output format
  ACPI, APEI, CPER: Enhance memory reporting capability
  ACPI, APEI, CPER: Add UEFI 2.4 support for memory error
  DMI: Parse memory device (type 17) in SMBIOS
  ACPI, x86: Extended error log driver for x86 platform
  bitops: Introduce a more generic BITMASK macro
  ACPI, CPER: Update cper info
  ACPI, APEI, CPER: Fix status check during error printing

Pull x86 EFI changes from Ingo Molnar:
 "Main changes:

   - Add support for earlyprintk=efi which uses the EFI framebuffer.
     Very useful for debugging boot problems.

   - EFI stub support for large memory maps (more than 128 entries)

   - EFI ARM support - this was mostly done by generalizing x86 <-> ARM
     platform differences, such as by moving x86 EFI code into
     drivers/firmware/efi/ and sharing it with ARM.

   - Documentation updates

   - misc fixes"

* 'x86-efi-for-linus' of git://git.kernel.org/pub/scm/linux/kernel/git/tip/tip: (26 commits)
  x86/efi: Add EFI framebuffer earlyprintk support
  boot, efi: Remove redundant memset()
  x86/efi: Fix config_table_type array termination
  x86 efi: bugfix interrupt disabling sequence
  x86: EFI stub support for large memory maps
  efi: resolve warnings found on ARM compile
  efi: Fix types in EFI calls to match EFI function definitions.
  efi: Renames in handle_cmdline_files() to complete generalization.
  efi: Generalize handle_ramdisks() and rename to handle_cmdline_files().
  efi: Allow efi_free() to be called with size of 0
  efi: use efi_get_memory_map() to get final map for x86
  efi: generalize efi_get_memory_map()
  efi: Rename __get_map() to efi_get_memory_map()
  efi: Move unicode to ASCII conversion to shared function.
  efi: Generalize relocate_kernel() for use by other architectures.
  efi: Move relocate_kernel() to shared file.
  efi: Enforce minimum alignment of 1 page on allocations.
  efi: Rename memory allocation/free functions
  efi: Add system table pointer argument to shared functions.
  efi: Move common EFI stub code from x86 arch code to common location
  ...

Firmware is not required to maintain alignment of SMBIOS
entries, so we should take care accessing fields within these
structures. Use "get_unaligned()" to avoid problems.

[ Found on ia64 (which grumbles about unaligned access) ]

Signed-off-by: Tony Luck <tony.luck@intel.com>
Cc: Chen Gong <gong.chen@linux.intel.com>
Link: http://lkml.kernel.org/r/27d82dbff5be1025bf18ab88498632d36c2fcf3c.1383331440.git.tony.luck@intel.com
Signed-off-by: Ingo Molnar <mingo@kernel.org>

cper.c contains code to decode and print "Common Platform Error Records".
Originally added under drivers/acpi/apei because the only user was in that
same directory - but now we have another consumer, and we shouldn't have
to force CONFIG_ACPI_APEI get access to this code.

Since CPER is defined in the UEFI specification - the logical home for
this code is under drivers/firmware/efi/

Acked-by: Matt Fleming <matt.fleming@intel.com>
Acked-by: Ingo Molnar <mingo@kernel.org>
Signed-off-by: Tony Luck <tony.luck@intel.com>

This driver doesn't need to directly access DMA masks if it uses the
platform_device_register_full() API rather than
platform_device_register_simple() - the former function can initialize
the DMA mask appropriately.

Signed-off-by: Russell King <rmk+kernel@arm.linux.org.uk>

dcdbas was explicitly initializing DMA masks thusly:
	dcdbas_pdev->dev.coherent_dma_mask = DMA_BIT_MASK(32);
	dcdbas_pdev->dev.dma_mask = &dcdbas_pdev->dev.coherent_dma_mask;
which bypasses the architecture check.  Moreover, it is creating the
dcdbas_pdev device itself, and using the platform_device_register_full()
avoids some of this explicit initialization.

Convert the driver to use platform_device_register_full(), and as it
makes use of coherent DMA, also call dma_set_coherent_mask() to ensure
that the architecture gets to check the mask.

Tested-by: Fengguang Wu <fengguang.wu@intel.com>
Signed-off-by: Russell King <rmk+kernel@arm.linux.org.uk>

This patch adds a new interface to decode memory device (type 17)
to help error reporting on DIMMs.

Original-author: Tony Luck <tony.luck@intel.com>
Signed-off-by: Chen, Gong <gong.chen@linux.intel.com>
Acked-by: Naveen N. Rao <naveen.n.rao@linux.vnet.ibm.com>
Acked-by: Borislav Petkov <bp@suse.de>
Reviewed-by: Mauro Carvalho Chehab <m.chehab@samsung.com>
Signed-off-by: Tony Luck <tony.luck@intel.com>

Remove a redundant memset() call from efi_relocate_kernel() that
was clearing memory that would be used by BSS in non-compressed
images loaded with this function.  This clear was redundant with
the clearing done in the image itself, and also implemented incorrectly
with a 0 length.

Signed-off-by: Roy Franz <roy.franz@linaro.org>
Acked-by: Mark Salter <msalter@redhat.com>
Signed-off-by: Matt Fleming <matt.fleming@intel.com>