Pull ARM updates from Russell King:

 - StrongARM SA1111 updates to modernise and remove cruft

 - Add StrongARM gpio drivers for board GPIOs

 - Verify size of zImage is what we expect to avoid issues with
   appended DTB

 - nommu updates from Vladimir Murzin

 - page table read-write-execute checking from Jinbum Park

 - Broadcom Brahma-B15 cache updates from Florian Fainelli

 - Avoid failure with kprobes test caused by inappropriately
   placed kprobes

 - Remove __memzero optimisation (which was incorrectly being
   used directly by some drivers)

* 'for-linus' of git://git.armlinux.org.uk/~rmk/linux-arm: (32 commits)
  ARM: 8745/1: get rid of __memzero()
  ARM: 8744/1: don't discard memblock for kexec
  ARM: 8743/1: bL_switcher: add MODULE_LICENSE tag
  ARM: 8742/1: Always use REFCOUNT_FULL
  ARM: 8741/1: B15: fix unused label warnings
  ARM: 8740/1: NOMMU: Make sure we do not hold stale data in mem[] array
  ARM: 8739/1: NOMMU: Setup VBAR/Hivecs for secondaries cores
  ARM: 8738/1: Disable CONFIG_DEBUG_VIRTUAL for NOMMU
  ARM: 8737/1: mm: dump: add checking for writable and executable
  ARM: 8736/1: mm: dump: make the page table dumping seq_file
  ARM: 8735/1: mm: dump: make page table dumping reusable
  ARM: sa1100/neponset: add GPIO drivers for control and modem registers
  ARM: sa1100/assabet: add BCR/BSR GPIO driver
  ARM: 8734/1: mm: idmap: Mark variables as ro_after_init
  ARM: 8733/1: hw_breakpoint: Mark variables as __ro_after_init
  ARM: 8732/1: NOMMU: Allow userspace to access background MPU region
  ARM: 8727/1: MAINTAINERS: Update brcmstb entries to cover B15 code
  ARM: 8728/1: B15: Register reboot notifier for KEXEC
  ARM: 8730/1: B15: Add suspend/resume hooks
  ARM: 8726/1: B15: Add CPU hotplug awareness
  ...

Pull dmaengine updates from Vinod Koul:
 "This time is smallish update with updates mainly to drivers:

   - updates to xilinx and zynqmp dma controllers

   - update reside calculation for rcar controller

   - more RSTify fixes for documentation

   - add support for race free transfer termination and updating for
     users for that

   - support for new rev of hidma with addition new APIs to get device
     match data in ACPI/OF

   - random updates to bunch of other drivers"

* tag 'dmaengine-4.16-rc1' of git://git.infradead.org/users/vkoul/slave-dma: (47 commits)
  dmaengine: dmatest: fix container_of member in dmatest_callback
  dmaengine: stm32-dmamux: Remove unnecessary platform_get_resource() error check
  dmaengine: sprd: statify 'sprd_dma_prep_dma_memcpy'
  dmaengine: qcom_hidma: simplify DT resource parsing
  dmaengine: xilinx_dma: Free BD consistent memory
  dmaengine: xilinx_dma: Fix warning variable prev set but not used
  dmaengine: xilinx_dma: properly configure the SG mode bit in the driver for cdma
  dmaengine: doc: format struct fields using monospace
  dmaengine: doc: fix bullet list formatting
  dmaengine: ti-dma-crossbar: Fix event mapping for TPCC_EVT_MUX_60_63
  dmaengine: cppi41: Fix channel queues array size check
  dmaengine: imx-sdma: Add MODULE_FIRMWARE
  dmaengine: xilinx_dma: Fix typos
  dmaengine: xilinx_dma: Differentiate probe based on the ip type
  dmaengine: xilinx_dma: fix style issues from checkpatch
  dmaengine: xilinx_dma: Fix kernel doc warnings
  dmaengine: xilinx_dma: Fix race condition in the driver for multiple descriptor scenario
  dmaeninge: xilinx_dma: Fix bug in multiple frame stores scenario in vdma
  dmaengine: xilinx_dma: Check for channel idle state before submitting dma descriptor
  dmaengine: zynqmp_dma: Fix race condition in the probe
  ...