linux.git/drivers/clk/at91, branch v3.19

clk: at91: keep slow clk enabled to prevent system hang

2015-01-13T18:54:01+00:00

All slow clk users are not properly claiming it (get + prepare + enable)
before using it.
If all users properly claiming this clock release it, the clock is
disabled, but faulty users still depends on it, and the system hangs.

This fix prevents the slow clock from being disabled, and should solve the
hanging issue, but offending drivers should be patched to properly claim
this clock.

Signed-off-by: Boris Brezillon 
Reported-by: Bo Shen 
Cc: stable@vger.kernel.org
Signed-off-by: Michael Turquette

clk: Change clk_ops->determine_rate to return a clk_hw as the best parent

2014-12-04T00:21:37+00:00

This is in preparation for clock providers to not have to deal with struct clk.

Signed-off-by: Tomeu Vizoso 
Reviewed-by: Stephen Boyd 
Signed-off-by: Michael Turquette

clk: at91: usb: fix at91sam9x5 recalc, round and set rate

2014-11-17T18:38:40+00:00

First check for rate == 0 in set_rate and round_rate to avoid div by zero.
Then, in order to get the closest rate, round all divisions to the closest
result instead of rounding them down.

Signed-off-by: Boris Brezillon 
Acked-by: Nicolas Ferre 
Signed-off-by: Michael Turquette

clk: at91: usb: fix at91rm9200 round and set rate

2014-11-17T18:38:40+00:00

at91rm9200_clk_usb_set_rate might fail depending on the requested rate,
because the parent_rate / rate remainder is not necessarily zero.
Moreover, when rounding down the calculated rate we might alter the
divisor calculation and end up with an invalid divisor.

To solve those problems, accept a non zero remainder, and always round
division to the closest result.

Signed-off-by: Boris Brezillon 
Reported-by: Andreas Henriksson 
Tested-by: Andreas Henriksson 
Acked-by: Nicolas Ferre 
Signed-off-by: Michael Turquette

Merge tag 'clk-for-linus-3.18' of git://git.linaro.org/people/mike.turquette/linux

2014-10-15T05:05:03+00:00

Pull clock tree updates from Mike Turquette:
 "The clk tree changes for 3.18 are dominated by clock drivers.  Mostly
  fixes and enhancements to existing drivers as well as new drivers.
  This tag contains a bit more arch code than I usually take due to some
  OMAP2+ changes.  Additionally it contains the restart notifier
  handlers which are merged as a dependency into several trees.

  The PXA changes are the only messy part.  Due to having a stable tree
  I had to revert one patch and follow up with one more fix near the tip
  of this tag.  Some dead code is introduced but it will soon become
  live code after 3.18-rc1 is released as the rest of the PXA family is
  converted over to the common clock framework.

  Another trend in this tag is that multiple vendors have started to
  push the complexity of changing their CPU frequency into the clock
  driver, whereas this used to be done in CPUfreq drivers.

  Changes to the clk core include a generic gpio-clock type and a
  clk_set_phase() function added to the top-level clk.h api.  Due to
  some confusion on the fbdev mailing list the kernel boot parameters
  documentation was updated to further explain the clk_ignore_unused
  parameter, which is often required by users of the simplefb driver.

  Finally some fixes to the locking around the clock debugfs stuff was
  done to prevent deadlocks when interacting with other subsystems."

* tag 'clk-for-linus-3.18' of git://git.linaro.org/people/mike.turquette/linux: (99 commits)
  clk: pxa clocks build system fix
  Revert "arm: pxa: Transition pxa27x to clk framework"
  clk: samsung: register restart handlers for s3c2412 and s3c2443
  clk: rockchip: add restart handler
  clk: rockchip: rk3288: i2s_frac adds flag to set parent's rate
  doc/kernel-parameters.txt: clarify clk_ignore_unused
  arm: pxa: Transition pxa27x to clk framework
  dts: add devicetree bindings for pxa27x clocks
  clk: add pxa27x clock drivers
  arm: pxa: add clock pll selection bits
  clk: dts: document pxa clock binding
  clk: add pxa clocks infrastructure
  clk: gpio-gate: Ensure gpiod_ APIs are prototyped
  clk: ti: dra7-atl-clock: Mark the device as pm_runtime_irq_safe
  clk: ti: LLVMLinux: Move __init outside of type definition
  clk: ti: consider the fact that of_clk_get() might return an error
  clk: ti: dra7-atl-clock: fix a memory leak
  clk: ti: change clock init to use generic of_clk_init
  clk: hix5hd2: add I2C clocks
  clk: hix5hd2: add watchdog0 clocks
  ...

Merge tag 'drivers-for-linus' of git://git.kernel.org/pub/scm/linux/kernel/git/arm/arm-soc

2014-10-08T21:37:16+00:00

Pull ARM SoC driver updates from Arnd Bergmann:
 "These are changes for drivers that are intimately tied to some SoC and
  for some reason could not get merged through the respective subsystem
  maintainer tree.

  Most of the new code is for the Keystone Navigator driver, which is
  new base support that is going to be needed for their hardware
  accelerated network driver and other units.

  Most of the commits are for moving old code around from at91 and omap
  for things that are done in device drivers nowadays.

   - at91: move reset, poweroff, memory and clocksource code into
     drivers directories
   - socfpga: add edac driver (through arm-soc, as requested by Boris)
   - omap: move omap-intc code to drivers/irqchip
   - sunxi: added an RTC driver for sun6i
   - omap: mailbox driver related changes
   - keystone: support for the "Navigator" component
   - versatile: new reboot, led and soc drivers"

* tag 'drivers-for-linus' of git://git.kernel.org/pub/scm/linux/kernel/git/arm/arm-soc: (92 commits)
  bus: arm-ccn: Fix spurious warning message
  leds: add device tree bindings for register bit LEDs
  soc: add driver for the ARM RealView
  power: reset: driver for the Versatile syscon reboot
  leds: add a driver for syscon-based LEDs
  drivers/soc: ti: fix build break with modules
  MAINTAINERS: Add Keystone Multicore Navigator drivers entry
  soc: ti: add Keystone Navigator DMA support
  Documentation: dt: soc: add Keystone Navigator DMA bindings
  soc: ti: add Keystone Navigator QMSS driver
  Documentation: dt: soc: add Keystone Navigator QMSS bindings
  rtc: sunxi: Depend on platforms sun4i/sun7i that actually have the rtc
  rtc: sun6i: Add sun6i RTC driver
  irqchip: omap-intc: remove unnecessary comments
  irqchip: omap-intc: correct maximum number or MIR registers
  irqchip: omap-intc: enable TURBO idle mode
  irqchip: omap-intc: enable IP protection
  irqchip: omap-intc: remove unnecesary of_address_to_resource() call
  irqchip: omap-intc: comment style cleanup
  irqchip: omap-intc: minor improvement to omap_irq_pending()
  ...

Merge tag 'soc-for-linus' of git://git.kernel.org/pub/scm/linux/kernel/git/arm/arm-soc

2014-10-08T21:13:04+00:00

Pull ARM SoC platform changes from Arnd Bergmann:
 "New and updated SoC support.  Among the things new for this release
  are:

   - at91: Added support for the new SAMA5D4 SoC, following the earlier
     SAMA5D3
   - bcm: Added support for BCM63XX family of DSL SoCs
   - hisi: Added support for HiP04 server-class SoC
   - meson: Initial support for the Amlogic Meson6 (aka 8726MX) platform
   - shmobile: added support for new r8a7794 (R-Car E2) automotive SoC

  Noteworthy changes to existing SoC support are:

   - imx: convert i.MX1 to device tree
   - omap: lots of power management work
   - omap: base support to enable moving to standard UART driver
   - shmobile: lots of progress for multiplatform support, still
     ongoing"

* tag 'soc-for-linus' of git://git.kernel.org/pub/scm/linux/kernel/git/arm/arm-soc: (171 commits)
  ARM: hisi: depend on ARCH_MULTI_V7
  CNS3xxx: Fix debug UART.
  ARM: at91: fix nommu build regression
  ARM: meson: add basic support for MesonX SoCs
  ARM: meson: debug: add debug UART for earlyprintk support
  irq: Export handle_fasteoi_irq
  ARM: mediatek: Add earlyprintk support for mt6589
  ARM: hisi: Fix platmcpm compilation when ARMv6 is selected
  ARM: debug: fix alphanumerical order on debug uarts
  ARM: at91: document Atmel SMART compatibles
  ARM: at91: add sama5d4 support to sama5_defconfig
  ARM: at91: dt: add device tree file for SAMA5D4ek board
  ARM: at91: dt: add device tree file for SAMA5D4 SoC
  ARM: at91: SAMA5D4 SoC detection code and low level routines
  ARM: at91: introduce basic SAMA5D4 support
  clk: at91: add a driver for the h32mx clock
  ARM: pxa3xx: provide specific platform_devices for all ssp ports
  ARM: pxa: ssp: provide platform_device_id for PXA3xx
  ARM: OMAP4+: Remove static iotable mappings for SRAM
  ARM: OMAP4+: Move SRAM data to DT
  ...

clk: at91: add a driver for the h32mx clock

2014-09-22T09:38:59+00:00

Newer SoCs have two different AHB interconnect. The AHB 32 bits Matrix
interconnect (h32mx) has a clock that can be setup at the half of the h64mx
clock (which is mck). The h32mx clock can not exceed 90 MHz.

Signed-off-by: Alexandre Belloni 
Acked-by: Boris Brezillon 
Signed-off-by: Nicolas Ferre

Merge branch 'clk-fixes' into clk-next

2014-09-17T18:47:56+00:00

clk: at91: fix div by zero in USB clock driver

2014-09-02T22:37:26+00:00

Test rate value before calculating the div value to avoid div by zero.

Signed-off-by: Boris BREZILLON 
Reported-by: Gaël PORTAY 
Tested-by: Gaël PORTAY 
Signed-off-by: Mike Turquette