linux.git/drivers/block/drbd/drbd_actlog.c, branch v4.8

dynamic_debug: only add header when used

2016-08-02T23:35:03+00:00

kernel.h header doesn't directly use dynamic debug, instead we can
include it in module.c (which used it via kernel.h).  printk.h only uses
it if CONFIG_DYNAMIC_DEBUG is on, changing the inclusion to only happen
in that case.

Link: http://lkml.kernel.org/r/1468429793-16917-1-git-send-email-luisbg@osg.samsung.com
[luisbg@osg.samsung.com: include dynamic_debug.h in drb_int.h]
  Link: http://lkml.kernel.org/r/1468447828-18558-2-git-send-email-luisbg@osg.samsung.com
Signed-off-by: Luis de Bethencourt 
Cc: Rusty Russell 
Cc: Hidehiro Kawai 
Cc: Borislav Petkov 
Cc: Michal Nazarewicz 
Cc: Rasmus Villemoes 
Cc: Joe Perches 
Signed-off-by: Andrew Morton 
Signed-off-by: Linus Torvalds

drbd: al_write_transaction: skip re-scanning of bitmap page pointer array

2016-06-14T03:43:08+00:00

For larger devices, the array of bitmap page pointers can grow very
large (8000 pointers per TB of storage).

For each activity log transaction, we need to flush the associated
bitmap pages to stable storage. Currently, we just "mark" the respective
pages while setting up the transaction, then tell the bitmap code to
write out all marked pages, but skip unchanged pages.

But one such transaction can affect only a small number of bitmap pages,
there is no need to scan the full array of several (ten-)thousand
page pointers to find the few marked ones.

Instead, remember the index numbers of the few affected pages,
and later only re-check those to skip duplicates and unchanged ones.

Signed-off-by: Philipp Reisner 
Signed-off-by: Lars Ellenberg 
Signed-off-by: Jens Axboe

drbd: introduce WRITE_SAME support

2016-06-14T03:43:07+00:00

We will support WRITE_SAME, if
 * all peers support WRITE_SAME (both in kernel and DRBD version),
 * all peer devices support WRITE_SAME
 * logical_block_size is identical on all peers.

We may at some point introduce a fallback on the receiving side
for devices/kernels that do not support WRITE_SAME,
by open-coding a submit loop. But not yet.

Signed-off-by: Philipp Reisner 
Signed-off-by: Lars Ellenberg 
Signed-off-by: Jens Axboe

drbd: finish resync on sync source only by notification from sync target

2016-06-14T03:43:05+00:00

If the replication link breaks exactly during "resync finished" detection,
finishing too early on the sync source could again lead to UUIDs rotated
too fast, and potentially a spurious full resync on next handshake.

Always wait for explicit resync finished state change notification from
the sync target.

Signed-off-by: Philipp Reisner 
Signed-off-by: Lars Ellenberg 
Signed-off-by: Jens Axboe

drbd: allow larger max_discard_sectors

2016-06-14T03:43:05+00:00

Make sure we have at least 67 (> AL_UPDATES_PER_TRANSACTION)
al-extents available, and allow up to half of that to be
discarded in one bio.

Signed-off-by: Philipp Reisner 
Signed-off-by: Lars Ellenberg 
Signed-off-by: Jens Axboe

block, drivers, fs: rename REQ_FLUSH to REQ_PREFLUSH

2016-06-07T19:41:38+00:00

To avoid confusion between REQ_OP_FLUSH, which is handled by
request_fn drivers, and upper layers requesting the block layer
perform a flush sequence along with possibly a WRITE, this patch
renames REQ_FLUSH to REQ_PREFLUSH.

Signed-off-by: Mike Christie 
Reviewed-by: Christoph Hellwig 
Reviewed-by: Hannes Reinecke 
Signed-off-by: Jens Axboe

drbd: use bio op accessors

2016-06-07T19:41:38+00:00

Separate the op from the rq_flag_bits and have drbd
set/get the bio using bio_set_op_attrs/bio_op.

Signed-off-by: Mike Christie 
Reviewed-by: Christoph Hellwig 
Reviewed-by: Hannes Reinecke 
Signed-off-by: Jens Axboe

block/fs/drivers: remove rw argument from submit_bio

2016-06-07T19:41:38+00:00

This has callers of submit_bio/submit_bio_wait set the bio->bi_rw
instead of passing it in. This makes that use the same as
generic_make_request and how we set the other bio fields.

Signed-off-by: Mike Christie 

Fixed up fs/ext4/crypto.c

Signed-off-by: Jens Axboe

drbd: avoid potential deadlock during handshake

2015-11-25T16:22:03+00:00

During handshake communication, we also reconsider our device size,
using drbd_determine_dev_size(). Just in case we need to change the
offsets or layout of our on-disk metadata, we lock out application
and other meta data IO, and wait for the activity log to be "idle"
(no more referenced extents).

If this handshake happens just after a connection loss, with a fencing
policy of "resource-and-stonith", we have frozen IO.

If, additionally, the activity log was "starving" (too many incoming
random writes at that point in time), it won't become idle, ever,
because of the frozen IO, and this would be a lockup of the receiver
thread, and consquentially of DRBD.

Previous logic (re-)initialized with a special "empty" transaction
block, which required the activity log to fully drain first.

Instead, write out some standard activity log transactions.
Using lc_try_lock_for_transaction() instead of lc_try_lock() does not
care about pending activity log references, avoiding the potential
deadlock.

Signed-off-by: Philipp Reisner 
Signed-off-by: Lars Ellenberg 
Signed-off-by: Jens Axboe

drbd: separate out __al_write_transaction helper function

2015-11-25T16:22:03+00:00

To be able to "force out" an activity log transaction,
even if there are no pending updates.

This will be used to relocate the on-disk activity log,
if the on-disk offsets have to be changed,
without the need to empty the activity log first.

While at it, move the definition,
so we can drop the forward declaration of a static helper.

Signed-off-by: Philipp Reisner 
Signed-off-by: Lars Ellenberg 
Signed-off-by: Jens Axboe