linux.git/drivers/ata/libata-core.c, branch v4.2

Add factory recertified Crucial M500s to blacklist

2015-08-26T15:30:47+00:00

The Crucial M500 is known to have issues with queued TRIM commands, the
factory recertified SSDs use a different model number naming convention
which causes them to get ignored by the blacklist.

The new naming convention boils down to: s/Crucial_/FC/

Signed-off-by: Guillermo A. Amaral 
Signed-off-by: Tejun Heo 
Cc: stable@vger.kernel.org

Revert "libata: Implement support for sense data reporting"

2015-08-03T16:01:19+00:00

This reverts commit fe7173c206de63fc28475ee6ae42ff95c05692de.

As implemented, ACS-4 sense reporting for ATA devices bypasses error
diagnosis and handling in libata degrading EH behavior significantly.
Revert the related changes for now.

ATA_ID_COMMAND_SET_3/4 constants are not reverted as they're used by
later changes.

Signed-off-by: Tejun Heo 
Cc: Hannes Reinecke 
Cc: stable@vger.kernel.org #v4.1+

Revert "libata-eh: Set 'information' field for autosense"

2015-08-03T15:41:33+00:00

This reverts commit a1524f226a02aa6edebd90ae0752e97cfd78b159.

As implemented, ACS-4 sense reporting for ATA devices bypasses error
diagnosis and handling in libata degrading EH behavior significantly.
Revert the related changes for now.

Signed-off-by: Tejun Heo 
Cc: Hannes Reinecke 
Cc: stable@vger.kernel.org #v4.1+

libata: Do not blacklist M510DC

2015-07-16T16:15:45+00:00

A new Micron drive was just announced, once again recycling the first
part of the model string. Add an underscore to the M510/M550 pattern to
avoid picking up the new DC drive.

Signed-off-by: Martin K. Petersen 
Cc: 
Signed-off-by: Tejun Heo

libata: increase the timeout when setting transfer mode

2015-07-15T15:56:40+00:00

I have a ST4000DM000 disk. If Linux is booted while the disk is spun down,
the command that sets transfer mode causes the disk to spin up. The
spin-up takes longer than the default 5s timeout, so the command fails and
timeout is reported.

Fix this by increasing the timeout to 15s, which is enough for the disk to
spin up.

Signed-off-by: Mikulas Patocka 
Cc: stable@vger.kernel.org
Signed-off-by: Tejun Heo

libata: add ATA_HORKAGE_MAX_SEC_1024 to revert back to previous max_sectors limit

2015-07-15T15:47:24+00:00

Since no longer limiting max_sectors to BLK_DEF_MAX_SECTORS (commit 34b48db66e08),
data corruption may occur on ST380013AS drive configured on 82801JI (ICH10 Family)
SATA controller. This patch will allow the driver to limit max_sectors as before

 # cat /sys/block/sdb/queue/max_sectors_kb
 512

I was able to double the max_sectors_kb value up to 16384 on linux-4.2.0-rc2
before seeing corruption, but seems safer to use previous limit. Without this
patch max_sectors_kb will be 32767.

tj: Minor comment update.

Reported-by: Jeff Moyer 
Signed-off-by: David Milburn 
Signed-off-by: Tejun Heo 
Cc: stable@vger.kernel.org # v3.19 and later
Fixes: 34b48db66e08 ("block: remove artifical max_hw_sectors cap")

libata: force disable trim for SuperSSpeed S238

2015-07-15T15:22:35+00:00

This device loses blocks, often the partition table area, on trim.
Disable TRIM.
http://pcengines.ch/msata16a.htm

Signed-off-by: Arne Fitzenreiter 
Signed-off-by: Tejun Heo 
Cc: stable@vger.kernel.org

libata: add ATA_HORKAGE_BROKEN_FPDMA_AA quirk for HP 250GB SATA disk VB0250EAVER

2015-07-14T21:57:10+00:00

Enabling AA on HP 250GB SATA disk VB0250EAVER causes errors:

[    3.788362] ata3.00: failed to enable AA (error_mask=0x1)
[    3.789243] ata3.00: failed to enable AA (error_mask=0x1)

Add the ATA_HORKAGE_BROKEN_FPDMA_AA for this specific harddisk.

tj: Collected FPDMA_AA entries and updated comment.

Signed-off-by: Aleksei Mamlin 
Signed-off-by: Tejun Heo 
Cc: stable@vger.kernel.org

Merge branch 'for-4.2' of git://git.kernel.org/pub/scm/linux/kernel/git/tj/libata

2015-06-25T23:49:21+00:00

Pull libata updates from Tejun Heo:

 - a number of libata core changes to better support NCQ TRIM.

 - ahci now supports MSI-X in single IRQ mode to support a new
   controller which doesn't implement MSI or INTX.

 - ahci now supports edge-triggered IRQ mode to support a new controller
   which for some odd reason did edge-triggered IRQ.

 - the usual controller support additions and changes.

* 'for-4.2' of git://git.kernel.org/pub/scm/linux/kernel/git/tj/libata: (27 commits)
  libata: Do not blacklist Micron M500DC
  ata: ahci_mvebu: add suspend/resume support
  ahci, msix: Fix build error for !PCI_MSI
  ahci: Add support for Cavium's ThunderX host controller
  ahci: Add generic MSI-X support for single interrupts to SATA PCI driver
  libata: finally use __initconst in ata_parse_force_one()
  drivers: ata: add support for Ceva sata host controller
  devicetree:bindings: add devicetree bindings for ceva ahci
  ahci: added support for Freescale AHCI sata
  ahci: Store irq number in struct ahci_host_priv
  ahci: Move interrupt enablement code to a separate function
  Doc: libata: Fix spelling typo found in libata.xml
  ata:sata_nv - Change 1 to true for bool type variable.
  ata: add Broadcom AHCI SATA3 driver for STB chips
  Documentation: devicetree: add Broadcom SATA binding
  libata: Fix regression when the NCQ Send and Receive log page is absent
  ata: hpt366: fix constant cast warning
  ata: ahci_xgene: potential NULL dereference in probe
  ata: ahci_xgene: Add AHCI Support for 2nd HW version of APM X-Gene SoC AHCI SATA Host controller.
  libahci: Add support to handle HOST_IRQ_STAT as edge trigger latch.
  ...

libata: Do not blacklist Micron M500DC

2015-06-18T18:52:30+00:00

Queued TRIM got disabled on Micron M500DC drives thanks to the
"Micron_M500*" pattern we had in place to accommodate the previous
generation of this drive family. Tweak the blacklist entry slightly so
we only disable queued TRIM for the non-DC variants of M500 drives.

Signed-off-by: Martin K. Petersen 
Cc: stable@vger.kernel.org
Signed-off-by: Tejun Heo