* 'merge' of git://git.secretlab.ca/git/linux-2.6:
  powerpc/5200: fix lite5200 ethernet phy address
  powerpc/5200: Fix build error in sound code.
  powerpc/5200: fix oops during going to standby
  powerpc/5200: add lite5200 onboard I2C eeprom and flash
  maintainers: Add git trees for SPI and device tree
  of: Drop properties with "/" in their name

According to my schematics, on Lite5200 board ethernet phy uses address
0 (all ADDR lines are pulled down). With this change I can talk to
onboard phy (LXT971) and correctly use autonegotiation.

Signed-off-by: Dmitry Eremin-Solenikov <dbaryshkov@gmail.com>
Signed-off-by: Grant Likely <grant.likely@secretlab.ca>

Add dts descriptions for onboard 256 byte I2C eeprom (pcf8582C-2)
and 16MB NOR flash (am29lv652d).

Signed-off-by: Dmitry Eremin-Solenikov <dbaryshkov@gmail.com>
[grant.likely@secretlab.ca: added lite5200b eeprom and declared lite5200 gpios]
Signed-off-by: Grant Likely <grant.likely@secretlab.ca>

It was used in the dim distant past for adding initrds to images
for legacy iSeries, but it's not even used for that now that we
have initramfs.  So remove it.

Signed-off-by: Paul Mackerras <paulus@samba.org>
Signed-off-by: Benjamin Herrenschmidt <benh@kernel.crashing.org>

Conflicts:
	arch/powerpc/sysdev/fsl_msi.c

P1021 is a dual e500v2 core based SOC with:
* 3 eTSECs (eTSEC1/3 RGMII, eTSEC2 SGMII on this board)
* 2 PCIe Controller
* 1 USB2.0 controller
* eSDHC, eSPI, I2C, DUART
* eLBC (NAND, BCSR, PMC0/1)
* Security Engine (SEC 3.3.2)
* Quicc Engine (QE)

Signed-off-by: Haiying Wang <Haiying.Wang@freescale.com>
Signed-off-by: Yu Liu <Yu.Liu@freescale.com>
Signed-off-by: Kumar Gala <galak@kernel.crashing.org>

Enable the sharing of MSI interrupt through AMP OSes in the mpc8572ds
dtses.

Signed-off-by: Zhao Chenhui <b26998@freescale.com>
Signed-off-by: Li Yang <leoli@freescale.com>
Signed-off-by: Kumar Gala <galak@kernel.crashing.org>

I believe support was disabled due to issues with earlier versions of
the board/processor.  At worst, adding the ports back into the device
tree should result in enabling ports that don't work on older systems,
so the default should be to enable them.

Signed-off-by: Andy Fleming <afleming@freescale.com>
Signed-off-by: Kumar Gala <galak@kernel.crashing.org>

There are two front-panel LEDs on MPC837xRDB and MPC8315RDB boards: PWR
and HDD. After adding appropriate nodes we can program these LEDs from
kernel and user space.

Signed-off-by: Anton Vorontsov <avorontsov@mvista.com>
Signed-off-by: Kumar Gala <galak@kernel.crashing.org>