linux.git/arch/mips/kernel/setup.c, branch v5.6-rc2

Merge tag 'mips_5.6' of git://git.kernel.org/pub/scm/linux/kernel/git/mips/linux

2020-01-31T19:28:31+00:00

Pull MIPS changes from Paul Burton:
 "Nothing too big or scary in here:

   - Support mremap() for the VDSO, primarily to allow CRIU to restore
     the VDSO to its checkpointed location.

   - Restore the MIPS32 cBPF JIT, after having reverted the enablement
     of the eBPF JIT for MIPS32 systems in the 5.5 cycle.

   - Improve cop0 counter synchronization behaviour whilst onlining CPUs
     by running with interrupts disabled.

   - Better match FPU behaviour when emulating multiply-accumulate
     instructions on pre-r6 systems that implement IEEE754-2008 style
     MACs.

   - Loongson64 kernels now build using the MIPS64r2 ISA, allowing them
     to take advantage of instructions introduced by r2.

   - Support for the Ingenic X1000 SoC & the really nice little CU Neo
     development board that's using it.

   - Support for WMAC on GARDENA Smart Gateway devices.

   - Lots of cleanup & refactoring of SGI IP27 (Origin 2*) support in
     preparation for introducing IP35 (Origin 3*) support.

   - Various Kconfig & Makefile cleanups"

* tag 'mips_5.6' of git://git.kernel.org/pub/scm/linux/kernel/git/mips/linux: (60 commits)
  MIPS: PCI: Add detection of IOC3 on IO7, IO8, IO9 and Fuel
  MIPS: Loongson64: Disable exec hazard
  MIPS: Loongson64: Bump ISA level to MIPSR2
  MIPS: Make DIEI support as a config option
  MIPS: OCTEON: octeon-irq: fix spelling mistake "to" -> "too"
  MIPS: asm: local: add barriers for Loongson
  MIPS: Loongson64: Select mac2008 only feature
  MIPS: Add MAC2008 Support
  Revert "MIPS: Add custom serial.h with BASE_BAUD override for generic kernel"
  MIPS: sort MIPS and MIPS_GENERIC Kconfig selects alphabetically (again)
  MIPS: make CPU_HAS_LOAD_STORE_LR opt-out
  MIPS: generic: don't unconditionally select PINCTRL
  MIPS: don't explicitly select LIBFDT in Kconfig
  MIPS: sync-r4k: do slave counter synchronization with disabled HW interrupts
  MIPS: SGI-IP30: Check for valid pointer before using it
  MIPS: syscalls: fix indentation of the 'SYSNR' message
  MIPS: boot: fix typo in 'vmlinux.lzma.its' target
  MIPS: fix indentation of the 'RELOCS' message
  dt-bindings: Document loongson vendor-prefix
  MIPS: CU1000-Neo: Refresh defconfig to support HWMON and WiFi.
  ...

arch/mips/setup: Drop dummy_con initialization

2020-01-14T14:29:16+00:00

con_init in tty/vt.c will now set conswitchp to dummy_con if it's unset.
Drop it from arch setup code.

Signed-off-by: Arvind Sankar 
Link: https://lore.kernel.org/r/20191218214506.49252-13-nivedita@alum.mit.edu
Signed-off-by: Greg Kroah-Hartman

MIPS: use resource_size

2020-01-10T19:31:16+00:00

Use resource_size rather than a verbose computation on
the end and start fields.

The semantic patch that makes these changes is as follows:
(http://coccinelle.lip6.fr/)


@@ struct resource ptr; @@
- (ptr.end - ptr.start + 1)
+ resource_size(&ptr)


Signed-off-by: Julia Lawall 
Reviewed-by: Philippe Mathieu-Daudé 
Signed-off-by: Paul Burton 
Cc: Ralf Baechle 
Cc: kernel-janitors@vger.kernel.org
Cc: James Hogan 
Cc: linux-mips@vger.kernel.org
Cc: linux-kernel@vger.kernel.org

MIPS: Loongson64: Rename CPU TYPES

2019-10-31T22:03:10+00:00

CPU_LOONGSON2 -> CPU_LOONGSON2EF
CPU_LOONGSON3 -> CPU_LOONGSON64

As newer loongson-2 products (2G/2H/2K1000) can share kernel
implementation with loongson-3 while 2E/2F are less similar with
other LOONGSON64 products.

Signed-off-by: Jiaxun Yang 
Signed-off-by: Paul Burton 
Cc: linux-mips@vger.kernel.org
Cc: chenhc@lemote.com
Cc: paul.burton@mips.com

MIPS: Make builtin_cmdline const & variable length

2019-10-12T20:44:24+00:00

We have no need for the builtin_cmdline array to be fixed at the length
of COMMAND_LINE_SIZE - we'll only copy out the string it contains up to
its NULL terminator anyway, and cap the size at COMMAND_LINE_SIZE when
copying into or concatenating with boot_command_line.

The string value is also constant, so we can declare it as such to place
it in the .init.rodata section.

Signed-off-by: Paul Burton 
Cc: linux-mips@vger.kernel.org

MIPS: Fix CONFIG_OF_EARLY_FLATTREE=n builds

2019-10-12T20:44:23+00:00

Configurations with CONFIG_OF_EARLY_FLATTREE=n fail to build since
commit 7784cac69735 ("MIPS: cmdline: Clean up boot_command_line
initialization") because of_scan_flat_dt() & of_scan_flat_dt() are not
defined in these configurations. Fix this by #ifdef'ing the affected
code...

Signed-off-by: Paul Burton 
Fixes: 7784cac69735 ("MIPS: cmdline: Clean up boot_command_line initialization")
Reported-by: kbuild test robot 
Cc: linux-mips@vger.kernel.org

MIPS: Always define builtin_cmdline

2019-10-12T20:44:22+00:00

Commit 7784cac69735 ("MIPS: cmdline: Clean up boot_command_line
initialization") made use of builtin_cmdline conditional upon plain C if
statements rather than preprocessor #ifdef's. This caused build failures
for configurations with CONFIG_CMDLINE_BOOL=n where builtin_cmdline
wasn't defined, for example:

   arch/mips/kernel/setup.c: In function 'bootcmdline_init':
>> arch/mips/kernel/setup.c:582:30: error: 'builtin_cmdline' undeclared
    (first use in this function); did you mean 'builtin_driver'?
      strlcpy(boot_command_line, builtin_cmdline, COMMAND_LINE_SIZE);
                                 ^~~~~~~~~~~~~~~
                                 builtin_driver
   arch/mips/kernel/setup.c:582:30: note: each undeclared identifier is
    reported only once for each function it appears in

Fix this by defining builtin_cmdline as an empty string in the affected
configurations. All of the paths that use it should be optimized out
anyway so the data itself gets optimized away too.

Signed-off-by: Paul Burton 
Fixes: 7784cac69735 ("MIPS: cmdline: Clean up boot_command_line initialization")
Reported-by: kbuild test robot 
Reported-by: Nathan Chancellor 
Cc: linux-mips@vger.kernel.org

MIPS: cmdline: Clean up boot_command_line initialization

2019-10-10T18:56:43+00:00

Our current code to initialize boot_command_line is a mess. Some of this
is due to the addition of too many options over the years, and some of
this is due to workarounds for early_init_dt_scan_chosen() performing
actions specific to options from other architectures that probably
shouldn't be in generic code.

Clean this up by introducing a new bootcmdline_init() function that
simplifies the initialization somewhat. The major changes are:

- Because bootcmdline_init() is a function it can return early in the
  CONFIG_CMDLINE_OVERRIDE case.

- We clear boot_command_line rather than inheriting whatever
  early_init_dt_scan_chosen() may have left us. This means we no longer
  need to set boot_command_line to a space character in an attempt to
  prevent early_init_dt_scan_chosen() from copying CONFIG_CMDLINE into
  boot_command_line without us knowing about it.

- Indirection via USE_PROM_CMDLINE, USE_DTB_CMDLINE, EXTEND_WITH_PROM &
  BUILTIN_EXTEND_WITH_PROM macros is removed; they seemingly served only
  to obfuscate the code.

- The logic is cleaner, clearer & commented.

Two minor drawbacks of this approach are:

1) We call of_scan_flat_dt(), which means we scan through the DT again.
   The overhead is fairly minimal & shouldn't be noticeable.

2) cmdline_scan_chosen() duplicates a small amount of the logic from
   early_init_dt_scan_chosen(). Alternatives might be to allow the
   generic FDT code to keep & expose a copy of the arguments taken from
   the /chosen node's bootargs property, or to introduce a function like
   early_init_dt_scan_chosen() that retrieves them without modification
   to handle CONFIG_CMDLINE. Neither of these sounds particularly
   cleaner though, and this way we at least keep the extra work in
   arch/mips.

Signed-off-by: Paul Burton 
Cc: linux-mips@vger.kernel.org

MIPS: init: Prevent adding memory before PHYS_OFFSET

2019-10-02T21:11:30+00:00

On some SGI machines (IP28 and IP30) a small region of memory is mirrored
to pyhsical address 0 for exception vectors while rest of the memory
is reachable at a higher physical address. ARC PROM marks this
region as reserved, but with commit a94e4f24ec83 ("MIPS: init: Drop
boot_mem_map") this chunk is used, when searching for start of ram,
which breaks at least IP28 and IP30 machines. To fix this
add_region_memory() checks for start address < PHYS_OFFSET and ignores
these chunks.

Fixes: a94e4f24ec83 ("MIPS: init: Drop boot_mem_map")
Signed-off-by: Thomas Bogendoerfer 
Signed-off-by: Paul Burton 
Cc: Ralf Baechle 
Cc: James Hogan 
Cc: linux-mips@vger.kernel.org
Cc: linux-kernel@vger.kernel.org

MIPS: init: Fix reservation of memory between PHYS_OFFSET and mem start

2019-10-02T21:10:16+00:00

Fix calculation of the size for reserving memory between PHYS_OFFSET
and real memory start.

Fixes: a94e4f24ec83 ("MIPS: init: Drop boot_mem_map")
Signed-off-by: Thomas Bogendoerfer 
Signed-off-by: Paul Burton 
Cc: Ralf Baechle 
Cc: James Hogan 
Cc: linux-mips@vger.kernel.org
Cc: linux-kernel@vger.kernel.org